Search

Search: Search took 1.00 seconds.

  1. Replies
    24
    Views
    1,356

    Ended up buying a new 2020 cruiser fx svho! ...

    Ended up buying a new 2020 cruiser fx svho! Anyone know if I should go with a 2 place spring yachtclub aluminum trailer for 1900 or buy a triton torsion elite for 2399? Will the torsion ride that...
  2. Replies
    24
    Views
    1,356

    I’ve got a 2019 FX with 160+ hours and a stage 3...

    I’ve got a 2019 FX with 160+ hours and a stage 3 kit with 20lb ET wheel. Top speed so far is 89.1 at 9350. Still on factory clutch and only issue I’ve had was needing a battery a couple of months...
  3. Replies
    24
    Views
    1,356

    Known issues I have seen. Ride plate as has...

    Known issues I have seen.

    Ride plate as has been discussed.
    Wetter ride than older model.
    Burping when fueling.
    Inaccuracy of fuel gauge and buzzer going off for low fuel with up to half tank...
  4. Replies
    190
    Views
    23,876

    4-Stroke Motor has been primed and dropped in the ski. ...

    Motor has been primed and dropped in the ski. Just need to button everything up and get it ready to be fired up.

    Robert
  5. Remove the oil pump. ...

    Remove the oil pump.

    http://greenhulk.net/forums/attachment.php?attachmentid=459031&stc=1

    There are 12 M6 bolts (item 22) of 20mm length holding the oil pump to the front of the engine, with...
  6. Thread: Manual I.A.C.

    by mwhc
    Replies
    19
    Views
    1,018

    If you had a maptuner jesus can up the idle for...

    If you had a maptuner jesus can up the idle for you in the tune fyi
  7. Replies
    13
    Views
    867

    Well... You are about right.... But but it's...

    Well... You are about right....

    But but it's not necessary to run a 3 bar map sensor even if your boost goes over 20Psi. There is different ways to adjust the fuel, and yes , boost is related...
  8. Replies
    73
    Views
    6,097

    Brian Baldwin told me the same thing.... He...

    Brian Baldwin told me the same thing....
    He recommends to not use the ARP cylinder head studs.
    Just sayin!
Results 1 to 8 of 10