Search

Type: Posts; User: dutchrxt

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. FS - Parts 260 injectors, Daspasc with O2 sensor, 2010-2011 87mm nozzle

    Parts:

    260 injectors, 3 pieces, low hours
    Dashpac with O2 sensor, very low hours (3 or so)
    2010-2011 87mm nozzle (from RXT rideplate pump)
    Located in europe / Netherlands
  2. FS - Parts Dashpac with O2 sensor, 260HP injectors (3pcs)

    Dashpac with O2 sensor, barely used, for 2011 and up Bosch ECU
    260HP injectors (3pcs), about 50 hours used

    Located in europe (Netherlands)
  3. FS - Parts DashPac for 2011 & Newer Display AFR and Boost on Factory Gauge 2011

    DashPac for 2011 & Newer Display AFR and Boost on Factory Gauge 2011
    Only used 4 hours
    Comes with Bosch O2 sensor.
    Located in Europe (The Netherlands)
  4. Replies
    0
    Views
    253

    FS - Parts Seadoo injectors (260HP) 420874834 (3x)

    Seadoo injectors (260HP) 420874834 (3x)
    Used about 60 hours, good condition
    Located The Netherlands Europe
  5. Replies
    11
    Views
    799

    Remove the valve cover, timing chain still in...

    Remove the valve cover, timing chain still in place?
    Next step is remove the superchager, try to look if the flywheel is still in place.
    If possible try to look with an endoscopic inspection camera...
  6. It it is an 2009 RXTX (the model with 255HP motor...

    It it is an 2009 RXTX (the model with 255HP motor and metallic grey upper hull, and not equipped with iBr), it should never had the driveshaft with screw.
    Only 2009 RXT / GTX iS models and the 2010...
  7. Replies
    4
    Views
    584

    Does anyone has a setup with Dashpac and the Ski...

    Does anyone has a setup with Dashpac and the Ski module (with or without cruise button) installed?
    In Ski mode or Cruise mode my speed can not exeed 6 mph (even if I setup target speed higher value)...
  8. Lucky cone 13 or supertech springs? 2010 RXT-X 260, 77/78mph at 8350

    Here is the case:

    2010 RXT-X 260. VT11, IMUK, Canaflex, R&D intake, vtech 8350 tune.
    Currently running 77/78mph (dash) at 8350

    Should I take a Lucky cone 13? (I have mounted 83mm venturi, 87mm...
  9. Replies
    10
    Views
    1,997

    That will save some money! :) Is there any...

    That will save some money! :)
    Is there any other advantage of doing only retainers for 8350 or 8600 tune?
  10. Replies
    10
    Views
    1,997

    Flywheels bolts? Yes! Broke them with 8350 tune...

    Flywheels bolts? Yes!
    Broke them with 8350 tune on my '10 rxt-x
    A friend of mine broke them also, with normal limiter (but he did more wave jumping)
    I don't understand why there is NO warning when...
  11. Replies
    0
    Views
    355

    PTO diameter outside 260 engine

    Hi,

    Can anyone measure the outside diameter of the PTO were the rubber seal fits?

    Thanks!
  12. Keep the rubber part from the pto seal, only the...

    Keep the rubber part from the pto seal, only the bearing is different! When the rubber part gets broken you have a spare one. Just place the baring and use a new oetiker clamp. Saved some bucks for a...
  13. Replies
    0
    Views
    228

    WTB WTB - Solas SRZ-CD-15/19R

    WTB - Solas SRZ-CD-15/19R

    Thanks! :)
  14. Replies
    6
    Views
    838

    My ski is a 2010 RXT-X 260. The model with the...

    My ski is a 2010 RXT-X 260. The model with the pump mounted to the ride plate.
  15. Replies
    6
    Views
    838

    Alignment doing without the tools

    What do you think about alignment without the original tools on this way:

    Pump, bellow, carbon ring and PTO seal are removed.

    Drive shaft into engine (watch for the bumper!), then check what...
  16. Dashpac in combination with ski module, anyone having this setup?

    Dashpac in combination with ski module, anyone having this setup?

    I am having troubles using cruise control and/or ski function.
    Speed is not exceeding 6mph, even when the speed is set to higher....
  17. Replies
    24
    Views
    3,969

    ALWAYS upgrade your flywheel bolts said I...

    ALWAYS upgrade your flywheel bolts

    said I always? please yes do it!
  18. I will show why in the picture included.... ...

    I will show why in the picture included....

    Found some debris in the bearing at supercharger impeller side......
    It is some copper from the stator.

    This happened atfer my flywheel bolts failed...
  19. Oil pressure regulator update '11+ double springs, first start after rebuild question

    Seadoo changed in 2011 the oil pressure regulator to a double spring style setup.
    In the service manual Seadoo says it has more stable oil pressure. Is there anyone who had problems with the 2010...
  20. 2015 rxp 2016 missing one cylinder when cold

    2015 rxp 260 is missing one cylinder when cold
    No sound of backfire so maybe a clogged injector?
    When engine gets warmer it runs fine. Plugs are new.

    Anyone has a suggestion or same experience?...
  21. Advice needed, rebuild after flywheel bolts failure, 260hp

    Yes, it happened to me... flywheel bolts failure

    Have to split the lower case also looking for dirt.
    Oil pumps are minimal damaged.

    Need advice about:

    change all the bearings after opening...
  22. Replies
    10
    Views
    2,493

    Hi Tim! I also have a 2010 RXT-X. If you are...

    Hi Tim!

    I also have a 2010 RXT-X. If you are satisfied, please keep it! The only big problem for a 2010 RXT-X (and also the 2009 IS (yellow) model is the driveshaft. It will fail at some time,...
  23. Replies
    30
    Views
    4,504

    I have a 2010 RXT-X 260 with V-Tech 8350 tune,...

    I have a 2010 RXT-X 260 with V-Tech 8350 tune, VT1100 injectors and it loves fuel at high speed. Amount of HP is related to the fuel consumption.....
  24. Replies
    9
    Views
    2,468

    Please read this:...

    Please read this: http://www.greenhulk.net/forums/showthread.php?t=248238

    The 2010 version 295 100 383 is still available if you look at the parts catalog under section Genuine Parts_Accessories...
  25. 1. Check the intercooler 2. Check the drive...

    1. Check the intercooler
    2. Check the drive shaft, 2009 and 2010 have a terrible design and often have the splines broke down. Check if the shaft has rubber coating and a big nut inside on it. If it...
Results 1 to 25 of 55
Page 1 of 3 1 2 3