Search

Type: Posts; User: Peteysparks

Search: Search took 0.00 seconds.

  1. I tried the holes in the brass inserts. Ended up...

    I tried the holes in the brass inserts. Ended up using a heat gun. Then I just replaced everything with a later model bracket. http://greenhulk.net/forums/attachment.php?attachmentid=459849&stc=1
  2. I’ve started rebuilding the carbs with the I...

    I’ve started rebuilding the carbs with the I series Mikuni kits. The spring that comes with the kit is listed as the 115gm. Looks to be the same size as what was previously in the carbs. I have...
  3. View Post

    So if the D-Plate requires the additional 1/4 screw out adjustment does that mean the center carb should only be 1 turn out? The factory position is 3/4 out. Must be because of the accelerator pumps?
  4. Got it out and yes the o ring is in bad shape....

    Got it out and yes the o ring is in bad shape. Explains why it was frozen in place. This confirms my mechanic didn’t replace it and I’m certain this is why I’m experiencing a bog from 0-25 throttle....
  5. I bet the last rebuilder didn’t bother replacing...

    I bet the last rebuilder didn’t bother replacing it.
  6. Yes clip is off. Thanks for the tip.

    Yes clip is off. Thanks for the tip.
  7. It won’t come out and now that it’s marked up...

    It won’t come out and now that it’s marked up from the needle nose it looks like I’ll be replacing. Any ideas to get it out?
  8. I’m assuming the bottom of the seat? Does it come...

    I’m assuming the bottom of the seat? Does it come out with a needle nose? With a little twist pull?
  9. How do I know what needle size I have?

    How do I know what needle size I have?
  10. Thank You. I’ve been searching for days. Just...

    Thank You. I’ve been searching for days. Just want to keep everything stock. The motor is new. It actually runs really well except for a bog down when accelerating. Checking the mixture screws while...
  11. 2000 XL 1200 Limited Carb High Low Mixture settings

    I have the carbs off to do the drilled return modification. Id like to check the factory settings for the high/low mixture screws. Does anyone know what they are or have a sweet spot to shoot for?...
  12. thanks Dave! I do have the non ethanol available...

    thanks Dave! I do have the non ethanol available near me. I plan on using it
  13. would definitely be interested is doing this...

    would definitely be interested is doing this since my ski is stored but easily accessible in a heated garage. Do I need the 95 jet for my carbs? Where can I get one? I did see the sticky on this. Is...
  14. 2000 XL 1200 LTD How to keep this 20yr old ski running well.

    Im new to wave runners and picked up a 20 year old ski in beautiful condition. It only has 97 hours. I just installed a new rebuilt motor and had the carbs rebuilt. Only had a short time out on it...
  15. Retrofit for pump shoe through hull inserts. 2000 XL1200 LTD.

    Wanted to seal my pump shoe and it turned into a project. Not too bad since its stored for the winter and it just took a few hours at a time on weekends. Thought this might help someone.
    I had to...
  16. Sticky: Can anyone confirm these will work on a 2000...

    Can anyone confirm these will work on a 2000 XL1200 LTD? Im in the process of removing the inserts for the intake grate plate bolts. This bracket appears to be a good fix. My WR is in another...
Results 1 to 16 of 16