Search

Type: Posts; User: mittens

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    12
    Views
    187

    I disagree even pointing it to the side, from...

    I disagree even pointing it to the side, from this location its way behide you as a rider and the body so turning around to see it happens either way. unless you drill a whole new hole somewhere...
  2. A lot of FZ & Gp been doing 90 with retainers.....

    A lot of FZ & Gp been doing 90 with retainers.. all in the rpm's. With stock wheel.
  3. Replies
    12
    Views
    187

    Yea you can turn it to left or right and clear...

    Yea you can turn it to left or right and clear ski. I have played with it, but either way you turn your head back to see it as its behind you, so why not strait. Can see it easy with a check back.....
  4. Replies
    22
    Views
    10,221

    I have been wanting to mount one of these. same...

    I have been wanting to mount one of these. same gauge size as my boost/AFR gauge, and waterproof. and reads at higher speeds, and inside hull mount. we ride shallow creeks and explore so would be...
  5. Replies
    12
    Views
    187

    I personally hate the factory bilge set ups with...

    I personally hate the factory bilge set ups with underwater holes & one way valves. You don't know when it's pumping water.

    I have done this to both my FZ, 3/4 inch 45 degree pissier. Hooked...
  6. Thread: BOV discussion

    by mittens
    Replies
    9
    Views
    212

    The HKS does sound off loudly. high pitch and you...

    The HKS does sound off loudly. high pitch and you can hear it when seats on and just passing buy someone.


    The tial is more of a blast of whoosh, and harder to hear out side.

    The tials...
  7. Thread: BOV discussion

    by mittens
    Replies
    9
    Views
    212

    The Tial flows more air, so its going to be more...

    The Tial flows more air, so its going to be more effective for a BOV. Spring wise its not complicated, you either want a super charger spring (green), or yellow for a turbo.

    a HKS will work...
  8. Replies
    6
    Views
    456

    Yep yep. Plan to tomorrow after a Walmart Mario...

    Yep yep. Plan to tomorrow after a Walmart Mario to the school section. Ha
  9. Replies
    6
    Views
    456

    http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=480797&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=480798&stc=1
  10. Replies
    116
    Views
    11,572

    Cool I debated it too.

    Cool I debated it too.
  11. Replies
    6
    Views
    456

    I have double checked and he said he did not...

    I have double checked and he said he did not resize them.
  12. Replies
    6
    Views
    456

    Props and prop gauges

    my ski has a 13/20 that was tweaked by dean for some more RPM. how much I don't know yet.

    I recently had a friend kind enough to print prop gauges on some clear projector paper. I have yet to...
  13. Replies
    0
    Views
    117

    Pump Bearing questions

    So I have had the pump out on all my skis, and removed the cone to hold for clutch before I had the tool.

    But I have never redone a pump bearing. I have re done a mid bearing so no issue there.
    ...
  14. Replies
    116
    Views
    11,572

    that in the mirror?

    that in the mirror?
  15. Replies
    36
    Views
    4,972

    I have 2 "circuits" if you will Manifold is...

    I have 2 "circuits" if you will

    Manifold is tapped, and 1/4 vaccum line runs to the Tial 50/fizzle, and a T's off feeding the BOV and then another 2-3 foot runs over to my boost gauge sensor....
  16. Replies
    36
    Views
    4,972

    Most wastegates do not want to see vacuum, only...

    Most wastegates do not want to see vacuum, only boost. This is why most turbos have a boost reference nipple on the compressor housing. Vacuum can even damage certain wastegates. Just FYI. Also...
  17. I assure you my hull is clean as well. & I want...

    I assure you my hull is clean as well. & I want to keep it that way. But just the job of removing / swapping will be as dirty as it leaking.

    water routing is all personal choice can split the feed...
  18. I have a 2016 as well, with the stack disk style,...

    I have a 2016 as well, with the stack disk style, so far no leaks. If and when it leaks I will worry about changing it. I have read only the first years of this leak later years where ok?
  19. Replies
    10
    Views
    498

    Good luck for sure. Keep us/ me posted.

    Good luck for sure. Keep us/ me posted.
  20. Replies
    10
    Views
    498

    Good to see you getting it working! once dialed...

    Good to see you getting it working! once dialed more in tune wise your going to love it. Looks good for sure. How did it feel just trying to data log it? sounds and feel differ right? and so...
  21. Thread: Turbo FZ Build

    by mittens
    Replies
    78
    Views
    6,166

    4-Stroke Ordered a box stock new 13/20. Will pull my...

    Ordered a box stock new 13/20. Will pull my current 13/20 and see what its tweaked too, all I know is Dean tweaked it years back for the Intake, ribbon delete, riva shaft, retainers, grate, and ride...
  22. Thread: Turbo FZ Build

    by mittens
    Replies
    78
    Views
    6,166

    4-Stroke Little update on my ski. Pulled hot side apart. ...

    Little update on my ski. Pulled hot side apart. Pressure tested up pipe again just to make sure all season of use did not crack anything and all was good. Dropped up pipe and down pipe back off at...
  23. Replies
    45
    Views
    4,535

    In my Trailaerable 34 foot Baja I Used the...

    In my Trailaerable 34 foot Baja I Used the cheapest vodka I could find. 2 handles and pumped the tank dry... Then I knew nothing left was freeze. one tank of water and no vodka smell. but the...
  24. Replies
    45
    Views
    4,535

    again, we are arguing over not doing something...

    again, we are arguing over not doing something that takes 5 min and is free. blow water out of your ski or don't. its not a bad idea... sure may not be needed. but it aslo does not hurt.....
  25. Replies
    7
    Views
    631

    I did 90 with stock wheel. Surprised not seeing...

    I did 90 with stock wheel. Surprised not seeing more then 87 with a bigger wheel.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4