Search

Search: Search took 1.00 seconds.

  1. Replies
    4
    Views
    171

    There are multiple issues. Check your water...

    There are multiple issues. Check your water hoses, the 2 that come from your cylinder head and go into the waterbox. 1 is under the intake manifold, the other is under the exhaust manifold.
    Check...
  2. Replies
    238
    Views
    23,200

    What were you expecting? The RXT just went...

    What were you expecting? The RXT just went through a major redesign couple years ago. The models take turns refreshing, this was the RXP year.
  3. Replies
    19
    Views
    881

    They are all good skis but if you wanna keep...

    They are all good skis but if you wanna keep maintenance cost down keep to an NA ski.
    I have an Kawasaki ultra lx. Itís awesome 60gallons of storage. 21gallon fuel tuel tank. Handles great. Super...
  4. Replies
    19
    Views
    881

    If you plan to ride up to 3 hours at a time, I...

    If you plan to ride up to 3 hours at a time, I think that would rule out most supercharged 'Skis. The new STX-160 has a large fuel tank and good performance.

    With two dealers in the area, the...
  5. Replies
    6
    Views
    452

    Have you checked the strainer on top of the jet...

    Have you checked the strainer on top of the jet pump?
  6. If you're trying to beat a stock 300 up top than...

    If you're trying to beat a stock 300 up top than it's pretty easy. A tune with ET137+4 charger, and supporting mods, will easily outrun a stock or scom rxp 300. If everything is good than you should...
  7. Replies
    54
    Views
    6,918

    View Post

    Yes you are correct. In reality it doesnít matter what you ride they are all fun and as long as you are out on the water who cares what machine it is.
  8. Thread: 2021 Rumors?

    by Chris288
    Replies
    54
    Views
    6,918

    VX vs. Ultra ,,,, seriously,,,,, the VX vs....

    VX vs. Ultra ,,,, seriously,,,,, the VX vs. stx160 is more appropriate comparison. ive ridden both and the stx is much better in the rough than the vx..
  9. Replies
    10
    Views
    464

    There was no recall.. Just a superseded parts...

    There was no recall..

    Just a superseded parts change on the later models...

    Just rebuild it to 2010 specs with a stock prop , depending on housing condition, might be easier to send it to...
  10. Thread: 2021 Rumors?

    by steve45
    Replies
    54
    Views
    6,918

    Took my Ultra 150 out yesterday and one of the...

    Took my Ultra 150 out yesterday and one of the mirrors fell off in the lake. This is a known problem for older Kawis.

    I'd like to see Kawasaki come up with mirrors that don't just fall off, and...
  11. Thread: 2020 310r

    by bill321
    Replies
    4
    Views
    518

    To be fair race show her how to put the PX in...

    To be fair race show her how to put the PX in sport mode and use the launch control.......;) ;)
  12. Replies
    15
    Views
    758

    The good news is that the leak is so bad it...

    The good news is that the leak is so bad it should be easy to find.
  13. Replies
    4
    Views
    490

    FS View Post

    Arenít these things vin locked?
  14. Replies
    56
    Views
    8,192

    IMO the most likely cause is shutting the motor...

    IMO the most likely cause is shutting the motor off after a hard hot run without allowing it to cool off by letting it idle around for a few minutes, or restarting a hot motor and blasting it with...
  15. Replies
    9
    Views
    1,211

    You can run an external IC without an AFR gauge...

    You can run an external IC without an AFR gauge or RRFPR. Its a proven setup.
  16. Replies
    9
    Views
    1,211

    It is a direct fit replacement and you will...

    It is a direct fit replacement and you will definitely need the 42# injectors or else you will run lean. An external IC is recomended for best performance but not required with this setup.
  17. Replies
    10
    Views
    970

    You dont wont to go stainless if you run in...

    You dont wont to go stainless if you run in shallow sandy water, it will eat your prop up. Buy OEM and forget about it. Pay now or pay later.
  18. Replies
    10
    Views
    1,092

    I use a small ball pein hammer. Once you've...

    I use a small ball pein hammer. Once you've lapped, cleaned, oiled, put on springs and locks.......pop it a couple times so the valve open and closes under the spring pressure. This is how I've done...
  19. Thread: Sunk

    by nitrousballa45
    Replies
    5
    Views
    652

    Oh and invest in two of the baddest bilge pumps...

    Oh and invest in two of the baddest bilge pumps so that if you are out a good ways those pumps will save your ass.I plan on doing something like this on my turbo'd gpr to much mon ey to be swimming...
  20. Replies
    11
    Views
    991

    I put triple guard grease.

    I put triple guard grease.
Results 1 to 20 of 20