Search

Type: Posts; User: ncdoo

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    20
    Views
    590

    Just heard that Atlantic Beach and Emerald Isle...

    Just heard that Atlantic Beach and Emerald Isle have closed their boat ramps, in hopes that it will slow the influx of ding batters coming down from Raleigh.
  2. Replies
    12
    Views
    260

    Its not a SC bearing failure, you would have seen...

    Its not a SC bearing failure, you would have seen damage to the impeller.
  3. All models have a solenoid. And he's already...

    All models have a solenoid. And he's already replaced it.
  4. Replies
    20
    Views
    590

    According to the NCWRC website, most ramps in NC...

    According to the NCWRC website, most ramps in NC should be open. I went out last weekend, and I think everyone else did too.
  5. Sometimes the L13 just doesn't live up to its...

    Sometimes the L13 just doesn't live up to its name.
  6. Replies
    5
    Views
    195

    WTB I have one to go with the two GTRD has.

    I have one to go with the two GTRD has.
  7. Next to the sensor on the steering column. ...

    Next to the sensor on the steering column.


    http://greenhulk.net/forums/showthread.php?t=131770&page=2
    see Post#15
  8. Replies
    13
    Views
    419

    FS Yes they're definitely no RIVA's as were...

    Yes they're definitely no RIVA's as were advertised.
  9. Replies
    13
    Views
    419

    FS Did he send a photo before you bought them? Never...

    Did he send a photo before you bought them? Never mind just saw them on the classified section. They looked a little beat up there, bit he only showed the tops
  10. I'm running 80+ and haven't had any IC problems...

    I'm running 80+ and haven't had any IC problems running it this way. I'm not running open loop either.
  11. Replies
    4
    Views
    846

    greenhulk.net/forums/showthread.php?t=278688

    greenhulk.net/forums/showthread.php?t=278688
  12. Thats not how I ran mine. I ran the supply line...

    Thats not how I ran mine. I ran the supply line to the Groco then to the inlet of the IC. The oulet runs to the exhaust. I run the stock restrictor/pump washer. I ran a dedicated dump for the bleed....
  13. Did you check to see if the magnets were in...

    Did you check to see if the magnets were in place? If the sensor doesnt solve the problem continue troubleshooting per the manual.
  14. Replies
    7
    Views
    200

    The four beeps after the one long beep simply...

    The four beeps after the one long beep simply means you left the key on the post.
    http://greenhulk.net/forums/attachment.php?attachmentid=459608&stc=1
  15. Replies
    7
    Views
    200

    The key might have gone bad, they do fail. Have...

    The key might have gone bad, they do fail. Have you tried taking it off the post and reinstalling it several times? I have a ski that does that but when I reinstall the key a couple times, I get the...
  16. If the sensor is bad, I wouldn't expect anything...

    If the sensor is bad, I wouldn't expect anything to change.
  17. http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=459607&stc=1
  18. Do a web search for that fault code, it could be...

    Do a web search for that fault code, it could be a bad sensor. http://greenhulk.net/forums/showthread.php?t=131770&page=2&highlight=p1550
  19. I don't think your ski has OPAS, it has OTAS, Off...

    I don't think your ski has OPAS, it has OTAS, Off Throttle Assisted Steering. You need to check the fault codes by pressing the Mode button until you see Fault Code is displayed, then press the Set...
  20. Replies
    7
    Views
    200

    Wrong key or it needs to be reprogramed.

    Wrong key or it needs to be reprogramed.
  21. Replies
    3
    Views
    113

    If its been sitting up for 2 years, you need to...

    If its been sitting up for 2 years, you need to rebuild the carbs. If not, you will soon be rebuilding the engine.
  22. Check all the cable connections from the battery,...

    Check all the cable connections from the battery, along with the cables ends. The cable ends may look OK but they'll get corroded on the inside and cause the exact same problem.
  23. Replies
    27
    Views
    977

    We have the same problem on the Doo's. I think...

    We have the same problem on the Doo's. I think its an inherit problem to a jet ski, due to the fact that water sits in the exhaust at all times. Taking it out after every ride seems to help but...
  24. Replies
    2
    Views
    125

    WTB I've got a new one if interested.

    I've got a new one if interested.
  25. Replies
    4
    Views
    160

    It monitors and help keep you from melting your...

    It monitors and help keep you from melting your exhaust system (hoses, resonators) if its not getting sufficient cooling. It does not have any input as for as controlling the engine, other than...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4