Search

Type: Posts; User: Hydrotoys

Search: Search took 0.04 seconds.

  1. Replies
    8
    Views
    8,600

    Sticky: Like I said, take the measurements without the...

    Like I said, take the measurements without the midshaft, then WITH the midshaft installed. They should be very close....and take the damn shim out of the front!
  2. Replies
    8
    Views
    8,600

    Sticky: ...and spin the driveshaft to makesure it isn't...

    ...and spin the driveshaft to makesure it isn't wobbling on you...

    I sure hope you have dowel pins in everything at this point. O:)

    If your nice midwall bracket screws up your alignment, expect...
  3. Replies
    8
    Views
    8,600

    Sticky: answer above.

    answer above.
  4. Replies
    8
    Views
    8,600

    Sticky: GPRXP Engine installation.

    This assumes you are using the same mid-shaft design as in the Vigilante designed and sold by Ted Thompson. You can find this info in another thread. If you have gone a different route, then this...
Results 1 to 4 of 4