Search

Type: Posts; User: 1tommygunner1927

Page 1 of 8 1 2 3 4

Search: Search took 0.07 seconds.

  1. http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=457515&stc=1

    15 mph is about as fast as you want to tow a SeaDoo......the ski begins darting left and right and the faster you go the...
  2. You're a smart guy, figure it out!

    You're a smart guy, figure it out!
  3. Replies
    9,511
    Views
    633,005

    I never heard of that brand ammo but a squib...

    I never heard of that brand ammo but a squib round (no power charge) can happen with any factory ammo, like it did with .45 cal Winchester ammo is was using in my Dan Wesson Valor; The bullet was...
  4. This is why a tennis ball inserted into the...

    This is why a tennis ball inserted into the exhaust outlet is better than the clamp. Start the ski the ball is blown out, and a clamp isn't bouncing around in the glovebox or elsewhere!
  5. Replies
    9,511
    Views
    633,005

    Firearms were readily available and much more...

    Firearms were readily available and much more accessible in the past yet murder and other crimes were less numerous.
  6. Replies
    9,511
    Views
    633,005

    Factory ammo or reloads?

    Factory ammo or reloads?
  7. Replies
    109
    Views
    16,169

    Poll: I have better hook up with the the Riva stainless...

    I have better hook up with the the Riva stainless grate over the R&D, but the Riva grate is slightly slower.
  8. Replies
    5
    Views
    361

    Stock ecu stock charger stock rpm.....12.2-12.7...

    Stock ecu stock charger stock rpm.....12.2-12.7 or so is acceptable afr. 11.7 is too rich for stock, and for 14 pounds of boost, usually. Only way to know for sure is to datalog, especially knock....
  9. SS wear ring SS impeller......any dimensional...

    SS wear ring SS impeller......any dimensional change due to temp should be equal with both. Impeller blade flexing more likely.
  10. Use the best IC you can afford. My Garret cored...

    Use the best IC you can afford. My Garret cored IC logs air intake manifold temps the same as lake water temps +/- 1 or 2 degrees. Pump efficiency matters too!
  11. This is the problem with hand bending impellers &...

    This is the problem with hand bending impellers & using a SS wear ring. Send impeller to Glenn at Impros for pitching. Whether 3 or 4 blades, he basically "blueprints" the impeller.
  12. Its about the Volume of air getting in the hull. ...

    Its about the Volume of air getting in the hull. In hull temps usually is not a factor as the IC will cool the air intake charge to near lake or ocean water temps. With MoTeC I "see" in hull air...
  13. Replies
    5
    Views
    361

    Humidity and barometric pressure plus water temps...

    Humidity and barometric pressure plus water temps will affect speed numbers. The lower the humidity and water temps plus higher the barometric pressure together will generate higher performance.
  14. Getting more air into the hull improves...

    Getting more air into the hull improves performance. If you haven't tried it you'll never know! You'll gain at least 200 more rpm.........
  15. You're not far off on that! Some basic...

    You're not far off on that!



    Some basic items need to be addressed: ensure engine alignment is spot on, same for intake grate and ride plate, fill ride plate holes, check steering, get air into...
  16. ***

    ***
  17. LOL.....I only did it for 10 years, but it was...

    LOL.....I only did it for 10 years, but it was for 70 miles......each way!
  18. What Riva claims: ...

    What Riva claims:

    https://yt3.ggpht.com/ytc/AKedOLTO8MDOWu95nzFtwewyFruWfHTKhGzQAwbcJVY3=s88-c-k-c0x00ffffff-no-rj RIVA Racing




    Our RXP-X 300 Stage 2 Kit delivers 81...
  19. Replies
    9,511
    Views
    633,005

    Sounds as if this presenter would like the Glock...

    Sounds as if this presenter would like the Glock 44.
  20. This is one part you want to buy new and OEM...

    This is one part you want to buy new and OEM ONLY!

    The older style stator has a 3 pin connector mid way in the harness to the regulator/recifier (RR). The 300 stator wiring runs directly to the RR.
  21. See post 21 and 31.

    See post 21 and 31.
  22. Replies
    17
    Views
    926

    Maybe Andy (Dash Pac) has something in the works...

    Maybe Andy (Dash Pac) has something in the works to "fix" this situation. Until then, go caveman!
  23. Replies
    17
    Views
    926

    We all know the speedo is not accurate, what...

    We all know the speedo is not accurate, what makes you think the rpm gauge is accurate? I view BRPs decision to eliminate smaller rpm increments as an admission that is isn't accurate. Weather ...
  24. Replies
    17
    Views
    926

    ***

    ***
  25. Replies
    95,231
    Views
    9,757,711

    When do they decertify the AZ election and call...

    When do they decertify the AZ election and call Trump the winner?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4