Search

Type: Posts; User: jetskier

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Never took #37 apart, figured i'd damage somethin...

    Never took #37 apart, figured i'd damage somethin and have to buy the whole assembly. Guess polaris considered #37 and #39 as a pump rebuild. Figured there was somethin special in there. K-saki site...
  2. 137 is part of the fuel pump gsket set. Should be...

    137 is part of the fuel pump gsket set. Should be 3 pieces to the pump. I posted a breakdown of the pump side. From the years i've looked at the polaris parts diagrams i don't remember seeing the...
  3. Maybe talking about the pump side, with the...

    Maybe talking about the pump side, with the tamper resistant screws. Think the brass seat is also pressed in. Didn't think it was servicable. The Mikuni's have servicable seats.
  4. The console gauge doesn't loose any data. Only if...

    The console gauge doesn't loose any data. Only if u disconnect the battery. The aftermarket IFB is suppose to have reverse limiting, the 2 i bought said it did, never tested to see if it did. Putting...
  5. Since u have the aftermarket IFB. When u get the...

    Since u have the aftermarket IFB. When u get the battery back in try this. Listen to the IFB when u go from forward to reverse. Lanyard not inserted. Does IFB make a click sound. If so, its probably...
  6. Makes me feel a lot better about my MSX's. Only...

    Makes me feel a lot better about my MSX's. Only 123 hrs behind. Original turbo and motor.

    http://www.greenhulk.net/forums/attachment.php?attachmentid=423416&stc=1
  7. Lol. Think i miss understood which tube. I didn't...

    Lol. Think i miss understood which tube. I didn't remove the restrictor in the feed tube. Didn't know it had a restrictor until years later. Was looking for a feed tube o-ring on polaris site and...
  8. Never touched the hull exhaust tube, afraid i...

    Never touched the hull exhaust tube, afraid i would damage it trying to unscrew the nipple. Guess thats the tube ur talking about. I put the tee in the feed line. Then cut the drain line with enough...
  9. I changed my 96 SLTX water routing. Added the tee...

    I changed my 96 SLTX water routing. Added the tee to the feed house and hooked the self drain there. Then capped the the exhaust outlet fitting. Does not run good with complete thermostat removed. If...
  10. Replies
    78
    Views
    5,295

    You need to water test it. Reving on trailer...

    You need to water test it. Reving on trailer means nothing. A sick Outboard will rev up on the muffs, but under load in the water it will not. Always water test to make sure the problem is fixed.
  11. Replies
    22
    Views
    1,871

    Does it blow fuel back threw the carb throat with...

    Does it blow fuel back threw the carb throat with the breather cover off? If it does you might want to check the reeds.
  12. Replies
    5
    Views
    806

    The MSX is a great ski. Bought mine both new,...

    The MSX is a great ski. Bought mine both new, still in the shipping package. I have 110's, so never rode a 150. They handle good and have a dry ride. I like how the hulls are shaped. If mine ever...
  13. If its running on the gas thats being dribbled in...

    If its running on the gas thats being dribbled in it, it should eventually pick up. If the fuel system is in working order.
  14. Has it ran since the motor took on water and if...

    Has it ran since the motor took on water and if not how long has it set up?
  15. Replies
    2
    Views
    630

    A flush could clear the problem, wouldn't hurt to...

    A flush could clear the problem, wouldn't hurt to try. Make sure its running before u turn water on. Turn water off before u kill it. It fixed my SL900 overheat problem one time. In shallow water...
  16. If the fuel system is dry from being rebuilt or...

    If the fuel system is dry from being rebuilt or fuel lines replaced it may take it a while to pick up. Your doing the right thing to get the fuel system re-primed. Make sure its mix gas ur dribbling...
  17. Replies
    7
    Views
    1,261

    Sounds like a boost leak. Does it have the...

    Sounds like a boost leak. Does it have the original factory small rubber lines to the wastegate acutator, fuel pressure regulator, and blow off valve. Mine dry rotted and cracked. Ran good until the...
  18. Replies
    22
    Views
    2,117

    Dang, hate to see that. My eyes wasn't playin...

    Dang, hate to see that. My eyes wasn't playin tricks on me, when i seen the scuffing above the exhaust port. Thats ur compression problem. Could have been over heat, or a cylinder bore matched/bored...
  19. Replies
    22
    Views
    2,117

    May be the way the light is hitting the cylinder...

    May be the way the light is hitting the cylinder in the first pic, but looks like some fine scratching begining to start above the exhaust port. If the compression numbers don't go up pull the jugs...
  20. Replies
    14
    Views
    3,094

    Anything over 1600 RPM is high for idle in water....

    Anything over 1600 RPM is high for idle in water. Make sure u installed the o-rings on the intake manifold to head if u removed it. Check ETB mounting and the boot. Check banjo bolt and the small...
  21. Replies
    14
    Views
    3,094

    How high of idle in the water. High idle in the...

    How high of idle in the water. High idle in the water is a air leak in the intake manifold area or throttle body boot. Unless the other problems are causing this. They tend to high rev out of the...
  22. Thats the battery vent tube in the first picture....

    Thats the battery vent tube in the first picture. The 2nd is were the battery vents to the outside of the hull. Paddle wheel tells the NGI (uses wires instead of a hose) the speed to display on the...
  23. Thread: MSX110 help

    by jetskier
    Replies
    29
    Views
    2,001

    The oeitker's on the fuel lines look to be...

    The oeitker's on the fuel lines look to be stronger than the regular ones used everywhere else. Those clamps can be a pain sometimes. Replacing mine sometime this month. Im gonna disconnect quick...
  24. Thread: MSX110 help

    by jetskier
    Replies
    29
    Views
    2,001

    Hiperco is correct the orange that came in them...

    Hiperco is correct the orange that came in them is enviromental safe. Automotive isn't no matter the color, it will tell you on the bottle the type it is. Dex cool is orange, but its not low tox. I...
  25. Thread: MSX110 help

    by jetskier
    Replies
    29
    Views
    2,001

    A bad plug could cause the symptoms ur having. A...

    A bad plug could cause the symptoms ur having. A plugged fuel filter could be causing weak fuel pressure and putting a bind on the fuel pump which is over working it. Im abt to service the filters on...
Results 1 to 25 of 104
Page 1 of 5 1 2 3 4