Search

Type: Posts; User: nashvegas

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Sticky: Introducing the 2020 line up of Yamaha Waverunners and Jet Boats.

    .
  2. Sticky: The new colors suck except the all black FX. And...

    The new colors suck except the all black FX. And when are they gonna fix these stupid 155 pump tunnels?
  3. BNG

    BNG
  4. BNG

    BNG
  5. Replies
    8
    Views
    288

    View Post

    Itís most likely the throttle body adapter. Get the aftermarket aluminum one and never look back.
  6. Replies
    8
    Views
    288

    High idle 3k rpm

    Pretty sure this is your answer. Have fixed this problem on a couple of skis now. Both times it was an vacuum type leak after the throttle body. Acted just like no wake mode.

    Did you drill or tap...
  7. Replies
    19
    Views
    924

    Is there someone who has successfully done a Hull...

    Is there someone who has successfully done a Hull mod on this version of FX? Need some pics of that if so.
  8. Replies
    19
    Views
    924

    Plate cut? We have several around here with...

    Plate cut? We have several around here with similar setups all running 80+ in the 90+ degree stuff with 50-70% humidity at 400ft elevation.
  9. Replies
    19
    Views
    924

    You running the stock IC also? Would surprise me...

    You running the stock IC also? Would surprise me if you were not and not able to crack 80 in the heat.
  10. Replies
    63
    Views
    5,310

    On the 2008-11 FX SHO a Jim cut plate was good...

    On the 2008-11 FX SHO a Jim cut plate was good for like 4.5mph just depends on the ski and how bad the stock plate is.
  11. Replies
    14
    Views
    1,720

    why your 2019 fx svho may be slower

    Jim youíve probably done a few of these new FXs now. Iím hearing around a 2 mph slower hull mod for mod compared to the prior version. Whatís your experience?
  12. Gonna have a hard time matching 17-18lbs of SVHO...

    Gonna have a hard time matching 17-18lbs of SVHO boost on those cast pistons. It would be cheaper to not build the motor and just get the SVHO.
  13. Replies
    6
    Views
    344

    Sounds like your bearings may be pushed into your...

    Sounds like your bearings may be pushed into your seals. When you take the cone off again you will see the back end of the shaft with the nut. Bang the end of the shaft with the nut with moderate...
  14. View Post

    Yes. Limp mode. Itís been years ago but if I remember right 3500 rpm max. Which really sucked as I was 55 miles away from where I put in. Ski would not plane and sucked gas bad due to plowing through...
  15. Sticky: No results yet?

    No results yet?
  16. Replies
    13
    Views
    742

    Wedge Plate feedback

    I have a 2 degree wedge and the very elusive 1 degree wedge and still find that the 5 degree nozzle is faster on smooth water with the FX. Iíve tried both on many different FX skis with different...
  17. Replies
    8
    Views
    370

    I do regular rides 170+ miles without a fuel stop...

    I do regular rides 170+ miles without a fuel stop carrying an extra fuel on my FX. By far itís not the fuel. Itís the lack of open water experience that will do you in quick.
  18. Replies
    2
    Views
    225

    Mustang survival jacket and klim snow mobile bib...

    Mustang survival jacket and klim snow mobile bib with thinsulate are my go to for outer shell. I ride regularly during the winter months comfortably 27 degrees and up.
  19. Replies
    8
    Views
    370

    Based on your post count and question the answer...

    Based on your post count and question the answer is no. There are people who ride the open water to the Bahamas, itís doable but I wouldnít suggest you do it until you have some real experience...
  20. Replies
    10
    Views
    786

    Speed wise 2017 faster?

    Speed wise 2017 faster?
  21. Replies
    22
    Views
    1,117

    Nice write up. All being said ceramic coating...

    Nice write up. All being said ceramic coating along with some SIO2 maintenance is a game changer for those OCD about keeping their paint looking top notch.
  22. Replies
    18
    Views
    1,098

    Dry suit by far. Wearing a wet wetsuit in the...

    Dry suit by far. Wearing a wet wetsuit in the cold will rob you of your core temp. The best way to maintain your core temp in between dives or if you get wet riding a ski or something is to get out...
  23. Thread: Impeller

    by nashvegas
    Replies
    11
    Views
    799

    Just cleaned this up for a friend. Just as I...

    Just cleaned this up for a friend. Just as I described above

    447250

    447251

    447252

    447253
  24. Thread: Impeller

    by nashvegas
    Replies
    11
    Views
    799

    Impeller

    From what I could tell in the pic the prop is dinged on the leading edge where the prop bites the water, not dinged where it meets the wear ring. By all means to the OP if you canít gather what Iím...
  25. Thread: Impeller

    by nashvegas
    Replies
    11
    Views
    799

    Impeller

    I fixed one with similar damage and couldnít tell a difference once fixed. Trace a sharpie tip along the edge of each blade using something flat along the edge of the blade. If damage is thicker than...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4