Search

It might not have been a great deal, but deals are hard to come by in this market. Then again, it's always worth paying more for a clean, low-hour ski.

You might have gotten a better deal if you...

From the NADA site: "Note: Vehicles/Vessels in exceptional condition can be worth a significantly higher value than the Average Retail Price shown."

Prices here in NY are insane since last year. ...

From a safety perspective seven years maximum, and depending on the climate and storage conditions, could be a lot less.

DOT date code on the sidewall gives the age since manufacture.

Sitting...

Roger that! just don't dip it in salt.

http://greenhulk.net/forums/attachment.php?attachmentid=473063&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=473064&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=473065&s...

inspect every 25hrs.... my last 5 ultra have all gone past 100hrs on OEM bearings... but checking is the key to a long bearing life , as water inside the pump happens to all brands and will take...

Not sure about what the manual says in regard to the pump bearings. I do know a few friends that have 100+ hrs on their Kawi 310’s and never checked/inspected or changed the pump bearings. I...

Thanks for the response. Your info makes me feel a little better about my searching skills. I saw a few people calling it the "drive shaft tunnel" but that's as close as a I got. I talked to a guy...

I replaced all of the lines yesterday and found that my fuel filter had a small leak from a stress crack so that was a good find.

Thanks for the help.

I had an oil pump sitting here so I put on the calipers to measure. Steve is exactly right on the measurement.

I think I used a 1/16 x 3/4 and it worked, but now that we know its available from...

changed the plugs and put a new battery. Also adjusted idle screw a little. Runs like a champ. I would think that spark plugs were fouled

Send it? with no water showing at pisser?

No, you need to find out why your pisser is not showing water. It located on the starboard side (right) just ahead of the foot well.
If thats working,...

If you really want to run without oil injection you would have to modify the engine to do so. It is not worth the effort. Go back to using the oil pump. Make sure when you reinstall it you put the...

I have the same ski.. You really should convert back to the oil injection system on this specific ski. The oil pump on the stxr feeds the front and rear balancers with oil as well, you do not want to...

Let see, 600 to 800Volts , yep that will work great on water! Wipe out on a gas ski, you get a bruse or sprain and a little swim back to the machine. Wipe out on an electic ski and you may survive...

Offshore riding - the primary objective must be reliability of the running watercraft.

Every thing that you add to a watercraft can potentially reduce reliability. Even a simple manually operated...

That twenty six year old trailer looks like it was built for much shorter and smaller PWC hulls.

To get the back end of the hull onto the actual bunks it looks like the hull would have to move...

Hi, was thinking... Take a Sxr 1500, put on a hood steering kit.
Do some minor work of the rear Hull and put in a seat console like from a Reaper. Has this been done yet?
4-stroke freestyle...

Not all ST tires are limited to a 65 mph rating. One example is Carlisle @ 81 mph:

https://www.carlislebrandtires.com/our-products/product-detail/radial-trail-hd/

I think the Maxxis are rated...

Another photo. Looks pretty simple and gives you the whole upper deck for SUPs, kayaks, gear.... whatever. ...

After struggling with this same problem for years, I now reverse-assemble the 12F/15F motors. Start with the cylinders and top case half only, and drop-in each piston from the top (rod attached)...

I really wish people would stop talking OTD. Taxes vary anywhere from 0 to 10%. So at least stage what your taxes our other comparing is pointless.

looks like we wasted our time with this one..

a "post and ghost", OP hasn't been here since last august

I'm getting less inclined by the day to waste time on newly registered users

unsubbing...

Finally have the project gp out of the garage and on its home till its warm enough for a test ride. This stand works extremely well and for these smaller skis theres no reason to have a winch to get...

Don't jerry rig it and screw somebody else. Take the carbs apart, clean them, rebuild them, and be proud about selling a great running ski.