Search

Type: Posts; User: shumie7

Search: Search took 0.00 seconds.

  1. Replies
    113
    Views
    5,071

    Haha I hear ya man, i surely wish I wasn’t part...

    Haha I hear ya man, i surely wish I wasn’t part of the water in the Kawasaki engine club it’s so frustrating. So you just use the ultra copper spray on an oem gasket?
  2. Replies
    113
    Views
    5,071

    I hear ya. Yeah, if I would have been installing...

    I hear ya. Yeah, if I would have been installing an exhaust that looked anything like my previous one I would have definitely had the mating surface machined but this new exhaust I got looked 100%...
  3. Replies
    113
    Views
    5,071

    It’s all good. And yes I did, and then repeated...

    It’s all good. And yes I did, and then repeated the torque sequence multiple times.
  4. Replies
    113
    Views
    5,071

    Dry and it had some factory type glue film on it....

    Dry and it had some factory type glue film on it.

    And yes I went off the torque sequence from the manual. I did not pressure test my new manifold but I knew the history on it very low hours on a...
  5. Replies
    113
    Views
    5,071

    What’s up everyone, I’ve been following this...

    What’s up everyone, I’ve been following this thread and any others about water getting into these Kawasaki engines and I also made a post on this one back on page 9. Well I thought I had found the...
  6. Replies
    113
    Views
    5,071

    I have an 07 Ultra LX that I purchased recently...

    I have an 07 Ultra LX that I purchased recently for cheap, shows around 60 hours but not sure on the history of the actual engine and what it’s been through. But it is doing the same thing, runs...
  7. Thanks for the replies, the entire engine leak...

    Thanks for the replies, the entire engine leak test makes sense now, I will do some more research on here to get some ideas on that.

    Since I'm going to do a full rebuild, any tips on who you...
  8. Thanks for the reply. I would like to find the...

    Thanks for the reply. I would like to find the problem if possible before I rebuild. In your experience, where are common areas to cause such an air leak meltdown? In the sad shape my pistons are in,...
  9. Waveblaster 760 Engine Rebuild Any Advice Appreciated

    So I bought a cheap waveblaster 2. The guy said he had rebuilt the engine but couldn’t ever get it to run right and already had replaced one piston that he put a hole in after the rebuild. So it ran...
  10. Replies
    0
    Views
    315

    13/16 Skat-Trak vs 13/18 Solas WR500

    I havenít found this actual comparison anywhere online. This may be a shot in the dark but does anyone have any opinions on these two different SS impeller options for the WR500? Thanks!
Results 1 to 10 of 11