Search

Type: Posts; User: swlamarshrunner

Page 1 of 8 1 2 3 4

Search: Search took 0.03 seconds.

  1. 701 Swapped Kawasaki SXR 1500 - Conversion For Kids

    Before I get all the negative Nancy's, I want to first state these things:

    Yes, the ski has a smaller engine than stock - it is specifically for my kids
    The ski has a throttle stop to limit...
  2. Jam Racing Pro B1 hull. Bottom is very similar...

    Jam Racing Pro B1 hull. Bottom is very similar to Trinity
  3. Yeah, yamaha pump and I used ADA Billet couplers....

    Yeah, yamaha pump and I used ADA Billet couplers. You could also use stock kawi 1100 engine coupler and then put the other stock side on the yamaha midshaft... Same thread/pitch. I had a 15/22...
  4. FS - Parts Tool sold. OEM Valve springs/retainers still...

    Tool sold. OEM Valve springs/retainers still available
  5. Bringing This MSX 150 Back To Life

    After selling my msx 150 to a friend last summer, I kind've regretted selling it so have been searching for another one. Nothing has popped up the last few weeks in the marketplace so I contacted a...
  6. FS - Parts Sounds good, thank you

    Sounds good, thank you
  7. FS - Parts Tried to send pm but says your inbox is full. ...

    Tried to send pm but says your inbox is full.

    Let me know shipping address after payment and I will make a shipping label and send over to you today, ship tomorrow.


    Thanks, Ricky
  8. FS - Parts Riva Valve Spring Compressor Tool & OEM Valve Springs/Retainers

    Valve spring compressor for seadoo, used once. $108 shipped priority TOOL SOLD

    OEM 4tec valve springs and retainers from 260 rxpx. $58 shipped

    ...
  9. Yeah have to use a puller and usually give it a...

    Yeah have to use a puller and usually give it a good whack with a hammer once it gets tight. If you have enough clearance in front of the motor to get a puller in there then you may could leave it in...
  10. Ok, more than likely the CDI. Unplugging the...

    Ok, more than likely the CDI. Unplugging the stop switch was just a free and quick way to diagnose 1st thing. If CDI does not fix it and you end up replacing the stator, it is not that difficult to...
  11. The cost is pretty low to completely rebuild a...

    The cost is pretty low to completely rebuild a 760 and the engine is pretty easy to take all the way down. I would strip it down to inspect crank then start fresh with new crank seals, all new...
  12. With the hood up, look for the wires coming...

    With the hood up, look for the wires coming through the handlebar stem. Then trace the black/white plug as seen in pic below. No need to take the switch apart, just unplug the black/white plug and...
  13. Try this. At the end of the start/stop switch,...

    Try this. At the end of the start/stop switch, unplug the black/white plug from the main harness. Make sure you are holding the end of the plug against the block when checking spark. Very common...
  14. Replies
    1
    Views
    168

    SOLD SOLD

    SOLD
  15. Replies
    6,773
    Views
    371,692

    That was some nasty storms that rolled through a...

    That was some nasty storms that rolled through a few days ago but we're making the best of it
  16. Stock kawi 1100 waterbox is too big. I have this...

    Stock kawi 1100 waterbox is too big. I have this one that I would sell. TDR and the inlet/outlet are perfect sizes to work for the kawi 1100. Fits perfect back there too.
    ...
  17. Replies
    1
    Views
    168

    SOLD Solas 13/18 160mm Impeller

    Damaged Solas 13/18 160mm Impeller. Got this from Dean for my level 3 FX SVHO last year. Sold the ski and ended up doing some work on it when the new owner sent some rocks through the pump. $125...
  18. I think the 1100 waveraider waterbox along with...

    I think the 1100 waveraider waterbox along with waveraider 701/760 and gp760 will fit. I have the extreem throttle waterbox in mine now and it could be quieter if I was injecting more water. I have...
  19. @JonJet where are you located? I have a good...

    @JonJet where are you located? I have a good running 1100 engine but I'm in SW Louisiana.
  20. More videos

    Madisonville Race

    https://youtu.be/PUCtNc6OA9Y


    https://youtu.be/f2i1vUA0OLQ

    Testing the new handling parts & throttle response (dialing in jetting & screws when I swapped to Race/pump...
  21. Recap vid from Powerboat Nationals Race in...

    Recap vid from Powerboat Nationals Race in Shreveport. These were longer moto's and I was getting gassed early. Can't blame that on the ski though!


    https://youtu.be/AmLgsl8nd8w
  22. 2.5 year update

    Well its been over 2.5 yrs since I started this thread and ALOT has happend since then. I honestly forgot that I had started this thread but will do my best to catch you guys up on what all has...
  23. Waterbox is commonly done 1 of 2 ways, either cut...

    Waterbox is commonly done 1 of 2 ways, either cut down a waveraider waterbox or buy a handmade waterbox from extreem throttle designed for this exact application. You use a yamaha pump (stock or...
  24. Replies
    5
    Views
    494

    SOLD Sold

    Sold
  25. Replies
    5
    Views
    494

    SOLD Sorry, I just saw this. I have no problem...

    Sorry, I just saw this. I have no problem shipping to Italy as long as additional shipping is covered by buyer
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4