Search

Type: Posts; User: Duke

Search: Search took 0.04 seconds.

  1. Replies
    51
    Views
    40,415

    Sticky: New seals will create a little tension. Not an...

    New seals will create a little tension. Not an issue.
  2. Replies
    51
    Views
    40,415

    Sticky: I push the seals in till they bottom out.8-[ ...

    I push the seals in till they bottom out.8-[

    The spacer is the same thickness etc. and goes between prop and pump. Flat side goes torwards prop.

    1/2" sounds kinda large. Can you take a pic??
  3. Replies
    51
    Views
    40,415

    Sticky: Found out recently that a 1" PVC coupler works...

    Found out recently that a 1" PVC coupler works out perfect to push the seals in.
  4. Replies
    51
    Views
    40,415

    Sticky: :lol: :lol: No genius here, just good ole...

    :lol: :lol: No genius here, just good ole redneck ingenuity.;)

    Glad it worked for ya bud!!!
  5. Replies
    51
    Views
    40,415

    Sticky: Group-K for the spacer. The seals I installed...

    Group-K for the spacer.

    The seals I installed after it cooled down with my floor jack handle and some grease. Took very little pressure to get then seated. I'm sure any kind of pipe would work.
    ...
  6. Replies
    51
    Views
    40,415

    Sticky: Didn't think of that!=D> =D> Is that the new...

    Didn't think of that!=D> =D>

    Is that the new heavy duty bearing on the front?
  7. Replies
    51
    Views
    40,415

    Sticky: Pump bearing install tips.

    The absolute best way I have found to install new pump bearings does not involve a press.

    Installing the clean driveshaft in the freezer for 10hrs is the start. This will allow the installation of...
Results 1 to 7 of 7