Search

Type: Posts; User: casey67

Search: Search took 0.01 seconds.

  1. It's hard to tell in recordings. These ski's...

    It's hard to tell in recordings.
    These ski's are pretty loud, especially the impeller to drive shaft ,metal to metal connection.

    Many times I need to have them in the water with seat on to tell...
  2. Simply took off the knee guards/pads.

    Simply took off the knee guards/pads.
  3. I agree with K447, if all the other wires are...

    I agree with K447, if all the other wires are easily identified (colors are clear) then what is left over will go together.
    The red and green wires are the signal for each cylinder, not a high...
  4. The aftermarket wires are typically brighter in...

    The aftermarket wires are typically brighter in color, sometimes kinda pastel looking.

    The PVL wires are typically kinda dull.

    I have trouble with some colors if they are not side by side....
  5. 2cyl stator will have 8 wires. The 3cyl will have...

    2cyl stator will have 8 wires. The 3cyl will have 9 wires.

    Green CDI wire needs to connect to green stator wire.


    Early models used tan for temp warning. That also translated to 3 cyl CDI that...
  6. STOP !!! The 3cyl stator use a BLUE wire for the...

    STOP !!!
    The 3cyl stator use a BLUE wire for the third cyl.

    The 2cyl 803 CDI will have an 'Extra" grey wire for the temp circuit, limiter. Not used on 2 cyl typically.


    The red/pur stator...
  7. From the conversation I'd have to say you have...

    From the conversation I'd have to say you have the aftermarket stator, some things are slightly different from the factory PVL stator.

    The picture K posted is the 99 and newer design(2000+ 2cyl),...
  8. The factory Polaris gasket had a bead of some...

    The factory Polaris gasket had a bead of some sort of sealer already on the gasket, the stuff really made the gasket stick to both surfaces. Pretty much impossible to reuse the gasket.

    All depends...
  9. Yes, it seems you do have a pretty good...

    Yes, it seems you do have a pretty good understanding so far.
    Correct that the timing ring will be turned clockwise as viewed from the front.

    The high start i've seen and were reported here, will...
Results 1 to 9 of 9