Search

Page 1 of 16 1 2 3 4

Search: Search took 1.00 seconds.

  1. I just don’t get why so many people are afraid to...

    I just don’t get why so many people are afraid to drill a hole in these things. If you want to modify the ski you’re going to have to drill something at some time.
  2. Replies
    17
    Views
    1,002

    The blow off valve should help. However, the...

    The blow off valve should help. However, the biggest part to making your supercharger clutch last is your right finger. Do not rev the ski sky high out of the water. Also when you let off the...
  3. You'll gain a little bit in acceleration and top...

    You'll gain a little bit in acceleration and top end. As well as a good amount of noise from the intake.
  4. Id be up for a Lake Michigan get together...

    Id be up for a Lake Michigan get together sometime too. Ive run from Milwaukee to Racine and Kenosha a few times.
  5. I would try a local upholstery shop. Thats...

    I would try a local upholstery shop. Thats something they should be able to make for you.
  6. Replies
    28
    Views
    3,248

    It Works!!!!

    I have an update here. After finally getting a hold of all of the pieces and taking the time to plan and put it all together it does work. Heres what is needed and what I did

    For a tachometer...
  7. I use a 1/4 hex drive impact driver to spin bolts...

    I use a 1/4 hex drive impact driver to spin bolts out after breaking them loose by hand.
  8. Replies
    28
    Views
    3,248

    I’m working on this now. I have purchased an...

    I’m working on this now. I have purchased an analog to NMEA 2000 converter. I should be able to tap into analog sensors to display any data I want.

    So far my plan is for engine rpm, fuel level,...
  9. Replies
    23
    Views
    1,203

    If you don’t already have a copy of the factory...

    If you don’t already have a copy of the factory service manual get one and read through the engine removal procedure. The best advice I can give is to have a long 5mm ball end hex wrench for a 3/8...
  10. Replies
    10
    Views
    623

    Even better way to deal with the wire where it...

    Even better way to deal with the wire where it enters the hull. I removed my paddle wheel completely and used the cable entry from the paddle wheel for the transducer cable for my garmin gps
  11. Replies
    5
    Views
    446

    Battery powered or air ratchet. Gives you extra...

    Battery powered or air ratchet. Gives you extra reach
  12. Replies
    18
    Views
    1,311

    I used a razor blade as a scraper.

    I used a razor blade as a scraper.
  13. WIth an intercooler you’d be running a stage 2...

    WIth an intercooler you’d be running a stage 2 tune which puts you 82-86 mph most likely depending on conditions
  14. Do you check the jet pump for any debris? All...

    Do you check the jet pump for any debris? All it takes is a little piece and you won’t go anywhere
  15. Replies
    9
    Views
    1,361

    Go for the Yamaha. You’ll just gas and go for...

    Go for the Yamaha. You’ll just gas and go for many many hundreds of hours.
  16. Replies
    130
    Views
    7,155

    I’m not poo pooing Polaris. I’m just basing my...

    I’m not poo pooing Polaris. I’m just basing my comments on ownership experience between the Polaris and a new modern machine. There is no comparison. The new Yamaha is just better in every way. ...
  17. Ijust read through this whole thread. I see no...

    Ijust read through this whole thread. I see no mention of changing spark plugs. These ficht motors do weird things and sometimes it’s just the spark plugs. Always keep a new set of plugs on hand. ...
  18. Replies
    130
    Views
    7,155

    Because your sea Doo 951 Will blow up every 30...

    Because your sea Doo 951 Will blow up every 30 hours While the ex just keeps going and going and going
  19. Thread: 2021 rxp x

    by Mr. GP1800
    Replies
    67
    Views
    8,187

    It’s really expecting something special and game...

    It’s really expecting something special and game changing. Instead I get meh....
  20. Replies
    28
    Views
    2,181

    You’re on the limiter because of the 11/15 prop

    You’re on the limiter because of the 11/15 prop
  21. Replies
    4
    Views
    313

    Send it out to impros to have it repaired.

    Send it out to impros to have it repaired.
  22. Replies
    4
    Views
    622

    Loosen the winch and slide the whole winch tower...

    Loosen the winch and slide the whole winch tower back away from the ski. Adjust the bow roller so it sits in the same position on the hull where it’s shown now. What you are trying to achieve is...
  23. Replies
    5
    Views
    752

    The LT is a smaller trailer as well. If you have...

    The LT is a smaller trailer as well. If you have modern skis definitely get the elite. You won’t regret it
  24. Replies
    31
    Views
    1,468

    Because it’s way easier to pull the motor out...

    Because it’s way easier to pull the motor out than it is to try and remove the gas tank and work through the hood opening. So many people are afraid to pull the motor out of the ski to work on them....
  25. Replies
    16
    Views
    1,012

    I’d pull the motor rather than trying to move the...

    I’d pull the motor rather than trying to move the fuel tank and work on it in the hull
Results 1 to 25 of 400
Page 1 of 16 1 2 3 4