Search

Type: Posts; User: TwoGP12s

Search: Search took 0.00 seconds.

  1. Replies
    21
    Views
    3,870

    Hi Oleg, Here is a picture of the head gasket...

    Hi Oleg,

    Here is a picture of the head gasket with the enlarged cooling holes highlighted.

    Mike
  2. Replies
    21
    Views
    3,870

    Looking good, Jonesy! How is it running? I'm...

    Looking good, Jonesy! How is it running?

    I'm in the same boat, Re: back pain. I spent the better part of the day delivering and installing a Sawstop table saw and my back finally said "NO...
  3. Replies
    21
    Views
    3,870

    In the diagram below, I ran the hose labeled...

    In the diagram below, I ran the hose labeled "Overboard" to a fitting high up on the transom. I think I used a 19mm fitting that matched the hose size, but if I were to do it again, a 12mm fitting...
  4. Replies
    21
    Views
    3,870

    Hi Oleg and Jonesy, Oleg, I'm not sure what...

    Hi Oleg and Jonesy,

    Oleg, I'm not sure what picture you are looking at, but none of the images in this thread above show the head gasket (see new post below).
    Oleg and Jonesy: To enlarge the...
  5. Replies
    21
    Views
    3,870

    Long Overdue Update

    Whoa! I ran the snot out of the ski all last summer and had loads of fun with it. Sorry I missed all these questions, I was having too much fun on the water!

    Oleg - I'm not sure what the final...
  6. Replies
    21
    Views
    3,870

    7-10-19 Got it started today! :D YESS!! It...

    7-10-19

    Got it started today! :D YESS!! It idled pretty smooth, too, all things considered. I only let it run for 10 seconds or so as it wasn't on the hose. Before starting, I had to fix a...
  7. Replies
    21
    Views
    3,870

    List of Modifications Carbs/Intake/Fuel...

    List of Modifications

    Carbs/Intake/Fuel
    Drilled return restrictors and added 100 jet in return line (changed restrictor jet to 90)
    Extended both fuel pickups to bottom of tank and removed...
  8. Replies
    21
    Views
    3,870

    2000 GP1200R Conversion to 1300

    I thought I would start a build thread to document my experience rebuilding/converting my GP1200. This all started 2 years ago when one of the washers bracketing the piston pin bearing got loose and...
Results 1 to 8 of 8