Search

Type: Posts; User: waterpest

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    224
    Views
    37,393

    Is there still an option to purchase these...

    Is there still an option to purchase these handles or is there anybody else that can supply them???
  2. Sticky: Thx K447....so I guess seeing that I do have...

    Thx K447....so I guess seeing that I do have this spare round MFD, I could install that in the same location where it exists on the SLT750, extend the wiring harness and the speedometer tube to...
  3. Sticky: So the OVAL MFD is mostly dead, I have tried...

    So the OVAL MFD is mostly dead, I have tried plugging it in a half-dozen times or more, once it came to life had a nice crisp display, indicated correct fuel and oil levels, then went blank... I...
  4. Sticky: So I have this E box with the wiring harness from...

    So I have this E box with the wiring harness from a 95 SLT 750, as you can see here I powered the box and set the oil level sensor to just above halfway and fuel sensor to full as indicated by the...
  5. Sticky: There WAS moisture, it was wet after the ski...

    There WAS moisture, it was wet after the ski flipped. I disassembled the MFD, dried everything, cleaned the circuit board, rubber connector, bezel, and let it all dry in the sun for more than an...
  6. Sticky: Yes I unplugged to read voltage at the connector....

    Yes I unplugged to read voltage at the connector. I confirmed that voltage at the yellow stator wire in the connector...12.45v.
    I will check the integrity of the circuits feeding the connector and...
  7. Sticky: Thx for steering me to the info. I wish I had a...

    Thx for steering me to the info. I wish I had a loaner oval MFD to verify all that is going on. The MFD was working fine until it got very wet. Oil/Fuel/Power etc were all indicating what they should...
  8. Sticky: I have noticed upon reinserting the connector...

    I have noticed upon reinserting the connector that all display elements light up upon re-powering the MFD but the display reverts to LOPwr and inaccurate Fuel/Oil levels as well as no response to the...
  9. Sticky: I have not been able to find the "Reset...

    I have not been able to find the "Reset Procedure". Does unplugging the rear connector for a period of time accomplish the same "Reset"??
  10. Sticky: Does anyone know if the oval '96 mfd is...

    Does anyone know if the oval '96 mfd is repairable? I have fixed the faded screen but now it indicates low power even though the battery is fully charged, also the fuel and oil levels are inaccurate ...
  11. Replies
    26
    Views
    1,210

    Finishing up on this post, just opened up the...

    Finishing up on this post, just opened up the carbs and all three had defective needle tip, specifically the viton tip had a deep Groove in each....
    Thanks to all of you for your help... will not be...
  12. Replies
    6
    Views
    324

    Thanks for the info on "Randy's tuning...

    Thanks for the info on "Randy's tuning method".....it's foolproof and brilliant
  13. Replies
    6
    Views
    324

    Sometimes a Stator tests good but fails under...

    Sometimes a Stator tests good but fails under load/rpm....working through that myself with the same motor. Carbs/fuel line/fuel pump/coils/plugs/ were all changed but still got my bog although mine...
  14. Replies
    26
    Views
    1,210

    I checked for a large "swoosh" of air last time I...

    I checked for a large "swoosh" of air last time I opened the fuel cap, it was no more than the usual "pffft" sound...
  15. Replies
    26
    Views
    1,210

    Carbs are coming off next week to rebuild, will...

    Carbs are coming off next week to rebuild, will check the popoff then.
  16. Replies
    26
    Views
    1,210

    No gas in the flywheel/Stator...Yes!

    No gas in the flywheel/Stator...Yes!
  17. Replies
    26
    Views
    1,210

    One more question guys...since the ski ran well...

    One more question guys...since the ski ran well after I got all the gas removed can I assume that the leak into the crankcase was not via the fuel pump diaphragm but rather through one of the...
  18. Replies
    26
    Views
    1,210

    Got all the gas out safely. Started rough but ran...

    Got all the gas out safely. Started rough but ran well after a few minutes. I will get into the carbs when I get time, probably in a couple weeks. Thanks to all for your help, suggestions, and advice.
  19. Replies
    26
    Views
    1,210

    Good point...will be back to the lake this...

    Good point...will be back to the lake this weekend, I will keep you all informed of my findings. Thanks all for your input!
  20. Replies
    26
    Views
    1,210

    Just think about this, I am looking for Winter...

    Just think about this, I am looking for Winter tires for my Truck and still working on my 2 skis at the lake...Canada eh...lol
  21. Replies
    26
    Views
    1,210

    "Some liquid fuel may have worked itself past the...

    "Some liquid fuel may have worked itself past the crankshaft seals, so consider the possibility there is fuel inside the flywheel housing or in between the rear crank seal pair (the Fuji engine has...
  22. Replies
    26
    Views
    1,210

    Mockingee, I agree, there will be no oil film...

    Mockingee, I agree, there will be no oil film anywhere as the engine has literally been converted temporarily to a 3 piston gasoline pump.
  23. Replies
    26
    Views
    1,210

    Thanks Myself, that is what I was guessing, the...

    Thanks Myself, that is what I was guessing, the ski ran great (although I thought it was running a little rich) before it was left for 2 weeks, I am thinking that a ruptured diaphragm is not the root...
  24. Replies
    26
    Views
    1,210

    Myself what caused the gas to fill the crank?

    Myself what caused the gas to fill the crank?
  25. Replies
    26
    Views
    1,210

    Oil injection on the ski

    Oil injection on the ski
Results 1 to 25 of 92
Page 1 of 4 1 2 3 4