Search

Type: Posts; User: HDAV

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Reseal the transom bolts to hull between the...

    Reseal the transom bolts to hull between the ride plate and grate and replace bilge pump...
  2. Replies
    9
    Views
    202

    They might not sell that part anymore it’s been...

    They might not sell that part anymore it’s been replaced with an updated part also need oil pump gasket

    this is the stock unit

    6S5-17800-20-00




    I thought it was 14 on had the new...
  3. Replies
    4
    Views
    132

    Hi impedance faults can cause havoc on these...

    Hi impedance faults can cause havoc on these skis, check the engines ground connections as well as terminals and cables for breaks or damage
  4. Replies
    9
    Views
    202

    Yamaha only make one clutch now the older sho...

    Yamaha only make one clutch now the older sho motors need the idler gear updating to use the SVHO spec clutch
  5. Replies
    9
    Views
    202

    There are several ways the Sc clutch can fail...

    There are several ways the Sc clutch can fail proper operation is freely spins one way and not at all the other. If it spins both, not at all, is spongy it’s likely gone or about too.
  6. Replies
    5
    Views
    113

    Would consider a supercharger rebuild and find...

    Would consider a supercharger rebuild and find and a local Indy shop that has the dignsotic software or buy a candoo if looking to maintain your self
  7. Pull plugs see if it turns over does water come...

    Pull plugs see if it turns over does water come out of the plug holes? Having water in oil is not good, change the oil till clean then replace filter also pull air box if filter wet bin it and...
  8. Replies
    4
    Views
    108

    Run compression test and wouldn’t hand over cash...

    Run compression test and wouldn’t hand over cash without a water test or see it running on a lake or ocean and making full rpm and speed.

    Top end often needs a rebuild after 100 or so hours sounds...
  9. Regular oil and filter changes every year or 50...

    Regular oil and filter changes every year or 50 hours, stock very reliable.

    SC clutch only real weak spot. familiarise yourself with how to check it and the likely costs for replacement
  10. Gp dash isn’t new.... can’t see how it getting...

    Gp dash isn’t new.... can’t see how it getting wet would cause the ski to not start, check all the plugs on loom for water ingress and corrosion
  11. Replies
    17
    Views
    600

    Tune and prop under $1k after that wasting...

    Tune and prop under $1k after that wasting cash......
  12. Thread: What ski to buy

    by HDAV
    Replies
    9
    Views
    240

    Yamaha hulls are made of SMC toughest and...

    Yamaha hulls are made of SMC toughest and heaviest, nano xcel - lighter but less durable, nano 2 - even lighter again less durable. The if doing a lot of jumping then there are some reinforcers to...
  13. Take the plugs out and hold throttle in full will...

    Take the plugs out and hold throttle in full will it turn over?

    could be a weak starter, bad compression, bad earths, bad solenoids, could be bound up pump pull the pump and see if starts then....
  14. Replies
    18
    Views
    902

    Worth speaking to Yamaha do you still have...

    Worth speaking to Yamaha do you still have warranty? Certainly worth getting checked
  15. Foot well bubbles is usually sorted under...

    Foot well bubbles is usually sorted under warranty if it appears during warranty period...
  16. Replies
    5
    Views
    227

    Known that happen before.......filter replaced...

    Known that happen before.......filter replaced oil refilled ski ran fine rest of season...was traded if for a new model the next year....not saying it doesn’t need rings and 2 rods but that seems an...
  17. Replies
    21
    Views
    1,074

    Fitting aftermarket parts while trying to...

    Fitting aftermarket parts while trying to diagnose a fault is making your life harder than it needs to be............

    is idle that high or is dash going Screwy?
  18. Speed is about right for the rpm on a stock ski...

    Speed is about right for the rpm on a stock ski wonít go much go faster without mods, check prop for damage and clearance but itís not far off where it should be... check speed with gps and dash...
  19. Replies
    11
    Views
    412

    Tow rope, spare plug or 3, some oil (1 quart),...

    Tow rope, spare plug or 3, some oil (1 quart), first aid kit, jump leads/small booster, length of hose/jiggle siphon, inflatable bouy, PlB,
  20. Thread: fresh water tank

    by HDAV
    Replies
    7
    Views
    387

    look at the seadoo wake ballast tanks from about...

    look at the seadoo wake ballast tanks from about 2008
  21. Replies
    11
    Views
    378

    Do the NA motors have starboard pissers? On the...

    Do the NA motors have starboard pissers? On the sho thatís for the intercooler.

    Yamaha service schedule is every 50 hours or 12 months.......so hopefully the oil in the motor isnít 5 years old! I...
  22. Yeah ah looks like mine did, order a new one Avos...

    Yeah ah looks like mine did, order a new one Avos in Preston had then on the shelf but any dealer should get one in a few days form Yamaha. Also should be a washer on sensor make sure you have one...
  23. locations are on the OEM parts diagram the...

    locations are on the OEM parts diagram the likely one is near the rear of the motor intake side next to the anode mine tested in spec but since replaced has been fine I also ended up replacing the...
  24. Replies
    11
    Views
    361

    Look for a VXR from 2011-14 1800cc single piece...

    Look for a VXR from 2011-14 1800cc single piece seat (can swap with other vx of same year) no Sc to worry about 66+ no mods, runs on regular gas
    ...
  25. Replies
    3
    Views
    163

    Well you can rep@ce battery but might just need...

    Well you can rep@ce battery but might just need charging if ski has sat for a while, what voltage shows when running? Should be 14.5v ish and 12.5 when motor stopped under 11.5 I think shows as “lo”...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4