Search

Type: Posts; User: TimeBandit

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Only hope to be helpful. :cheers2: I found...

    Only hope to be helpful. :cheers2:

    I found another thread on here that summaries the codes ... and I hear what others are saying about the bucket adjustment - certainly worth a try, but hard to...
  2. I read your long story, and FWIW Yamaha likely...

    I read your long story, and FWIW Yamaha likely still rules.
    I had a similar experience involving a motorcycle wheel that I knew to be improperly honed boss landings where the disc rotor attaches to...
  3. Replies
    9
    Views
    300

    Alternative - some folks might want to look into...

    Alternative - some folks might want to look into outsourcing the job, rather than investing in a printer ... A site called "makexyz" is just one of a few that aims to connect you to local printers in...
  4. First, I'm on your side. I feel ya'. However, you...

    First, I'm on your side. I feel ya'. However, you must fully understand the environmentalist-mentality behind this if you are ever to understand it. Like I said back on post #8, it's less about...
  5. Replies
    9
    Views
    434

    So the pressure build-up is normal for these...

    So the pressure build-up is normal for these models, and it is intentional. That's a good sign. FYI, raw Petrol naturally releases hydrocarbons (which are bad for the environment), so the Yamaha vent...
  6. Replies
    35
    Views
    2,667

    Agreed….. the OP has not yet clearly elaborated...

    Agreed….. the OP has not yet clearly elaborated having an overheat alarm or that the ski keeps going into limp-mode as a result, so it sounds like the ski has more issues than just sand. Details are...
  7. Replies
    21
    Views
    1,199

    Hmmmm..... well my service manual only goes up...

    Hmmmm..... well my service manual only goes up to 2012 HO & SHO, illustrates no sub-grouping of pins, so I'll stop-short of asserting how yours is supposed to be.
    That said, can you attach a pic...
  8. Replies
    9
    Views
    434

    I haven't a theory regarding the source of your...

    I haven't a theory regarding the source of your issue,... but I have a few questions...
    a) How full is the tank presently? If full, how full is full exactly?
    b) Can you confirm if there is (or is...
  9. Replies
    21
    Views
    1,199

    Hope this helps … I’m looking at a 2009-2012...

    Hope this helps …
    I’m looking at a 2009-2012 (shouldn’t be that much more different) wiring diagram for the SHO … and I’m seeing no electronics (ECM) or other switchable devices that could or would...
  10. Replies
    21
    Views
    1,199

    Yes, that's normal and expected for the FI...

    Yes, that's normal and expected for the FI signals. They are not pure on/off like the coil signal, rather pulsed within the pulse (aka PWM).
  11. Replies
    21
    Views
    1,199

    Really no need to get an analog meter, because...

    Really no need to get an analog meter, because setting your DVM to "peak voltage" is the correct procedure as per service manual.
    The service manual states roughly 2.5v peak while cranking. You got...
  12. Replies
    21
    Views
    1,199

    I was able to take a look at the service manual...

    I was able to take a look at the service manual ... there's a NPN transistor illustrated inside the coil pack, so you are correct - it's not a ground signal, it will be a positive signal on that 3rd...
  13. Replies
    21
    Views
    1,199

    Sorry, memory fades me... I don't remember the...

    Sorry, memory fades me... I don't remember the TTL wire pulses pos or neg .. just that its a logic signal that instructs the coil pack to fire. May want to get an analog volt meter on that 1st -...
  14. Should be able to roll/support the ski to one...

    Should be able to roll/support the ski to one side is good enough, to avoid oil and gas issues.
    2015 VXR.... that's a gen 1 nanoxcel smc, so please liberally wipe the area clean with...
  15. Replies
    17
    Views
    1,244

    Adding an extra bilge pump is a great idea – I...

    Adding an extra bilge pump is a great idea – I have one, 1,100 GPM, with and above waterline discharge port, as the poster above mentions. It also has an override-on switch mounted up on my console....
  16. Replies
    21
    Views
    1,199

    All four coils bad? Very very unlikely. Rather,...

    All four coils bad? Very very unlikely. Rather, if you are sure none are firing (i.e. YDS active test fails), I’d focus on the common-denominator among all four coils. In no particular order, I can...
  17. View Post

    Going to keep it real here . . . I’m a local native to Tampa Bay gulf coast, it can be very harsh/rough riding depending on the day of the week – so I'd not plan a trip on the water that would span...
  18. Read the last couple posts here: ...

    Read the last couple posts here:
    http://greenhulk.net/forums/showthread.php?t=254249&p=3023795&viewfull=1#post3023795
    ... ask these owners how they are still holding up.
  19. Replies
    70
    Views
    22,781

    Nope - likely NOT at all. My memory is a bit...

    So is this really the issue?[/QUOTE]

    Nope - likely NOT at all.

    My memory is a bit fuzzy ... but the 1.8L ACCT has a built-in one-way ratchet-like mechanism (aka there's a "reset" technique in...
  20. Replies
    82
    Views
    19,766

    How much more psi given what weight oil? Would...

    How much more psi given what weight oil? Would that really amount to THAT much more tension?? IDK. POA group 4 synthetics are the most weight-stable over temp changes - aka get way less watery at...
  21. Replies
    82
    Views
    19,766

    Do a bit more deeper searching on this forum ......

    Do a bit more deeper searching on this forum ... as I remember reading other past threads where folks said they had no issues updating everything but the crank.

    Side-note: Might also consider...
  22. Replies
    10
    Views
    573

    Correct, the o-rings, part #2's. Yet I really...

    Correct, the o-rings, part #2's. Yet I really can't say if a leak there would wick over to the anode area or not.

    The plastic part nearest the anode . . . are you speaking of the crank case oil...
  23. Replies
    4
    Views
    397

    Awesome !! =D> Summer 2020 ?? Hey, shoot me a...

    Awesome !! =D>

    Summer 2020 ?? Hey, shoot me a PM when your next trip is around the corner. I would have like to have gone this time (saw your other thread) but the timing wasn't right on my side....
  24. Oh, and I forgot to add in my last post-up . . ....

    Oh, and I forgot to add in my last post-up . . . "VTX" ?? Miss-type?
    So in 07, the models offered --> VX Deluxe, VX Cruiser, VX Sport, and the plain 'ol VX.

    2-stroke : 250+ hrs would be...
  25. In a nutshell, the gauges simply report the run...

    In a nutshell, the gauges simply report the run hours from the ECU/ECM. You can attached a YDS system to the ski's harness to poll the ECU data for more details via a laptop computer, but in the end,...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4