Search

Type: Posts; User: kenfyoozed

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    129

    I am no expert with these engines, but i just...

    I am no expert with these engines, but i just replaced my reeds on my 62t, 95 wave raider 700. I used the carbon reeds that way when they go bad next time they will not cause any damage to the...
  2. Replies
    1
    Views
    115

    tore apart everything back down to the reeds....

    tore apart everything back down to the reeds. Used paper gaskets with a light coat of gasket maker at each joint. Buttoned her back up and she ran great. Took her out for 1hr shakedown and she ran...
  3. Replies
    1
    Views
    115

    95 waveraider revving up..

    just replaced the reeds and put on new gaskets at each joint. Now when trying to get it to idle it will run fine for a about 10 secs and then its starts to rev up and I have to kill it. Everything is...
  4. Replies
    5
    Views
    167

    I did just as you have suggested. Top of the...

    I did just as you have suggested. Top of the piston has a few nicks that I can only assume are from the petals. I was able to get the bore scope into the crank area and all looks good. I am going to...
  5. Replies
    5
    Views
    167

    I tried the bore scope but it was to big so that...

    I tried the bore scope but it was to big so that was a no go. Guess I will start looking at the service manual to figure out how this thing comes apart. I assume I can do this all while the engine is...
  6. Replies
    5
    Views
    167

    these are stainless.....guess that means a...

    these are stainless.....guess that means a rebuild. I have a bore scope I'll try to use to find it first. Maybe i'll see it and it will be easy to retrieve. Otherwise If I'm pulling parts off to find...
  7. Replies
    5
    Views
    167

    Broken reed = tear down?

    So I found I have broken petals that are missing from one of the reed assemblies. Does this mean I now have to tear down the engine to find the missing parts? I thought I remembered someone saying...
  8. Replies
    11
    Views
    308

    I guess i won't know until I tear into it. What...

    I guess i won't know until I tear into it. What would cause a reed to go bad if it is the OEM stainless. I doubt this ski was ever modded or much maintenance ever done. Which may be the issue....
  9. Replies
    11
    Views
    308

    Are used reeds worth installing or would new ones...

    Are used reeds worth installing or would new ones be better?
  10. Replies
    11
    Views
    308

    I was just thinking that might be the case. Might...

    I was just thinking that might be the case. Might as well do both while I am in there..... Is there an aftermarket set of reeds or is OEM better?

    Also just looked at the plugs and it seems the...
  11. Replies
    11
    Views
    308

    Took it to the river today. She idled for about 5...

    Took it to the river today. She idled for about 5 min. Would bog and die trying to get on plane. Then stopped running at all. On the way home now to diagnose what the issue is. I know it’s getting...
  12. Replies
    11
    Views
    308

    I found one of the springs in the carb out of...

    I found one of the springs in the carb out of place. I cleaned then good one more time and set both popoffs at 55-60psi with the new kit. After a bit of choking she started to run ok and I got her...
  13. Replies
    11
    Views
    308

    1995 Wave Raider......

    Picked up 95 wave raider. It had not been run in a few years. I pulled the fuel tank and clean it out. I cleaned out the oil tank and replaced all the oil lines and bled them properly. I also...
Results 1 to 13 of 13