Search

Type: Posts; User: steve45

Page 1 of 8 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    1
    Views
    62

    No problem with removing them--until you flip it...

    No problem with removing them--until you flip it upside down!

    Then it will instantly flood your 'Ski and possibly sink it.
  2. Replies
    6
    Views
    178

    I've tried adjusting the latch pin down lower to...

    I've tried adjusting the latch pin down lower to try to pull the door down tighter, but no luck.

    If you find a solution let us know.

    Does your storage bin have a drain plug? I haven't seen...
  3. Replies
    5
    Views
    206

    You may be using too much water pressure. Too...

    You may be using too much water pressure. Too much can flow backwards through the exhaust and back into the cylinders (at least this can happen on a Kawasaki, I'm guessing that the SeaDoo works in a...
  4. Replies
    20
    Views
    1,103

    I don't remember a cone-shaped spacer. Have you...

    I don't remember a cone-shaped spacer. Have you looked at the parts diagram?

    https://partsfinder.onlinemicrofiche.com/4tec/showmodel.asp?type=13&make=kawasakipwc&a=128
  5. Glad you got it running! I hope that you tell...

    Glad you got it running!

    I hope that you tell Yamaha of your experience. I would also suggest that you give the dealer some 'free advertising' here!
  6. Replies
    21
    Views
    1,810

    The fuel pickup had a lot of problems and new...

    The fuel pickup had a lot of problems and new ones are not available. I made a new one:

    http://greenhulk.net/forums/attachment.php?attachmentid=471705&stc=1

    I will run the On and Reserve lines...
  7. Replies
    16
    Views
    520

    Heat & freezing, along with penetrating oil, may...

    Heat & freezing, along with penetrating oil, may work.

    Following that, use an end mill with a drill bushing to get the top of the broken bolt flat, then try a left-hand drill bit with a drill...
  8. I don't know if the 260 had the upgraded jet pump...

    I don't know if the 260 had the upgraded jet pump or not. The 250 had problems with the impeller shaft moving and pushing against the crank and destroying the engine. Check for fore/aft movement of...
  9. Replies
    15
    Views
    2,569

    Thank relative speed. Which one is going faster...

    Thank relative speed. Which one is going faster while cranking? Which one is going faster while running?
  10. Replies
    15
    Views
    2,569

    https://en.wikipedia.org/wiki/Sprag_clutch

    https://en.wikipedia.org/wiki/Sprag_clutch
  11. Replies
    5
    Views
    514

    I don't do facebook, either, but I was able to...

    I don't do facebook, either, but I was able to view it by clicking on 'Not Now' when it asked if I wanted to join. The music was hideous, but the Waverunner was interesting. I had trouble...
  12. Replies
    15
    Views
    2,569

    OK then, sitting for months without charging a...

    OK then, sitting for months without charging a battery will kill it. I guess it is 'a thing'. A brand new charged battery must be charged periodically or it will die. Dirty or loose battery cable...
  13. Replies
    15
    Views
    2,569

    If it sits for months without charging the...

    If it sits for months without charging the battery, it can ruin the battery.
  14. Replies
    21
    Views
    1,810

    I thought I'd include a photo of the fuel tank. ...

    I thought I'd include a photo of the fuel tank. It's not like any other arrangement that I've seen. The thing in the middle of the tank is the pickup. It has two tubes, On and Reserve. If you...
  15. Replies
    13
    Views
    773

    Welcome aboard, wagsjet! Any fogging oil will...

    Welcome aboard, wagsjet!

    Any fogging oil will do. Kawasaki and the other PWC manufacturers market their own brand. StaBil and others also sell it.
  16. Replies
    21
    Views
    1,810

    I brought the Jet Mate home from my lake house...

    I brought the Jet Mate home from my lake house and started looking it over. I installed a battery and tested the electrical equipment. It cranks! I can hear the bilge pump running! The blower is...
  17. Replies
    9
    Views
    526

    This might be another option: ...

    This might be another option: http://greenhulk.net/forums/showthread.php?t=230909

    I'm planning to do this to an Ultra 150 hull that I have. I've been accumulating parts for it, have an engine,...
  18. Replies
    9
    Views
    526

    You'll get just above nothing for a trade-in on a...

    You'll get just above nothing for a trade-in on a new 'Ski. They don't want a 20 year old 'Ski sitting around that they don't even know how to work on. Buying a used Ultra 150 is a real crap shoot....
  19. Replies
    9
    Views
    526

    Doing a top overhaul on the 150 isn't all that...

    Doing a top overhaul on the 150 isn't all that difficult, but there are definitely some things you need to watch out for/be aware of. You MUST have a service manual.

    These have nikasil plated...
  20. Replies
    9
    Views
    526

    Are you using the same compression gauge? ...

    Are you using the same compression gauge?

    Sounds like one of the carb slides is sticking or something.
  21. Replies
    1
    Views
    158

    Ebay is your friend. Read this: ...

    Ebay is your friend.

    Read this: http://greenhulk.net/forums/showthread.php?t=287069
  22. Everybody has an opinion on this. My opinion is...

    Everybody has an opinion on this. My opinion is to leave the oil injection system in place, here's a number of reasons why:

    The oil pump is the most reliable part of the boat. It doesn't fail, the...
  23. Replies
    15
    Views
    2,569

    Welcome aboard, Jose! Have you tested/swapped...

    Welcome aboard, Jose!

    Have you tested/swapped the battery? What is it's voltage? Cleaned the connections on the battery?
  24. Replies
    5
    Views
    255

    I'd bet that the Europeans aren't stupid enough...

    I'd bet that the Europeans aren't stupid enough to put ethanol in their gasoline.
  25. Replies
    3
    Views
    222

    I looked at the parts diagram and was surprised...

    I looked at the parts diagram and was surprised to see that the trim cable doesn't have a bellows seal. I never noticed that on my 2015 310X, but I'm going to install one.

    The rubber bellows,...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4