Search

Type: Posts; User: Stinky Pinkie

Search: Search took 0.00 seconds.

  1. Replies
    13
    Views
    1,655

    Man I feel so stupid!!!! I had Denso plugs...

    Man I feel so stupid!!!! I had Denso plugs installed and not the NGK PZFR6H! It would not idle for nothing.

    Thank you you guys for your support I would be lost without this forum
  2. Replies
    8
    Views
    820

    Ok I see! LOL this only applies to 110 and 150 Msx

    Ok I see! LOL this only applies to 110 and 150 Msx
  3. Replies
    8
    Views
    820

    How do you perform a throttle relearn?

    How do you perform a throttle relearn?
  4. Replies
    13
    Views
    1,655

    Man just no luck!!! I cant seem to dial in the...

    Man just no luck!!! I cant seem to dial in the TPS just right it is either too high of idle or way too low! Then if I get it just right i tighten the bolts then it throttles up to 5K
  5. Replies
    13
    Views
    1,655

    Ok thank you very much for the advise. Is there...

    Ok thank you very much for the advise. Is there any adjustment for the TPS I don't see any adjustment. Or do I need to bust out the dremel? LOL!
  6. Replies
    13
    Views
    1,655

    If I unbolt the TPS and keep it plugged into the...

    If I unbolt the TPS and keep it plugged into the harness and then turn the shaft on the TPS by hand it will idle fine and it throttles up great! But when I bolt it back on it won't idle
  7. Replies
    13
    Views
    1,655

    Yes it idles fine I just can't rev it up

    Yes it idles fine I just can't rev it up
  8. Replies
    13
    Views
    1,655

    Ok just the replaced the TPS and it won't idle...

    Ok just the replaced the TPS and it won't idle but revs up great and no check engine codes! What could I check next
  9. Replies
    13
    Views
    1,655

    Ok I just ordered a new TPS.

    Ok I just ordered a new TPS.
  10. Replies
    13
    Views
    1,655

    How to determine a bad TPS?

    Hey guys I just picked up a 2003 MSX 140 and had to replace the fuel pump and fix the FPR. And now the ski will not idle unless I unplug the TPS. Dose this mean that the TPS bad?
Results 1 to 10 of 10