Search

Search: Search took 1.00 seconds.

  1. You might be able to open up the old starter...

    You might be able to open up the old starter motor and fix it. Maybe. Since it is not working you might as well take it apart.

    There is a whole section of the service manual just for...
  2. More likely the motor will have to be pulled to...

    More likely the motor will have to be pulled to swap fuel tanks.
  3. Please help, 2002 Virage TXi 1200 DI (Ficht)

    Ok, i pull the fuel pump and the regulator had falling off. i put it back on, put it back together and i checked fuel psi and it was slowly going up started at 10 and then went up from there. I...
  4. The assorted grease fittings pack I bought and...

    The assorted grease fittings pack I bought and used on my thru-hull assemblies says

    1/4-28 on the pack.

    Cheers!
  5. That spring came out of the bendix. Its not shown...

    That spring came out of the bendix. Its not shown in most parts fiche for the PWC's, but its shown in this picture from a Polaris ATV bendix. Its #20. It holds the 3 flywheels in position and helps...
  6. I made a thread about how to disassemble, clean...

    I made a thread about how to disassemble, clean and reassemble your bendix. There are also plenty on eBay but it is pretty easy to clean...

    http://www.greenhulk.net/forums/showthread.php?t=268628
  7. WTB Make sure the screen and orifice are clean. ...

    Make sure the screen and orifice are clean.

    http://www.greenhulk.net/forums/attachment.php?attachmentid=418786&stc=1
  8. WTB There are 3 connections to the exhaust pipe. ...

    There are 3 connections to the exhaust pipe. The large connection at the Front of the ski (when the pipe is installed), the small inlet at the top of the ski (with screen and orifice) and the small...
  9. WTB That hose looks distended. I suspect it has been...

    That hose looks distended. I suspect it has been overheated and heat stressed, perhaps many times.

    IIRC (blue Fuji engines are not my forte) the water injection orifice is hidden inside a water...
  10. Replies
    14
    Views
    1,315

    Sure, if the thread locker manages to insulate...

    I last tested it out of the water with an induction timing light, but I never tried under load would that make a difference?

    What I have a hard time wrapping my head around is that it always...
  11. I do not have a pop-off tool but I do have a...

    I do not have a pop-off tool but I do have a piston pin tool, somewhere ... :-k
Results 1 to 11 of 11