Search

Type: Posts; User: ZMANN

Page 1 of 8 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    30
    Views
    1,886

    stock reeds were stainless on that ski or no ? ...

    stock reeds were stainless on that ski or no ?

    i replaced all mine with carbontech brand unless I went all out for RAD valves
  2. 324613lol

    324613lol
  3. Replies
    30
    Views
    1,886

    sound like reeds to me also their should be...

    sound like reeds to me also their should be suction only not PSI to blow fuel back out of the carb
  4. Replies
    2
    Views
    591

    Agreed

    Agreed
  5. Replies
    9
    Views
    5,578

    In AZ We have people who ride their ski's at...

    In AZ We have people who ride their ski's at night with std boat marker lights
    They stated it's legal .. IDK I looked into it for a bit but could never figure out the letter of the law
  6. Replies
    42
    Views
    5,592

    ride one of my 3cyl 2 stroke"shaker motor" ski's...

    ride one of my 3cyl 2 stroke"shaker motor" ski's for a day LOL
  7. Agreed pro-x wsm for rec I bought all my...

    Agreed pro-x wsm for rec

    I bought all my ski's as basket cases ,, both of my 1200's were completely blown one had even run the rod through the cylinders LOL

    I change my own sleeves at...
  8. Replies
    29
    Views
    3,977

    they do vibrate .. but telling you if it is the ...

    they do vibrate .. but telling you if it is the normal amount would be hard over the internet ,,

    tell you what ,, they may be" low maintenance" but neglect the carbs for two long and you will...
  9. Replies
    23
    Views
    3,847

    Howdy PR

    Howdy PR
  10. Thread: any one ever????

    by ZMANN
    Replies
    13
    Views
    1,820

    Bill didn't list it out so I will do My best ,,...

    Bill didn't list it out so I will do My best ,, and then if I missed anything it will bother Him enough to chime in and clarify LOL

    too much to change in my opinion
    I have used the 63m cases...
  11. Replies
    23
    Views
    3,847

    I got tired of changing hard fuel lines and they...

    I got tired of changing hard fuel lines and they usually start sucking air past fittings when they get hard

    so three years ago I went to tygon on all of my ski's and have never had another...
  12. Replies
    18
    Views
    1,629

    Empty carbs will do this best way to work it is...

    Empty carbs will do this best way to work it is with a primer setup

    I have 2 1200's and if you rebuild the carbs this can happen

    it's not permanent but expected so get them full ( suck...
  13. mine do it when they aren't adjusted properly...

    mine do it when they aren't adjusted properly Like Chip stated

    I have 3 of them and they all have needed fine tuning
    also if the Idle rpm's are too high the bucket seems to hang
  14. SBT crank bearings have both pin locating holes...

    SBT crank bearings have both pin locating holes for either case in the bearing from what I have seen in person so they only need to stock one crank

    when I convert 1100 to 1200's I pull the pin...
  15. Agreed no aftermarket for these uses the thrust...

    Agreed
    no aftermarket for these uses the thrust washers from what I have seen
  16. Replies
    4
    Views
    1,089

    Agreed I do it all the time

    Agreed
    I do it all the time
  17. Replies
    8,911
    Views
    445,435

    http://www.greenhulk.net/forums/attachment.php?att...

    http://www.greenhulk.net/forums/attachment.php?attachmentid=116806&stc=1&d=1234537133

    I remember when My old metal wrist rocket broke and I was on the hunt for a new one ,, I couldn't find squat...
  18. Replies
    10
    Views
    3,932

    I have a few An Electric pt 109 The...

    I have a few

    An Electric pt 109
    The battleship blue destroyer electric
    a hull of some sort Electric

    A Traxxas electric dual motor name escapes Me

    and a Traxxas gasser that needs...
  19. Replies
    11
    Views
    1,090

    No way We can talk you in to Premix?

    No way We can talk you in to Premix?
  20. Replies
    22
    Views
    1,708

    Have a Happy Beerdart !!!

    Have a Happy Beerdart !!!
  21. Replies
    15
    Views
    1,696

    muriatic is nasty stuff be careful and even a...

    muriatic is nasty stuff be careful and even a sealed bottle stored in a shed can rust everything in site
    I would find something else like ducky or whatever
  22. Replies
    5
    Views
    810

    I run primers instead of chokes in all of my...

    I run primers instead of chokes in all of my ski's for that reason
  23. Replies
    5
    Views
    810

    what brand oil you run can play a role in the...

    what brand oil you run can play a role in the amount of smoke also
  24. post a pic of the piston tops this will tell us...

    post a pic of the piston tops this will tell us if it was lean
  25. Replies
    23
    Views
    3,765

    POL driveline pictures by radracingpics -...

    POL driveline pictures by radracingpics - Photobucket

    John's contact info http://rockcountyjetski.webs.com/contactme.htm

    I have revrse and trim on my old 92 SL fun to have
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4