Search

Type: Posts; User: Mockingee

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    9
    Views
    330

    Looks like he’s poked a hole in a plastic bag,...

    Looks like he’s poked a hole in a plastic bag, taped the cable into said hole, put some oil in the bag and then hung the whole works from a bungee cord.
  2. Replies
    2
    Views
    120

    I’m guessing engines like that for sale used are...

    I’m guessing engines like that for sale used are rare, and pricey.
  3. Before you decide to rebuild your engine, open up...

    Before you decide to rebuild your engine, open up the case and see if the crank bearings spun inside the case, enlarging the bearing bores. You want to know if you have a good case before you decide...
  4. Replies
    11
    Views
    512

    Makes sense. I’ve seen bent/broken rods but not...

    Makes sense. I’ve seen bent/broken rods but not cracked cylinders. Then again, I’ve not seen one of these flooded with water.
  5. Thanks HiPeRcO. Merry Christmas, Happy New Year...

    Thanks HiPeRcO. Merry Christmas, Happy New Year and all the best to everyone.
  6. Replies
    11
    Views
    512

    Right, I keep forgetting not everybody has Nova...

    Right, I keep forgetting not everybody has Nova Scotia temperatures. I wonder what caused everything to crack.

    As suggested above, a good used motor is probably your best option. Hopefully they’re...
  7. Replies
    11
    Views
    512

    Everything you describe sounds as if it froze...

    Everything you describe sounds as if it froze with everything full of water. I just canít figure out how thatís possible. As far as my experience goes, the water runs out when you pull it out of the...
  8. Replies
    11
    Views
    512

    My advice is pull the motor. If it has the damage...

    My advice is pull the motor. If it has the damage you described it’s bound to have more. I would inspect every part of that motor before putting it back together.
  9. The motors are basically the same. As u said, u...

    The motors are basically the same. As u said, u will have to change the heads, flywheel, stator, etc... I have heard that some DI motors don’t have a pulse nipple for the carb fuel pump but I can’t...
  10. There was a post a while back about a member...

    There was a post a while back about a member having a 505 in a FICHT ski. Going from memory, it would run but not charge. Also, who knows what damage may have been done in the long run.
  11. Replies
    13
    Views
    503

    Will a bad TPS cause a no spark condition? What...

    Will a bad TPS cause a no spark condition? What does it do with the TPS unplugged?
  12. Replies
    27
    Views
    872

    Hmm, my ignorance is showing once again. I...

    Hmm, my ignorance is showing once again. I thought that was done in the MFD.
  13. Replies
    27
    Views
    872

    This is all really cool and interesting. Before I...

    This is all really cool and interesting. Before I say more let me point out that I only have experience with my Genesis so my question might be a stupid one. Perhaps things are different on other...
  14. Replies
    13
    Views
    503

    Have you tried testing the fuel pressure on the...

    Have you tried testing the fuel pressure on the water as it’s acting up? Have you done the fuel pressure regulator reinforcement?
  15. Replies
    86
    Views
    3,642

    Jealous.

    Jealous.
  16. Replies
    50
    Views
    3,001

    If I were you, having already shelled out the $...

    If I were you, having already shelled out the $ for that sensor, I would either try to adapt it to the other end of the throttle shaft or offset it on the correct end of the throttle body and make a...
  17. Replies
    15
    Views
    852

    Wow, I had no idea this is so simple. I thought...

    Wow, I had no idea this is so simple. I thought there was precision machining involved. Maybe next time I rebuild my 1200, (hopefully many yrs down the road), I’ll give it a try.
  18. Replies
    47
    Views
    7,620

    Check to see if you can turn the engine by hand...

    Check to see if you can turn the engine by hand by grasping the drive coupler. With the spark plugs out it should turn freely.
  19. Replies
    50
    Views
    3,001

    After looking further it seems that sensor is...

    After looking further it seems that sensor is obsolete. Maybe this one could be made to work. This seems to be available for about $70. Voltages are slightly off but maybe close enough?

    Honeywell...
  20. Replies
    50
    Views
    3,001

    It looks to me as if Honeywell RPNS090AC1A21X...

    It looks to me as if Honeywell RPNS090AC1A21X could be adapted. It’s definitely not a drop in replacement part. I’m not sure if the housing would stand up or what the cost would be.
    ...
  21. Replies
    8
    Views
    361

    I’m no expert but that doesn’t look like lean...

    I’m no expert but that doesn’t look like lean burn to me. It looks as if something went though it. I would look very closely at the bottom rod bearing and crank bearings in that cylinder.
  22. Good, you’re ahead of the game on the fpr. Odd...

    Good, you’re ahead of the game on the fpr. Odd that it won’t rev. My Genesis does 5000 rpm with hardly any throttle. Does it feel as if it’s pulling hard or just feel as it would if you were to just...
  23. You should check compression in all three...

    You should check compression in all three cylinders and above all, do the fuel pressure regulator reinforcement.
  24. Replies
    50
    Views
    3,001

    I can’t find anything on Honeywell’s website that...

    I can’t find anything on Honeywell’s website that mentions this sensor being available in anything other than cw rotation. Granted I’m no expert so maybe I’m just overlooking it.
  25. Replies
    50
    Views
    3,001

    On the website it says high voltage cw and low...

    On the website it says high voltage cw and low voltage ccw. I’ll have to go look at mine but is that the wrong way for us?

    According to K447’s post above it seems so.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4