Search

Type: Posts; User: FXSlowKroozer

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    338

    You might pick up 1.5 mph.You can run stock...

    You might pick up 1.5 mph.You can run stock bottom end with bigger wheels just need better fuel.
  2. Replies
    9
    Views
    254

    Rideplate mods are always a must do especially on...

    Rideplate mods are always a must do especially on big skis like the FX.Gets the nose up of the ski out of the water and atleast a 2mph speed increase without having to touch the motor at all.When you...
  3. Similar testing was done years ago with and...

    Similar testing was done years ago with and without filters, velocity stacks, air scoops, different size elbows, etc and the results where always the same.The further away you got the intake end from...
  4. Thank you for sharing.Unfortunately we use to run...

    Thank you for sharing.Unfortunately we use to run similar short ram intakes many years ago and its not even close in comparison.Both of the setups I previously mentioned outperform it by 200 to 250...
  5. Front Storage Intake Vs Side Cowl Intake

    Anybody tested a front storage intake setup versus a side cowling in the same conditions BOTH without air filters ? I have a feeling the front compartment intake would turn more rpms but I would...
  6. Replies
    1
    Views
    379

    FS - Parts TTT

    TTT
  7. Replies
    18
    Views
    850

    That transom looks like it was sealed...

    That transom looks like it was sealed correctly.They use to leave a huge gap in the old skis but that hasnt been the case for a bit.That stuff is a nightmare to get off completely and if you just...
  8. Replies
    2
    Views
    275

    over 30 psi or 600 hp ish is usually where guys...

    over 30 psi or 600 hp ish is usually where guys start breaking things but the guys boosting that high are mostly in a racing environment.On recreationally used skis a stock motor with a spring kit,...
  9. Replies
    43
    Views
    2,988

    The SHO exhaust manifolds locate the sensor...

    The SHO exhaust manifolds locate the sensor further away from the waterbox keeping them a little drier.As far as the O2 adapter gasket that shouldnt be an issue if it was installed correctly.I would...
  10. For what your trying to do a Stock intercooler...

    For what your trying to do a Stock intercooler with a BOV IMO.
  11. Replies
    37
    Views
    3,694

    There are alot of variables but I can tell you if...

    There are alot of variables but I can tell you if you do any kind of holeshots, wave jumping, closed course, or really rough riding it wont matter what boost wheel it is your going to eat through...
  12. The thin diffuser vanes and straighter taper...

    The thin diffuser vanes and straighter taper profile lead me to believe it started life as an XLT 3 degree nozzle 87mm nozzle.
  13. Replies
    43
    Views
    2,988

    If your still running a stock waterbox and...

    If your still running a stock waterbox and restricting water doesnt work try pulling the exhaust manifold at the head and makesure you dont have an upstream gasket leak.You will sometimes get one mid...
  14. Replies
    8
    Views
    358

    Usually bad throttle bodies are either frozen...

    Usually bad throttle bodies are either frozen shut or throw out codes but being stuck right at 45 sounds like no boost or a misfire honestly.Make sure the ski isnt in learners mode or that the...
  15. Replies
    1
    Views
    379

    FS - Parts Fzr fzs fx sho ho svho misc parts

    Too many pictures to upload them all.If seriously interested do not respond to this thread.Personal Message is best.Thank you

    SVHO Intake manifold with Ribbon intact $180shipped

    SVHO Upper...
  16. Replies
    9
    Views
    534

    WTB Wish I would have seen this sooner as I just...

    Wish I would have seen this sooner as I just parted with a spare I had.Be warned market value for these is really up there right now and your almost better off buying a whole ski to pull one...
  17. Replies
    6
    Views
    552

    Its 2+ mph loss with that pump and your average...

    Its 2+ mph loss with that pump and your average rider cares too much about top speed to spend money on going slower.The few who actually care enough about hole shot to sacrifice top speed will have...
  18. FS - Parts I am glad others are taking notice of this...

    I am glad others are taking notice of this problem but unfortunately reporting one user does absolutely nothing.This is because the scammers on this forum go by atleast a dozen different usernames...
  19. WTB - Parts Wtb 08 - 11 sho oil pump gear retainer plate

    WTB a gear retainer plate for an 08 - 11 SHO Oil pump that is not rotted out.Not looking to buy an entire oil pump just the front plate only.PM is best.Thank you
  20. Replies
    33
    Views
    3,197

    Was one of the nicest guys around.My condolences...

    Was one of the nicest guys around.My condolences RIP
  21. Replies
    13
    Views
    1,221

    The old style SHO exhaust manifold that mounts...

    The old style SHO exhaust manifold that mounts the O2 upstream is the best way.They sell an adapter that goes on the end of the new style SVHO exhaust manifold but the sensor mounts further...
  22. Replies
    4
    Views
    214

    Even if you keep a ski otherwise stock the single...

    Even if you keep a ski otherwise stock the single best mod you can do is a tune.Your going to pick up power everywhere adding timing and lifting the rev limiter its %100 worth it
  23. Replies
    22
    Views
    891

    The actual fuel system for E85 on a high powered...

    The actual fuel system for E85 on a high powered ski is probably one of the biggest headaches.The stock charging system drops voltage at wide open and the stock battery is not designed to support a...
  24. In my experience anything over 2 years begins to...

    In my experience anything over 2 years begins to be borrowed time on an intercooler. Regardless of the vendor an aluminum core is going to rot out sooner than later if you use it in the salt.We have...
  25. Replies
    5
    Views
    313

    You can mount them on any plastics on the ski but...

    You can mount them on any plastics on the ski but you need to make sure to seal the face and rear harness of the gauge with silicone or humidity is going to ruin them very fast
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4