Search

Type: Posts; User: molemansd

Search: Search took 0.00 seconds.

  1. Emm repair

    What do you charge to diagnose an emm?
  2. So I took resistance readings from stator and got...

    So I took resistance readings from stator and got all good readings. I took off the cover and here are some photos. It appears the plastic ends of three coils are broken. Any ideas how this could...
  3. I also checked the resistance on the newly...

    I also checked the resistance on the newly installed stator. Each reading just zeros out. No reading. Does that make sense???
  4. I stuck a couple paper clips in and tested each...

    I stuck a couple paper clips in and tested each one. The multimeter registered a trickle of power , like .05 volts to each injector. I did not manually inject any more fuel to the cylinders so...
  5. Both fuel pump and stator are aftermarket. I...

    Both fuel pump and stator are aftermarket. I have posted information with this reply. The EMM was rebuilt by Harris at Ficht EMM Repair in Tennessee. It didn’t work the first time and I had to send...
  6. I tried cleaning the plugs and even bought new...

    I tried cleaning the plugs and even bought new ones. And the ski doesn’t start. I did a compression test and am getting about 140, 150 and 150psi. A local jetski mechanic told me that a broken...
  7. Will go and get a compression test kit. In the...

    Will go and get a compression test kit. In the meantime, it appears the oil pump did go wide open as it is still on a spring. I pulled the plugs and they don’t appear to look good. They were brand...
  8. 2002 Kawasaki 1100 STX DI Broken Oil Pump Throttle Control Cable

    Recently replaced fuel pump, had the emm rebuilt and replaced the stator. Had it out for the first time today. It ran fine for a long while then engine died and wouldn’t restart. It was trying to...
  9. Thanks. I found the washer and didn’t understand...

    Thanks. I found the washer and didn’t understand it went there. Glad you chimed in On this thread! What cooling system mods are you referring to? Are the oil pump bearings a difficult...
  10. 2002 Kawasaki 1100 STX DI - Spring Found When Replacing Stator

    I am replacing the stator in the ski with the engine in. I removed the magneto flywheel cover and put the new stator in. At one point I looked down and found a spring about ˝” in diameter and about...
  11. Thanks. Going to the link to review.

    Thanks. Going to the link to review.
  12. Okay. So I sent the EMM back to be looked at...

    Okay. So I sent the EMM back to be looked at again. He said that he found one solder joint that needed to be redone. I got the EMM back, put it in the ski and it fired right up! I took it ou and...
  13. Update below. Additional help needed. Thanks!

    Update below. Additional help needed. Thanks!
  14. How much would you charge to check it over and...

    How much would you charge to check it over and refurbish it...if needed?
  15. I already sent it out to him before I saw this. ...

    I already sent it out to him before I saw this. What should I be worried about? I might be able to have UPS return it. I just don't want to spend another $500-$600 for someone else to fix when...
  16. I spoke to the guy at FICHT EMM REPAIR. He said...

    I spoke to the guy at FICHT EMM REPAIR. He said to send the EMM back to him again. He thinks some of the solder didn't stick due to some of the gel residue still being on the board.
  17. I spoke to the tech today at Ficht EMM Repair. He...

    I spoke to the tech today at Ficht EMM Repair. He stated it was working when it left. He had me do the ohm test on the stator because I didn't have a spark at the time. After I got it to spark I told...
  18. I just asked the same on the 2-stroke section. ...

    I just asked the same on the 2-stroke section. I'm going to email the moderators
  19. Ficht EMM Repair out of TN

    Ficht EMM Repair out of TN
  20. I spoke to the tech today at Ficht EMM Repair. ...

    I spoke to the tech today at Ficht EMM Repair. He stated it was working when it left. He had me do the ohm test on the stator because I didn't have a spark at the time. After I got it to spark I...
  21. 2002 Kawasaki 1100 STX DI Sputters, Pops/Backfires when trying to start. DOESNT START

    Engine not starting. EMM was just rebuilt. Fuel pump working.

    Replaced the sparkplugs with NGK PZFR7G-G. Prior plugs seem to have some black carbon on them

    When trying to start it cranks,...
  22. 2002 Kawasaki 1100 STX DI Sputters, Pops/Backfires when trying to start. DOESNT START

    Engine not starting. EMM was just rebuilt. Fuel pump working.

    Replaced the sparkplugs with NGK PZFR7G-G. Prior plugs seem to have some black carbon on them

    When trying to start it cranks,...
Results 1 to 22 of 22