Search

Type: Posts; User: nmpeter

Page 1 of 8 1 2 3 4

Search: Search took 2.05 seconds.

  1. Replies
    35
    Views
    387

    spend some time reading all my forum threads or...

    spend some time reading all my forum threads or threads related directly to your particular issue, you'll find these topics covered in depth. The search engine hree is quite good

    no reason a rinse...
  2. obvious: channel locks wielded by the invasive...

    obvious:

    channel locks wielded by the invasive species asshatitus mechanicus

    beware of other telltale signs, like plastic zip ties cut into daggers and aquarium air line used for primers
    ...
  3. Replies
    35
    Views
    387

    the kawasaki OEM mesh filter is good for now, you...

    the kawasaki OEM mesh filter is good for now, you can backwash it with some fresh gas and lots of agitiation until its clear. There are plenty of alternative nylon mesh filters on the market but the...
  4. Depends on the shop but I would typically charge...

    Depends on the shop but I would typically charge about 1.25 hrs labor on something like this depending on the amount of asshattety I run into(like soda draw nozzle bushings, damaged tail cones, dime...
  5. Replies
    35
    Views
    387

    View Post

    I’ve seen that funk before

    Little know fact but I’ve mentioned it before

    Some two stroke oils can allow the growth of bacteria if allowed to sit

    I assume the PO added some injector oil to...
  6. you'll want to replace the clamps for the bellows...

    you'll want to replace the clamps for the bellows as well. the "norma" type clams are strongly suggested. While pricey, OEM parts are suggested for this particular fix. Don't get any lubricant on the...
  7. Replies
    3
    Views
    135

    sorry, but I had to laugh a little, that mistake...

    sorry, but I had to laugh a little, that mistake goes all the way back to my first year in business here.

    I played the Legend of Poseidon scam on a trio of guys who just had one of the worst days...
  8. Replies
    4
    Views
    117

    check the ecu connector for a pin pushed in. ...

    check the ecu connector for a pin pushed in.

    that sucks
  9. Replies
    10
    Views
    257

    a quality engine rebuild is going to cost more...

    a quality engine rebuild is going to cost more then the skis are worth.

    The only upside of an sbt motor is the warranty. Sure there is alot of bitching, but that;s mostly do in my opinion to...
  10. Replies
    1
    Views
    99

    Welcome aboard. anytime raw fiberglass is...

    Welcome aboard.

    anytime raw fiberglass is exposed it should be repaired quickly.

    gelcoat repair kits are inexpesive and easy to use with just a little practice

    ignore this damage will lead...
  11. Replies
    4
    Views
    95

    in regards to inspection... pull the pump cone...

    in regards to inspection...

    pull the pump cone to check for water is suggest every 50 hour/seasonally especially if you pull water skiers or tubes, ride exceptionally hard
    pulling the pump and...
  12. Replies
    35
    Views
    387

    God work all around And now for the snake oil...

    God work all around

    And now for the snake oil because...

    You -might- have a sticky ring

    One tablespoon of marvel mystery oil into the low jug with the piston at TDC

    Let it sit 24 hours
  13. Replies
    35
    Views
    387

    frankly I'd be hesitant to beat on the ski much...

    frankly I'd be hesitant to beat on the ski much until you confirm a nice brown color on the plugs on a short run, that' a bigger concern then low compression, which is worrisome, but still in what...
  14. Replies
    35
    Views
    387

    Im not a big fan of snake oil, but opinions vary...

    Im not a big fan of snake oil, but opinions vary

    a low battery invalidates your compression test for any serious considerations. try again with a fully charged battery

    IF there is a problem...
  15. Replies
    35
    Views
    387

    put a teaspoon of two stroke oil into the low...

    put a teaspoon of two stroke oil into the low cylinder and retake the compression( twice), that will give you an idea if the jug is really bad or the ring is just sticky from running with...
  16. the electric gizo is a water injector for the...

    the electric gizo is a water injector for the exhaust

    I recall ( it's been a while and I'm getting kinda old now) that a low oil level would trigger a check engine, but the issue comes from a bad...
  17. Replies
    128
    Views
    15,733

    View Post

    A stuck trim motor wouldn’t even qualify her for its basic book value which is about 2300 put in a $700 value on the 4K (haha) engine rebuild and 500 for the trailer which is most generous...
  18. View Post

    I’d post the classic my cousin Vinny “calibrating the torque wrench” video here but you guys of seen it plenty of times

    But hey Marisa.....
  19. View Post

    I’ve stocked both versions of the Deka 16 as on a couple of skis the cables are very short due to trim age of cables and you must use an L model

    It’s a trap for the careless and I once came...
  20. welcome aboard if you sniff around the K447...

    welcome aboard

    if you sniff around the K447 polaris tech pages ( see signature link) an find information on how to use a 12v LED to read the actual error code

    for now, check that the battery is...
  21. Replies
    83,073
    Views
    5,792,237

    I won't forget the hurricanes for sure, Andrew...

    I won't forget the hurricanes for sure, Andrew destroyed my condo in homestead back when the town was nothing but double wides and advacado packing houses.

    when I looked to get out of NYC for a...
  22. Replies
    2
    Views
    143

    my go to for buggered threads in aluminum ...

    my go to for buggered threads in aluminum

    https://www.aluminumrepair.com/thread-repair/

    be warned, it ain't cheap and good for use on tragic and hard to replace parts, like obsolete italiano...
  23. title. My state is getting more involved in...

    title. My state is getting more involved in checking engine numbers these days, especially on older units. We already do it on out of state transfers. No inspection, no title transfer..and the...
  24. Replies
    37
    Views
    13,497

    Sticky: using a stainless wear ring is like marrying a...

    using a stainless wear ring is like marrying a well endowed gal, there are downsides and upsides to consider

    if there was a free lunch in jetpumps, I'd be first in line when the buffet opens

    I...
  25. Sticky: you want to absolutely replace the bolts, they...

    you want to absolutely replace the bolts, they are inexpensive. Consider them insurance against having to go in there again for a good long time. Be careful with the timing wheel, the large magnet...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4