Search

Type: Posts; User: svhokid

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. these engine run rich with type 14. dont waste...

    these engine run rich with type 14. dont waste your time. put a fizzle on it and forget about it
  2. start at 52 psi. a/f should be high 11s- low 12s...

    start at 52 psi. a/f should be high 11s- low 12s like 11.8-12.2 at WOT. also long as its good up top at wot dont worry about idle or crusing
  3. Thread: Lunajet Clutch

    by svhokid
    Replies
    2
    Views
    536

    best bet would be the CR clutch from deans team....

    best bet would be the CR clutch from deans team. i had a lumajet and when it blew it caused nothing but headaches to clean all the debre out of the sump
  4. Replies
    82
    Views
    4,173

    View Post

    What map sensor are you running? If itís the Riva on inspect the wires near the plugs I found mine chaffed and grounding out.
  5. Thread: Mxt-l

    by svhokid
    Replies
    4
    Views
    409

    I run mine while using the ski then take out when...

    I run mine while using the ski then take out when not using the ski. Had an AEM guage and I went thru 4 sensors last season. Switched to the innovate and haven’t had an issue yet
  6. Thread: 2014 fzr trim

    by svhokid
    Replies
    4
    Views
    487

    trim down until your on plane then trim in the...

    trim down until your on plane then trim in the middle or higher after on plane
  7. Replies
    11
    Views
    1,292

    FS - Parts cams changed as far as the gear i believe in...

    cams changed as far as the gear i believe in 2013. so up until 2015 you can use this cam+ gear setup. the gears cannot be swapped on pre- 2013 year cams. i did not know this when i purchased
  8. Replies
    11
    Views
    1,292

    FS - Parts will take better pics when i get home....

    will take better pics when i get home.
    interested?
  9. Replies
    11
    Views
    1,292

    FS - Parts vxr cams for 15' and under svho or sho

    like the title says. cams are for a 2015 or older svho/ sho engine
    i bought them not knowing the year and they will not work on my 16' svho

    500$ including shipping
    ...
  10. Replies
    12
    Views
    1,840

    Must have your prop pitched wrong

    Must have your prop pitched wrong
  11. Replies
    12
    Views
    1,840

    anything will help. Did he have it setup to run...

    anything will help. Did he have it setup to run rising rate or static?
  12. Replies
    12
    Views
    1,840

    R&D

    R&D
  13. Replies
    12
    Views
    1,840

    i am running just over 90 now with out the cams....

    i am running just over 90 now with out the cams. also on a twin prop. going to try a single prop once i get the engine dialed in . hopefully ill be in the mid 90s
  14. Replies
    12
    Views
    1,840

    svho et19, vxr cams

    what tune are you guys running with this setup
    ET19
    ID 1000s
    Fizzle
    VXR cams
    4 bar map sensor
    retainers

    currently running a deans tune @9800 limit minus the cams
    just bought cams and seeing...
  15. Replies
    8
    Views
    6,642

    theres the answer im looking for. thanks

    theres the answer im looking for. thanks
  16. Replies
    8
    Views
    6,642

    NanoXcel 2 hull repair, what to use?

    what should i use to fix this hull. caused by using a not properly set up trailer. this happened on both my fzr and gp. both hulls are nano2.

    dont really care about matching a color. just want to...
  17. Replies
    0
    Views
    276

    WTB WTB 2013+ FZR/S hull

    as title says want to buy 2013+ fzr/s hull
  18. aermotive 340 lph. can be bought in alot of...

    aermotive 340 lph. can be bought in alot of online stores about $150. i ran the riva tank kit along with there cartrage filter. See here...
  19. Replies
    16
    Views
    1,152

    ya i straight piped mine and one ride the o2...

    ya i straight piped mine and one ride the o2 sensor shorted. even with the water box i always keep a spare sensor close by. too cheap of a part to fail and cause an improper reading then your engine...
  20. Replies
    67
    Views
    25,386

    gp intake grate mounts should be reinforced at...

    gp intake grate mounts should be reinforced at them speeds
  21. Replies
    67
    Views
    25,386

    cut the wire bring to weld shop and have a plate...

    cut the wire bring to weld shop and have a plate welded over the hole. candoo gps for speedo
  22. Replies
    67
    Views
    25,386

    scom, shim plates removed from deans cut ride...

    scom, shim plates removed from deans cut ride plate, kanaflex to charger
  23. Replies
    67
    Views
    25,386

    i have both skis and the gp is deffinetly a...

    i have both skis and the gp is deffinetly a better ride in chop. speed of the fz hull is unmatched. granted my fz is heavily modded but when it was stock with scom id say they both ran just under 75...
  24. Replies
    45
    Views
    5,356

    im running a et19, 1000 cc injectors spinning up...

    im running a et19, 1000 cc injectors spinning up to 9600 rpm on a 15' fzr. still gets better fuel usage than all my buddys stock/ lightly modded 300s
  25. any dirtbike grip will work. use the dirtbike...

    any dirtbike grip will work. use the dirtbike throttle grip on the trim side. just have cut them a little shorter to get them to fit.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4