Search

Type: Posts; User: speedskixp

Page 1 of 8 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    4
    Views
    1,150

    SOLD Ttt

    Ttt
  2. if that hole isnt there you womt have barely...

    if that hole isnt there you womt have barely anything venting through the tops breather. Should be easy to tell by pulling the hose off the tops and see if any steam or smoke are blowing out when...
  3. Hopefully the cases on that used engine are...

    Hopefully the cases on that used engine are actually 07 and not 05 or earlier. 05 and earlier are missing the vent hole in the rear of the case behind the balance shaft. Have you tried relieving...
  4. What year is the new engine and the ski it is in...

    What year is the new engine and the ski it is in now?
  5. As mentioned, it sounds like you are having a...

    As mentioned, it sounds like you are having a venting issue. Double check Tops isn't stuck. What all was replaced during rebuild? Original engine cases, head, rocker shaft?
  6. Just bite the bullet and pull the pto. You've got...

    Just bite the bullet and pull the pto. You've got your mag cup/trigger installed wrong and crank pin isn't lined up with correct hole. I'm sure your alignment pin is partially covered by the trigger...
  7. Thread: riva ecu

    by speedskixp
    Replies
    14
    Views
    2,037

    WTB I have an 07-11 also.

    I have an 07-11 also.
  8. Replies
    4
    Views
    1,150

    SOLD Bump

    Bump
  9. Replies
    4
    Views
    1,150

    SOLD Ttt

    Ttt
  10. Replies
    4
    Views
    542

    WTB They are the same. I have one for sale in the...

    They are the same. I have one for sale in the classifieds. Pm if interested.
  11. Replies
    4
    Views
    1,150

    SOLD Cases are a clean 05 matching pair but will need...

    Cases are a clean 05 matching pair but will need to be bored one size over to be perfect. Will work with all years by simply drilling a 12mm vent hole for 06+ $650 .
    Cylinder head is a bare 05 with...
  12. FS Make offer.

    Make offer.
  13. Replies
    11
    Views
    1,356

    Seems like a major downgrade but I'm sure you...

    Seems like a major downgrade but I'm sure you have your reasons.
    As for your question.
    After determining where the need to be and building a good base I would finish by glassing over a 3/8"...
  14. Replies
    21
    Views
    1,772

    Depends on the circumstances . IMO it depends on...

    Depends on the circumstances . IMO it depends on kids behavior and amount of chores they help with.
  15. Replies
    12
    Views
    1,462

    FS - Parts He needs an 07+ rxp or rxpx harness for siemens...

    He needs an 07+ rxp or rxpx harness for siemens ecu. Not sure what year ski he is installing it in but if 06 or earlier an 07 harness would be easiest for direct plug into fuel pump and voltage reg.
  16. Replies
    5
    Views
    1,140

    FS TTT

    TTT
  17. This is true. Although I do ride mostly smooth...

    This is true. Although I do ride mostly smooth water I do occasionally ride some rough stuff but throttle control goes a long way. Its not the 9000 rpms that will get you its the over rev from coming...
  18. You will be fine with just a riva spring and...

    You will be fine with just a riva spring and retainer upgrade as long as you have the newer style valves. I have ran this set-up to 9100 rpms on a few ski's including the one I have now. Well over a...
  19. Replies
    5
    Views
    1,140

    FS With ported head around 17.5 @8900. Would be a...

    With ported head around 17.5 @8900. Would be a little higher on stock flowing head.
  20. Replies
    5
    Views
    1,140

    FS ET 70-145 race charger

    Sold!
  21. Replies
    144
    Views
    11,015

    I don't think he has that much more condensation...

    :smt067:smt021:smt075:smt070](*,)](*,)[/QUOTE]

    Ferrari Steve makes a valid point...He wants to know from the professionals what is causing and why Sean is getting so much more condensation than...
  22. +1. Without a doubt these IC's do not leak. We...

    +1.
    Without a doubt these IC's do not leak. We tested these the way I have always tested my coolers. These coolers were pressurized with 100psi of air with a pressure gauge on the outlet while...
  23. Replies
    3
    Views
    620

    Great tool. Ive had one similar to that for a few...

    Great tool. Ive had one similar to that for a few years. Comes in real handy for swapping clutch washers.
  24. Replies
    80
    Views
    10,185

    Wow! Hope you were wearing your helmet.

    Wow! Hope you were wearing your helmet.
  25. Replies
    19
    Views
    2,297

    FS Ski is 05

    Ski is 05
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4