Search

Page 1 of 9 1 2 3 4

Search: Search took 1.00 seconds.

  1. Cover on Trixx hard to get on. Simple fix

    Not sure if this has been posted, but if you have a trixx with the Seadoo cover, you know how hard it can be to get the cover over the handlebars. I have even seen covers torn and rubber ripped off...
  2. As nmpeter said, put and oil pressure gauge on it...

    As nmpeter said, put and oil pressure gauge on it and ride it. Sure the dealer checked the pressure in the shop, but did he water test it with the gauge.
    Im agreeing with nmpeter, the regulator is...
  3. Replies
    9
    Views
    741

    Agreed, all marketing, no product. Looks like a...

    Agreed, all marketing, no product. Looks like a fast barge, no fun.
  4. Looks like a post and ghost again.

    Looks like a post and ghost again.
  5. Replies
    112
    Views
    14,342

    What happened to Greenhulk's anual review of the...

    What happened to Greenhulk's anual review of the new Seadoo's? Gone all Yamaha now? Or did I just miss it?
  6. Replies
    9
    Views
    449

    Pull the heads at this point, see what the...

    Pull the heads at this point, see what the cylinders and pistons look like
  7. Replies
    6
    Views
    652

    For the numbers to mean anything you need to...

    For the numbers to mean anything you need to baseline dyno that engine before the mods were done to know what you were starting off with. Sure its called a 300, but maybe it made 280 or 290 stock,...
  8. Replies
    30
    Views
    2,021

    Looks like your counterbalancer gear is off a...

    Looks like your counterbalancer gear is off a tooth too. Dots are off a tooth
  9. Replies
    30
    Views
    2,021

    Those holes in the airbox are from a Skiworx mod....

    Those holes in the airbox are from a Skiworx mod. They will cause it to run lean, plug them.
  10. No point in the tripple bearing setup on a 2002....

    No point in the tripple bearing setup on a 2002. Now there was a seal upgrade that added and extra shaft seal which is far ore important thant the tripple bearing. Keep the water out and the bearing...
  11. Replies
    6
    Views
    761

    Your right, When Im cruising with my "old" 2004...

    Your right, When Im cruising with my "old" 2004 RXP and new ski's with "brats" on it blow by way too close, I usually pull up beside them and wave bye as i pull away.
    Yep , someone is always...
  12. First crank, hold it a WOT so it won't start, but...

    First crank, hold it a WOT so it won't start, but it will pump some oil to the bearings, they will be dry after sitting this long.
    Do a good visual inspection, be sure no corrosion on wires or...
  13. SC should not spin at all, other than gear lash. ...

    SC should not spin at all, other than gear lash. Sounds like it slipping too much
  14. Replies
    43
    Views
    2,216

    With the candoo connected and ski on but not...

    With the candoo connected and ski on but not running. Can it display the Throttle Position? I think it does in a % number.
    Does it keep working going form a low percent to high as you move the...
  15. Replies
    3
    Views
    475

    If it pressure tested fine, no oil in coolant or...

    If it pressure tested fine, no oil in coolant or coolant in oil, and its not dropping then I would not worry, its just the paint or what ever the black stuff is on the gasket flaking off a bit.
  16. Replies
    2
    Views
    285

    Unless you need coils, stock is perfectly fine. ...

    Unless you need coils, stock is perfectly fine. No beinfit in aftermarket stuff
  17. Not a problem, but you do need to put the nose...

    Not a problem, but you do need to put the nose cone back on. It looks like it is untreading and could travel up the shaft
  18. Send it? with no water showing at pisser? No,...

    Send it? with no water showing at pisser?

    No, you need to find out why your pisser is not showing water. It located on the starboard side (right) just ahead of the foot well.
    If thats working,...
  19. Replies
    20
    Views
    1,658

    Let see, 600 to 800Volts , yep that will work...

    Let see, 600 to 800Volts , yep that will work great on water! Wipe out on a gas ski, you get a bruse or sprain and a little swim back to the machine. Wipe out on an electic ski and you may survive...
  20. Replies
    26
    Views
    2,761

    Whats going on in the middle cylinder? Is that a...

    Whats going on in the middle cylinder? Is that a gap to the left of the piston or just a camera reflection (I hope its a reflection).

    Edit, I see, its just liquid sitting on the piston. Never...
  21. Which is faster? Nothing can catch this!!! No...

    Which is faster? Nothing can catch this!!! No SeaDoo, No Yamaha!
    Look how the tech has changed.
  22. Replies
    6
    Views
    806

    And what year 800SXR is it? the made them for...

    And what year 800SXR is it? the made them for many years.The 800 stock is a fast machine. For a first time standup its a lot of performance. That modified machine, well, i would think for beginner,...
  23. Probably a post and ghost! Sadly.

    Probably a post and ghost! Sadly.
  24. Replies
    6
    Views
    930

    Maybe the intake manifold cracked if it...

    Maybe the intake manifold cracked if it backfired. May have split it along the seam.
  25. Replies
    39
    Views
    7,030

    Just to clear some things up about how the...

    Just to clear some things up about how the bellows and carbon seal work.
    #1, a soft Bellows will not cause the ski to sink, Heat fron running the engine onland will not hurt the bellows (unless it's...
Results 1 to 25 of 206
Page 1 of 9 1 2 3 4