Search

Type: Posts; User: Teejay22

Search: Search took 0.00 seconds.

  1. Replies
    66
    Views
    4,755

    I have a brand new waveater clip set and d-plate...

    I have a brand new waveater clip set and d-plate that I purchased for my rebuild, only to find out it already had a d-plate and the SBT PV's. I'll give you a deal on them if you're interested in...
  2. Replies
    74
    Views
    37,546

    Sticky: For the life of me, I could not get the sending...

    For the life of me, I could not get the sending unit to budge. I could rotate it a little here and there, but could not find anyway to get any leverage to pull the unit out. VERY STUCK. Any tips on...
  3. Sounds good. I will check both. I was planning on...

    Sounds good. I will check both. I was planning on just leaving the stock jetting/stock airbox/etc.

    Going to build a popoff tester as well for when I get the carbs back out.

    Any thoughts on...
  4. We'll go through the carbs again. Is this the...

    We'll go through the carbs again.

    Is this the info you are referring to?
    http://www.greenhulk.net/forums/showthread.php?t=70129 This doesn't look like it is for stock setup though?

    Or this...
  5. Yes they were rebuilt with mikuni kits. I found...

    Yes they were rebuilt with mikuni kits. I found out that he didn't drill holes to adjust the pins...does that need to be done? I guess they thought if they were leaving stock they didn't need to do...
  6. Should I attempt to pull the plug wires and test...

    Should I attempt to pull the plug wires and test them with an ohm meter?
  7. Compression numbers below. Also attaching a video...

    Compression numbers below. Also attaching a video of the spark of each cylinder (slow motion). #3 seems a little slow and off of when it should be firing.

    360325


    https://youtu.be/53w2pmoNd74
  8. I bought it with the blown motor from the oil...

    Why did you replace the original motor? What caused it to fail? Did you repair what caused the previous failure?[/QUOTE]

    I bought it with the blown motor from the oil lines coming off of cylinders...
  9. 2001 XLT 1200 rebuilt - issues after 1st hour of running - bogging down, misfires

    Just had the engine rebuilt and put back in the ski. (Premix, d-plate, already had SBT improved PV so it didn't need the waveater clips, carbs rebuilt, new reeds,etc). I had purchased a D-Plate and...
  10. Replies
    302
    Views
    172,694

    Sticky: Passed away??

    Oside bill has passed away. Try wfo on here[/QUOTE]

    Passed away??
Results 1 to 10 of 10