Search

Page 1 of 16 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    1
    Views
    47

    Have you checked the engine end of the negative...

    Have you checked the engine end of the negative battery cable? Corrosion there could affect cranking speed.

    After that, start solenoid, cable to starter motor (corrosion at either end?) or the...
  2. Replies
    2
    Views
    70

    You can use a standard marine fuel gauge (33 ohm...

    You can use a standard marine fuel gauge (33 ohm to 240 ohm sender resistance range), BUT the fuel gauge you use must limit the voltage going to the actual fuel sender unit to only a couple of volts...
  3. Replies
    13
    Views
    141

    Welcome. I would suspect the EMM needs repair....

    Welcome.

    I would suspect the EMM needs repair.

    There are some additional diagnostics you can do before sending the EMM out for repair, but I would not be surprised if the EMM has failed.
    ...
  4. Replies
    7
    Views
    147

    Which grease system does the axle (zerk fitting)...

    Which grease system does the axle (zerk fitting) have?
    Where does the ‘old’ grease exit when fresh grease is pumped in?

    Some torsion axles dump the old grease out the back side of the swing arm...
  5. What range was your meter set to for AC volts? I...

    What range was your meter set to for AC volts? I would be expecting readings in the many volts ranges, not fractional numbers under 1.00 volts AC.

    Or the meter probes were not making solid contact...
  6. Thread: Changing bunks

    by K447
    Replies
    24
    Views
    501

    Yes, but one must be careful. I sometimes...

    Yes, but one must be careful.

    I sometimes adjust the bunks while ski is on trailer. Bow roller supporting the bow, winch strap tight. Hydraulic jack under the watercraft ride plate (centered),...
  7. Wondering if the flywheel is rotated out of time,...

    Wondering if the flywheel is rotated out of time, with a sheared woodruff key.
  8. Replies
    28
    Views
    3,490

    Be careful.

    Be careful.
  9. Replies
    3
    Views
    185

    This thread should be helpful. ...

    This thread should be helpful.

    http://greenhulk.net/forums/showthread.php?t=284841&p=3063615&viewfull=1#post3063615
  10. Replies
    7
    Views
    328

    And your thread received helpful replies. ...

    And your thread received helpful replies.

    http://greenhulk.net/forums/showthread.php?t=287258&p=3082530&viewfull=1#post3082530
  11. Welcome. What diagnostics have you done? ...

    Welcome.

    What diagnostics have you done?

    Cylinder compression?


    http://polarispwcknowledge.shorturl.com/first-things-to-do
  12. Replies
    143
    Views
    7,602

    My post was not to resolve every, or even most,...

    My post was not to resolve every, or even most, points of confusion in this thread. Merely to focus on the direct relationship between RPM and hull speed.

    The hull and the water do not care, at...
  13. Thread: HRs to Miles

    by K447
    Replies
    21
    Views
    753

    Supercharged engine or non-supercharged? ...

    Supercharged engine or non-supercharged?

    General theme seems to be that hundreds of running hours, perhaps well over one thousand running hours, is not surprising for a non-supercharged current...
  14. Replies
    3
    Views
    211

    WTB When viewing the private message there is a...

    When viewing the private message there is a button to report the message to moderators. Include your concerns about the message in the report.

    Zero post members should not be offering items for...
  15. Replies
    68
    Views
    1,870

    Yep. Reinforcing the OEM fuel pressure regulator...

    Yep. Reinforcing the OEM fuel pressure regulator inside the Polaris Ficht fuel pump is not optional, and not a repair to be deferred.
  16. Replies
    15
    Views
    1,639

    If having passenger weight on the back seat...

    If having passenger weight on the back seat aggravates the porpoising effect, moving your cooler weight from the front to the back seems unlikely to make things 'better'.

    You need to get the hull...
  17. Replies
    4
    Views
    175

    Don't forget to buy a replacement fuse to replace...

    Don't forget to buy a replacement fuse to replace the spare you used.

    Tip: Mark the positive battery terminal with red tape or paint.


    ...
  18. Replies
    6
    Views
    224

    What will keep the 3 inch wide U-bolts and...

    What will keep the 3 inch wide U-bolts and related bottom brackets from bending and flexing around the smaller 2” square tongue beam?

    What will keep everything aligned?

    Whatever you cobble...
  19. Sticky: Lakeside Technology repair service for Polaris Ficht EMM repair

    I have taken the liberty of revising the thread title to reflect my own perspective and the feedback of many members who have used Lakeside Tech for EMM repair.

    Darrin is simply doing a fantastic...
  20. Replies
    12
    Views
    580

    Talk to this guy...

    Talk to this guy about EMM sourcing.

    http://www.greenhulk.net/forums/showthread.php?t=268057&p=2917494&viewfull=1#post2917494


    I suggest buying an EMM that has already been fully vetted and...
  21. Replies
    68
    Views
    9,638

    Fourty Two thousand ...

    463141

    Well, at least my signature links are still useful :)

    http://polarispwcknowledge.shorturl.com/first-things-to-do
  22. Replies
    10
    Views
    394

    I have encountered more than once someone who...

    I have encountered more than once someone who uses the ‘turn over’ phrase to mean the engine actually started.

    And ‘would not turn over’ to mean the engine cranked but did not actually start....
  23. View Post

    I carry several 25 foot ‘boat size’ dock lines that are thick enough to be used as tow ropes. 3/8” or 7/16” braided ropes with a factory loop formed in one end.

    Several of these ‘dock lines’ *...
  24. Replies
    56
    Views
    4,192

    View Post

    Tip: Rather than reusing the Stock GP1800 ‘OEM size’ hull inserts, consider upgrading to the larger Yamaha hull inserts. GH store sells them for exactly this purpose - reinforcing the GP1800 intake...
  25. Replies
    5
    Views
    333

    How you looked around the engine and wiring...

    How you looked around the engine and wiring harness for possible damage?

    Rodent chewed wires, something unplugged or a connector slightly not quite snapped together, that sort of thing.
Results 1 to 25 of 400
Page 1 of 16 1 2 3 4