Search

Type: Posts; User: K447

Page 1 of 8 1 2 3 4

Search: Search took 0.33 seconds; generated 30 minute(s) ago.

  1. Replies
    27
    Views
    497

    So just buy the whole kit, MaptunerX unit, cables...

    So just buy the whole kit, MaptunerX unit, cables and tune license. By the time you have done the ten hour service it will be there.

    Install the tune, experiment, decide what is best for you.
    ...
  2. Replies
    27
    Views
    497

    Best to call and ask them directly.

    Best to call and ask them directly.
  3. Replies
    13
    Views
    322

    Import two, sell one, ride the other. No...

    Import two, sell one, ride the other.

    No warranty, but your financial exposure is reduced by the profit on the sold machine.
  4. Replies
    2
    Views
    66

    Are you sure that supercharger impeller cannot be...

    Are you sure that supercharger impeller cannot be used?
  5. Replies
    18
    Views
    2,576

    If you ride with the rear seat and bucket removed...

    If you ride with the rear seat and bucket removed does the top speed and maximum RPM change much?

    If no real change then the hull air inlets are not creating a flow restriction that the engine...
  6. Replies
    4
    Views
    127

    If the electrical box shorts to the battery...

    If the electrical box shorts to the battery positive post that can burn the thin black wires.
  7. Replies
    13
    Views
    933

    Remove the air filter, close up the empty air box...

    Remove the air filter, close up the empty air box and go for a test ride. See what sustained RPM it provides. There should be zero dust or loose debris inside the 10-hour hull so the engine will be...
  8. Possibly making some progress. I/we now...

    Possibly making some progress.

    I/we now suspect that on the Yamaha two connector ECU that pin 29 might provide the same tachometer signal that is present on pin-82 with the three connector ECU.
    ...
  9. Hmmm, something to think about. How best to do?...

    Hmmm, something to think about. How best to do? :-k
  10. This is the blower you are currently using,...

    This is the blower you are currently using, correct?
    https://www.pentair.com/en-us/products/residential/water-supply-disposal/marine/shurflo-yellow-tail-in-line-blower.html

    3.7 and 5.2 amp rated....
  11. Replies
    16
    Views
    471

    Post the link here so others can more easily find...

    Post the link here so others can more easily find it later, when they may need to repair their own mid-wall and mid-shaft housing problems. :)
  12. Replies
    16
    Views
    471

    Micro flame torch has been useful for me in the...

    Micro flame torch has been useful for me in the past. In my case I just needed to cook each bolt enough to achieve the breakdown temp of the thread locking compound.

    The micro torch flame is very...
  13. Your entire post presents some excellent points....

    Your entire post presents some excellent points.

    The OEM factory PWC configuration does of course meet the extent Coast Guard and industry regulations. That does not mean it is designed or...
  14. Replies
    16
    Views
    471

    Not too long ago another member posted about his...

    Not too long ago another member posted about his mid-wall repair after a difficult housing removal.

    If you can find that thread it had good photos of the damage and the repair process.
  15. This thread I think many people (now and in the...

    This thread I think many people (now and in the future) will find helpful for understanding the differences and reasons behind choosing ACR vs. battery selector switch vs. staying with the straight...
  16. My view is that the ACR configuration removes...

    My view is that the ACR configuration removes almost all mental workload from the rider despite having the complexity of a dual battery installation. Both batteries are automatically maintained to...
  17. If someone does have a dual battery...

    If someone does have a dual battery configuration, powering the radio from the ‘primary battery’ (the engine start battery) is the opposite of the advised configuration.

    If powering accessories...
  18. Looking at the wiring diagram for my 2017 SVHP...

    Looking at the wiring diagram for my 2017 SVHP GP1800;

    plug 1 , pin 8 is W/B wire, goes from pickup coil to ECU. Does not go anywhere else

    plug 2 , pin 47 is W/B, goes to the dash. I suppose...
  19. I do not have a two connector ECU Yamaha. On...

    I do not have a two connector ECU Yamaha.

    On the prior generation three connector ECU the tachometer signal on pin-82 has six pulses per engine revolution. Pin-82 had no factory wire at all on my...
  20. How does the second battery help if it will never...

    How does the second battery help if it will never be linked to the main battery except when the engine is running?

    Are you drawing power from the second battery for on-board electronics when the...
  21. I will reiterate that if one does decide to...

    I will reiterate that if one does decide to install a physical (heavy current) battery A-B-Both switch, that the switch should be wired into the battery negative cables. This is a safety thing. If...
  22. Welcome. Useful link for Polaris PWC related...

    Welcome.

    Useful link for Polaris PWC related info
    http://polarispwcknowledge.shorturl.com/first-things-to-do
  23. Yamaha ECU with two connectors, tachometer signal pin?

    On the Waverunners Yamaha changed the ECU in recent years. Prior to 2016 the ECU for 1.8 liter engine has three connectors. I have the wiring diagram for the three connector ECU and found the tach...
  24. What info do you need that is not in this post? ...

    What info do you need that is not in this post?

    http://greenhulk.net/forums/showthread.php?t=289442&p=3102347&viewfull=1#post3102347

    BlueSea m-ACR
  25. welcome. In what way did you check the relay...

    welcome.

    In what way did you check the relay for the bilge pump?

    What year and model is your Yamaha?

    The FX powers the bilge pump circuit (via the bilge pump relay) when the engine starts,...
Results 1 to 25 of 189
Page 1 of 8 1 2 3 4