Search

Type: Posts; User: Fast1

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Price lowered

    Price lowered
  2. Slippery When Wet Subzero Dry Suit - Size Large

    https://www.ebay.com/itm/323748347123



    or contact me direct via pm
  3. Replies
    13
    Views
    2,795

    They were selling for low $6's a year ago in MN....

    They were selling for low $6's a year ago in MN.

    Top speed stock seemed to be around ~62/63 mph.

    Friend has two, one purchased at the above price, and both have been
    extremely reliable. One...
  4. Replies
    311
    Views
    59,575

    YouTube - MacCluggage and Rius on Yamaha FZR and...

    YouTube - MacCluggage and Rius on Yamaha FZR and FZS at Body Beach
  5. Thread: GPR at rest

    by Fast1
    Replies
    4
    Views
    803

    what type of fuel do you use? any with ethynol...

    what type of fuel do you use? any with ethynol in it?


    Two months of non-use with ethynol fuel can gum up the injectors.
  6. Replies
    11
    Views
    2,374

    I've had problems with large fender washers...

    I've had problems with large fender washers pressing into the hull in real rough water and when jumping.
  7. Replies
    9
    Views
    967

    WOW!.. that thing must fly! where were you...

    WOW!.. that thing must fly!

    where were you testing on the river? That channel down by Prescott
    where the Mississippi and St. Croix meet?
  8. Replies
    10
    Views
    2,088

    you will say that again if you have rusted up...

    you will say that again if you have rusted up your crank bearings from the water instrustion.... hate to be the pessimist
  9. Replies
    11
    Views
    1,744

    as a comparison.. My 01 GPR with milled head,...

    as a comparison..

    My 01 GPR with milled head, extended nozzle, 13/19 impeller, stock plate, stock jetting and ppk would turn 67.5 mph in cool (65 degree) weather.

    The additional compression...
  10. Replies
    7
    Views
    1,142

    Did back in 2000.. but haven't since.

    Did back in 2000.. but haven't since.
  11. Replies
    23
    Views
    2,478

    pull all three plugs,, and see if you can turn...

    pull all three plugs,, and see if you can turn the engine over by hand by turning the drive shaft where it exits behind the engine.
  12. was there any paint left on the silver car from...

    was there any paint left on the silver car from your ski? red from the hull or black from the sponson?
  13. Replies
    21
    Views
    3,007

    hey I'll take a few shots since some others...

    hey I'll take a few shots since some others have..


    The reason they took shots at you is because they have no clue about what those mods will do for an Ultra..
  14. Replies
    15
    Views
    1,970

    +1.. don't run it anymore until you determine...

    +1.. don't run it anymore until you determine what is wrong with it.
  15. Thread: Need Help!

    by Fast1
    Replies
    11
    Views
    1,065

    hope you did not store it all winter with ethynol...

    hope you did not store it all winter with ethynol fuel and no gas preserver added (stabil)... ... that fuel will gum everything up within your fuel injection system.
  16. Replies
    5
    Views
    931

    CC racing puts alot of stress on the motor and...

    CC racing puts alot of stress on the motor and will generally heat it up or cause pistons "sticks" due to any problems with the engine set up. .. I would take a close look at that impeller you are...
  17. Replies
    25
    Views
    2,138

    probably obvious.. but get a helmet and goggles...

    probably obvious.. but get a helmet and goggles and wear them while you practice. The helmet will change how you hear your engine and others around or near you. I personally run about 1/3 of tank of...
  18. Replies
    41
    Views
    3,728

    nice .. stealth like I see you have that GPS...

    nice .. stealth like

    I see you have that GPS angled for viewing from the super-man position..
  19. Replies
    25
    Views
    2,138

    Most of the time following a group into the first...

    Most of the time following a group into the first turn will seriously impede your speed... the amount of spray coming off 3 or 4 PWC's in a tight corner will eliminate any vision and you risk nailing...
  20. Thread: 2008 Yamaha's.

    by Fast1
    Replies
    24
    Views
    2,555

    Maybe a 1500 CC Two-stroke fuel injected triple...

    Maybe a 1500 CC Two-stroke fuel injected triple pipe in the current GPR hull??? well at least you can dream!...
  21. Replies
    9
    Views
    1,915

    or someone got a special sauces plate for a...

    or someone got a special sauces plate for a race...

    just look at this way, at least you did not purchase an expensive engine mod only to cause a catastrophic engine failure after several hours of...
  22. Replies
    36
    Views
    5,311

    nice report.. only think I will add is that it...

    nice report..

    only think I will add is that it was "97" when Yamaha came out with the GP1200 which has been known to have hull issues.. mid 98 hulls were much improved.
  23. Replies
    38
    Views
    12,630

    I've never seen a 150 Ultra running the river...

    I've never seen a 150 Ultra running the river (St. Croix) in the last 5 years that will turn 70 mph (GPS) including two of my friends that own them. They are very economical when running 1/2 throttle...
  24. Replies
    38
    Views
    12,630

    An ultra 150 in stock form is a pond ski.. smooth...

    An ultra 150 in stock form is a pond ski.. smooth water only. I've watched many of my friends that own them go cartwheeling off them in 1' to 2' waves.

    A 250X is 100 times better for Lake of the...
  25. Replies
    75
    Views
    9,546

    not so.. my 1300 GPR will jump higher and...

    not so.. my 1300 GPR will jump higher and further, with more speed and wave height, and have a softer landing. Plus the old GPs were prone to hull damage. Yamaha provided me one of their back up...
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4