Search

Type: Posts; User: johnsonmtz

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    0
    Views
    60

    '03 GTI RFI LE blowing 10amp fuse

    I'm helping a friend fix his '03 GTI RFI LE. Lately is has been blowing the 10amp fuse which takes out all power. He seems to think it happens most often when he hits a hard wake. When I replace...
  2. Replies
    10
    Views
    185

    Long skinny one is the main fuel pickup. Not...

    Long skinny one is the main fuel pickup. Not sure what the white plastic one is but might be some other kind of pickup. Usually the main pickup sets about 1" or so off the bottom of the tank and...
  3. Replies
    4
    Views
    447

    Really common on the 650/750 skis. There is...

    Really common on the 650/750 skis. There is supposed to be a plastic cover on the battery to shield the terminals from the Ebox. Those were often lost and people would just put the Ebox directly on...
  4. Replies
    2
    Views
    316

    Yep, rebuild the pump with new bearings and seals...

    Yep, rebuild the pump with new bearings and seals and all will be right again.
  5. I don't have a part #, but i bought mine from...

    I don't have a part #, but i bought mine from John Zigler at Rock County Jet Ski in Wisconsin. You can find him at this web site.
    https://www.watcon.com/

    I don't see filler necks listed in the...
  6. I’ve replaced an SLT filler neck with the click...

    I’ve replaced an SLT filler neck with the click style with success.
  7. Replies
    27
    Views
    1,078

    With the piston at BDC you should be able to get...

    With the piston at BDC you should be able to get a good view of the dome using your endoscope. There should be no need to remove the heads. Usually, I just use a little flexible LED penlight and I...
  8. Replies
    11
    Views
    497

    Just to cover bases, you are using NGK BPR7ES...

    Just to cover bases, you are using NGK BPR7ES plugs, right? That's the correct plug for Fuji 750 engines.
  9. Replies
    4
    Views
    387

    The condition of the hoses in the tank is a...

    The condition of the hoses in the tank is a common problem for a 23 year old ski. I fount the same thing on my ‘95 when I got it .

    on the 750’s the return faces the rear of the ski. Kinda goofy...
  10. FS - Parts Ah gotcha, I was looking at the pic wrong. ...

    Ah gotcha, I was looking at the pic wrong.

    Hmmmm, so I wonder if I could triple pipe the SLT750? :-k Of course I still have a single PSI dry pipe setting in the garage that has never been...
  11. Replies
    9
    Views
    684

    FS - Parts Sweet, thanks.

    Sweet, thanks.
  12. FS - Parts wow, triple pipes and side draft carbs. Pretty...

    wow, triple pipes and side draft carbs. Pretty much the same setup Keddano used to have on the PSI Cooker.
  13. Glad you found the leak. Steering issue is...

    Glad you found the leak.

    Steering issue is probably the cable. Remove the cable linkage from the steering nozzle then move the nozzle by hand. It should be free and easy. Next move the steering...
  14. Replies
    24
    Views
    1,292

    Piston wash doesn't need a high speed run. Put...

    Piston wash doesn't need a high speed run. Put the cylinder at BDC and with your bore scope you should be able to see dome of the piston very well. Good wash will have clean aluminum areas about...
  15. Base gasket Intake gasket If Dual carb, the...

    Base gasket
    Intake gasket
    If Dual carb, the carb-to-intake gasket
    Pulse line/connection

    All 4 very possible locations of an air leak.
  16. Replies
    24
    Views
    1,292

    Definitely need to see piston wash to determine...

    Definitely need to see piston wash to determine lean or rich. Plug chops can be misleading.

    Have you removed your plug wires from the boots, cut 1/4" and reinstalled on the boot? Poor...
  17. Sounds like a grounding issue. First confirm...

    Sounds like a grounding issue. First confirm that you have a 0 ohm reading between the battery negative and bare metal on the engine. If the reading is above 0 ohm start tracking down grounds and...
  18. Red flashing light is for low fuel or low oil. ...

    Red flashing light is for low fuel or low oil. MFD should tell you which it is. Warnings in the MFD are Hot, LowFuel (under 1/8 tank) Low Oil (under 1/4 tank) and LoPr (voltage under 10.9 volt). ...
  19. Replies
    4
    Views
    1,060

    SOLD PM sent

    PM sent
  20. Replies
    9
    Views
    684

    FS - Parts Sounds good. PM me pay info and I’ll give you my...

    Sounds good. PM me pay info and I’ll give you my shipping address.
  21. Are you certain it's the oil pump that failed? ...

    Are you certain it's the oil pump that failed? Those Mikuni pumps are extremely reliable and if the hoses and clamps are in good shape there are typically no problems.

    A seized piston is most...
  22. I've used 1/4" ID fuel inject rated hose. there...

    I've used 1/4" ID fuel inject rated hose. there is a stainless frit that goes on the end of the hose. Make your reserve line long enough so the frit is just a hair above the bottom of the tank. ...
  23. Had that happen on my '96 SLT780. The rubber...

    Had that happen on my '96 SLT780. The rubber plug for the sender had shrunk and got loose in the opening. A couple of wraps of electrical tape, pop it back in the hole, and it's as snug as ever.
  24. Replies
    9
    Views
    684

    FS - Parts MFD

    How much for the MFD? If itís in good shape Iím interested.
  25. Replies
    4
    Views
    1,060

    SOLD Are any of these still available? Mine just...

    Are any of these still available? Mine just frizzed out with all kinds of gibberish looking lines so I'm not certain it's repairable.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4