Search

Type: Posts; User: Chrisx88

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    87

    View Post

    Canít upload video on mobile. But compared to my 12f this engine is knocking bad. Not even an hour on brand new
    Motor! Back to dealer it goes.
  2. Replies
    2
    Views
    87

    2012 15f jerking

    2012 stx15f

    New pump bearing and brand new engine installed by Kawi dealer.

    Canít go over 4K. Soon as you hit 4.1k rpm it starts jerking back and forth. Any ideas? I just changed plugs too.
  3. Replies
    4
    Views
    200

    I have the front bucket cover that holds the...

    I have the front bucket cover that holds the extinguisher. I thought it was just me being crazy when i felt ski was slower since i put it back on.
  4. Replies
    4
    Views
    200

    Speed not where it should be

    05 Seadoo RXT

    Brand new motor with 10hrs clocked on it so far

    Fizzle 1000
    RRFPR set to rising rate @ 58lbs
    open loop cooling
    Xcharger w/ oil mod in PTO
    15/20
    Pump wedge
  5. Replies
    7
    Views
    306

    Too many problems with SCOMS, you get lucky if...

    Too many problems with SCOMS, you get lucky if the one you get even works.

    I stand behind Racelab. I have their tune on my rxt 215. AFR were a little off, I sent ECU back and they made some tweaks...
  6. Replies
    15
    Views
    533

    I have pretty much same setup as you, except for...

    I have pretty much same setup as you, except for the 137+4.

    I run 80lb injectors, CMDM with the 80lb fuel map. My AFR are mint all across the board at all times.

    Stop wasting your time on Riva...
  7. Replies
    6
    Views
    222

    I topped the fluid off other day, ran it on...

    I topped the fluid off other day, ran it on trailer in water for few mins with some good RPMS. Than rode it, and no temp alarm. He rode it and less than a minute he said was throwing alarm.

    Ill...
  8. Replies
    6
    Views
    222

    05 rxp coolant gone

    Friend is bringing me his RXP to look at.

    No coolant in hull, no coolant leak from plate, no coolant in oil. Pressure test to 13psi, lost 1psi over an hr. Overheats within a minute on water,...
  9. Thread: 05 rxt

    by Chrisx88
    Replies
    8
    Views
    194

    the ground wires? They are bolted to engine block...

    the ground wires? They are bolted to engine block behind oil fill tube.
  10. Replies
    13
    Views
    407

    Pull the pump and see what prop your running.

    Pull the pump and see what prop your running.
  11. Replies
    20
    Views
    637

    Why are you only turning 6800rpm? Your not even...

    Why are you only turning 6800rpm? Your not even in boost yet.
  12. Replies
    18
    Views
    537

    Do yourself a favor. Search bens secret tips....

    Do yourself a favor. Search bens secret tips. Delete the accel pump, rejet the carbs, put on after market air filter. It really wakes the engine up. You will love it. Its also 10x easier to remove...
  13. Replies
    5
    Views
    194

    FS Would you be opposed to shipping it?

    Would you be opposed to shipping it?
  14. Replies
    4
    Views
    297

    FS - Parts Interested in 185 SC engine.

    Interested in 185 SC engine.
  15. Replies
    11
    Views
    256

    Take it to dealer and have the TPS reset. Then go...

    Take it to dealer and have the TPS reset. Then go from there.
  16. Replies
    18
    Views
    537

    If you towed the ski without clamping the inlet...

    If you towed the ski without clamping the inlet cooling hose than you filled the motor with water,
  17. Replies
    32
    Views
    2,578

    Frogskinz vent covers are the only way to go when...

    Frogskinz vent covers are the only way to go when covering holes. Ive used them on my XPLs, Rxs and XPs when removing vent tubes or cutting additional holes.
  18. Replies
    8
    Views
    230

    Im still learning this CMD. I just figured out...

    Im still learning this CMD. I just figured out how to do cell tracing today, that will help a lot. I was out cruising around 4-5k and i would hammer down, it did the same lag. Now that i can cell...
  19. A tap that size is going to be crazy money. Id...

    A tap that size is going to be crazy money. Id Silicone the shit out of plug, and send it home with a 3/4" impact gun, lol.
  20. Replies
    8
    Views
    230

    I did turn it off, didnt do anything.

    I did turn it off, didnt do anything.
  21. Replies
    8
    Views
    230

    Ive tried, doesnt help.

    Ive tried, doesnt help.
  22. Thread: Depitch?

    by Chrisx88
    Replies
    15
    Views
    562

    AFR are great everywhere. I just cannot get rid...

    AFR are great everywhere. I just cannot get rid of this nasty bog / lag from idle to WOT.
  23. Replies
    8
    Views
    230

    CMDM Guys, need help with bog / accel

    Running tuned ecu, and CMDM. Running the 80lb map. Ive got perfect AFR everywhere from 1750-8800 Rpm. Problem is i have a nasty bog / lag from idle to full throttle whack.

    AFR drops to 10.0 for...
  24. Thread: Depitch?

    by Chrisx88
    Replies
    15
    Views
    562

    Hooked up the reference to RRFPR. 8800 RPM....

    Hooked up the reference to RRFPR. 8800 RPM. Thanks Splishsplash. I gatta rework impeller a little now because i was banging limiter...or send computer out and raise it to 9k.
  25. Thread: Depitch?

    by Chrisx88
    Replies
    15
    Views
    562

    Thanks, ill hook it back up and try it.

    Thanks, ill hook it back up and try it.
Results 1 to 25 of 150
Page 1 of 6 1 2 3 4