Search

Type: Posts; User: RG5384

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    49
    Views
    1,140

    Brief update: Got the new cdi installed tonight,...

    Brief update: Got the new cdi installed tonight, also used the replacement coil and wires. Total replacement wasn’t possible due to a cut wiring harness and I didn’t feel like soldering that many...
  2. Replies
    49
    Views
    1,140

    Everything is ohming out correct. Well, mostly....

    Everything is ohming out correct. Well, mostly. The secondary coil I’m only able to get a very intermittent read on, not sure if it’s just an issue of connectivity inside the boots or a larger...
  3. Replies
    49
    Views
    1,140

    thanks!

    thanks!
  4. Replies
    49
    Views
    1,140

    they were removed and cleaned per Jeff’s...

    they were removed and cleaned per Jeff’s suggestion. Somewhere on page 4 of this post lol.
  5. Thread: Premix

    by RG5384
    Replies
    5
    Views
    218

    I have no experience with that particular ski,...

    I have no experience with that particular ski, but I'd tend to agree with Wrench. Both of my Ski's were converted to pre-mix before I bought them, and its a pain. Check the oil lines to make sure...
  6. Replies
    49
    Views
    1,140

    What should the stator ohm out at on these? Might...

    What should the stator ohm out at on these? Might as well start to check stuff like that while I wait for the new/used Ebox to arrive. The ebox that I purchased is complete with the harness, so I'm...
  7. Replies
    49
    Views
    1,140

    they are there. Is there any other way to check...

    they are there. Is there any other way to check the servo? I’ve done the gray to black wire jumper test and it passes that.
  8. Replies
    49
    Views
    1,140

    Thanks. I went ahead and ordered a used Ebox for...

    Thanks. I went ahead and ordered a used Ebox for the thing, going to wire that up, check for any obstructions in the exhaust as you mentioned, and if none of those fix it i'm giving up. I've spent...
  9. Replies
    49
    Views
    1,140

    Thanks! I know the inner coupler is good because...

    Thanks! I know the inner coupler is good because I had to replace it, the PO thought wrapping the split seal in duct tape was a good approach. I'll check into the other exhaust components though. ...
  10. Replies
    49
    Views
    1,140

    Problem persists. I adjusted them per the...

    Problem persists.

    I adjusted them per the manual,and they are cycling at shut down.

    Ive checked the fuel baffle and repaired that, and the ski is running great except for this.

    Any my...
  11. Replies
    49
    Views
    1,140

    Got it all back together again. Power valves...

    Got it all back together again. Power valves moving smooth and the servo is cycling them on shutdown. Headed to the river to check it out, but on the trailer I still have no movement when it hits 5k...
  12. Replies
    49
    Views
    1,140

    Now i'm confused, and I think I need to pull the...

    Now i'm confused, and I think I need to pull the whole thing apart again:facepalm:. So reference the attached picture, in this picture the power valve should be flipped the other way before being put...
  13. Replies
    49
    Views
    1,140

    Disregard, figured out how to remove. Now just...

    Disregard, figured out how to remove. Now just need to remember which way it came out to put it back in...
  14. Replies
    49
    Views
    1,140

    Just got the exhaust off and dug into the power...

    Just got the exhaust off and dug into the power valves. The Mag cylinder was extremely sticky, and was very difficult to move even by hand. I took out the allen head, removed the retaining clips, and...
  15. Replies
    49
    Views
    1,140

    Took out the fuel baffle this morning, that trap...

    Took out the fuel baffle this morning, that trap door was hung up, and twisted, and the entire bottom of the pickup where the screen is was twisted as well. I removed all of those, and re-installed....
  16. Replies
    49
    Views
    1,140

    good point. On an unrelated topic hit me up if...

    good point. On an unrelated topic hit me up if you’d like to head out riding sometime(I live in Lakewood ranch). I have another ski that is 100%, and have been looking for some fun places to ride....
  17. Replies
    49
    Views
    1,140

    Just checked compression, 120psi dead on both...

    Just checked compression, 120psi dead on both cylinders. Plugs were very wet so I’m definitely running it rich.

    This is thing is fighting me every step of the way, I went to check compression and...
  18. Replies
    49
    Views
    1,140

    Thanks, I did have the exhaust off to install the...

    Thanks, I did have the exhaust off to install the waveater clips and all was intact at that time. Granted I didn’t know exactly what I was looking at and for, but I didn’t see anything missing or...
  19. Replies
    49
    Views
    1,140

    Thanks all. I’m going to check compression again...

    Thanks all. I’m going to check compression again just to ensure I’m not tossing good money away, assuming good, from there I’m going to source a new(used) power valve servo, pull the exhaust back...
  20. Replies
    49
    Views
    1,140

    They are, I replaced the connector with the...

    They are, I replaced the connector with the waveater one. This thing runs pretty good without the servo hooked up, I ran it for about 6 hours yesterday and am taking it back out today, but it’d be...
  21. Replies
    49
    Views
    1,140

    Thanks grumpy Steven, looks like that is what I...

    Thanks grumpy Steven, looks like that is what I will be checking next!
  22. Replies
    49
    Views
    1,140

    Alright, so the power valves don’t really move,...

    Alright, so the power valves don’t really move, it just twitches. I also found a missing bolt holding the servo motor in, but no real changed after replacing that either. Here’s the weird part, if I...
  23. Replies
    49
    Views
    1,140

    Don’t recall which way it moves, I’ll check that...

    Don’t recall which way it moves, I’ll check that tomorrow and report back. The plugs were new when I bought it, but I haven’t changed them out yet. I’d be shocked if it was that simple, but it...
  24. Replies
    49
    Views
    1,140

    Yeah i've got a fluke knockoff that's pretty...

    Yeah i've got a fluke knockoff that's pretty solid. What do you recommend I check?
  25. Quick update: First time on the water today and...

    Quick update: First time on the water today and no leaks! I even did some donuts where I buried the nose of the ski in the water intentionally just to check. I also accidentally bumped the right...
Results 1 to 25 of 77
Page 1 of 4 1 2 3 4