Search

Type: Posts; User: Mr. GP1800

Page 1 of 8 1 2 3 4

Search: Search took 0.13 seconds; generated 28 minute(s) ago.

  1. Replies
    4
    Views
    91

    Were did you get that piston? I don’t think it’s...

    Were did you get that piston? I don’t think it’s the right piston for that motor either
  2. Replies
    2
    Views
    93

    It’s always better to tap the manifold. I would...

    It’s always better to tap the manifold. I would never use the T
  3. Gen 1 vs Gen 2 riva intake grates for the GP 1800

    Has anyone tested these grates back to back? Were there any performance differences? I currently have the gen 1 and just ordered the gen2. A friend of mine just installed the gen2 and gave great...
  4. Replies
    11
    Views
    279

    I had my seal pop out once when I didn’t have a...

    I had my seal pop out once when I didn’t have a ride plate bolt tightened all the way. Ski would only go 70 and bounced at full speed. Got that issue fixed and it was all good again. I’d be...
  5. It’s the left trigger to clear the exhaust on the...

    It’s the left trigger to clear the exhaust on the trailer. No way I can rev it too much with that
  6. Thats my favorite prop Polaris had for the 1200...

    Thats my favorite prop Polaris had for the 1200 skis. The hole shot and mid range are way better with the 707 than with the 202. The 202 is maybe 1-1.5 MPH faster on top though. But everywhere else...
  7. Replies
    84
    Views
    17,768

    So what is the actual verdict on this.? Is it...

    So what is the actual verdict on this.? Is it 155 or 160mm stator section?
  8. Replies
    2
    Views
    141

    If you’re looking for something to throw around...

    If you’re looking for something to throw around and have fun with the ex is the way to go. If you want to take longer rides and cruise or carry a passenger definitely the vx. Ride is completely...
  9. stock Polaris 707 prop is better then the 7.0

    stock Polaris 707 prop is better then the 7.0
  10. Replies
    5
    Views
    304

    Is about a 5 dollar part. There is a plastic tab...

    Is about a 5 dollar part. There is a plastic tab that acts as a spring on the latch
  11. Replies
    56
    Views
    4,750

    I’m sure that repair is just fine. The strength...

    I’m sure that repair is just fine. The strength comes from the mounting brackets being on top of both hull layers. That’s probably 1/2 inch of glass there. What was done inside the hull for...
  12. What was the reason for the change?

    What was the reason for the change?
  13. Replies
    2
    Views
    230

    If you can repair the wires the stator may still...

    If you can repair the wires the stator may still be good.
  14. Disconnect the grey wire completely and see what...

    Disconnect the grey wire completely and see what happens. There is a module in the box that will put the ski in limp mode for low fuel low oil or overheat. I had that go bad on mine. I just left...
  15. Replies
    56
    Views
    4,750

    How did they do the repair? Something in those...

    How did they do the repair? Something in those pics looks strange and I canít seem to figure it out
  16. Replies
    5
    Views
    290

    The LT is a smaller trailer as well. If you have...

    The LT is a smaller trailer as well. If you have modern skis definitely get the elite. You won’t regret it
  17. Get a start stop switch from an msx 140 and get...

    Get a start stop switch from an msx 140 and get rid of that stupid lr 503
  18. Replies
    10
    Views
    550

    It seems nobody has had luck getting the TTO tach...

    It seems nobody has had luck getting the TTO tach to work. It’s really too bad. It’s a nice little unit. The Searon tacos do work but aren’t real watertight. The PET 2100 is still the best though
  19. Replies
    31
    Views
    880

    View Post

    Because itís way easier to pull the motor out than it is to try and remove the gas tank and work through the hood opening. So many people are afraid to pull the motor out of the ski to work on them....
  20. Replies
    31
    Views
    880

    Because it’s way easier to pull the motor out...

    Because it’s way easier to pull the motor out than it is to try and remove the gas tank and work through the hood opening. So many people are afraid to pull the motor out of the ski to work on them....
  21. Replies
    16
    Views
    581

    I’d pull the motor rather than trying to move the...

    I’d pull the motor rather than trying to move the fuel tank and work on it in the hull
  22. Replies
    11
    Views
    538

    Are you checking speed with gps?

    Are you checking speed with gps?
  23. Replies
    3
    Views
    230

    A wire wheel on a drill may work.

    A wire wheel on a drill may work.
  24. Replies
    16
    Views
    581

    I had a ficht stator with one bad coil. I could...

    I had a ficht stator with one bad coil. I could get the engine to start and run as long as I gave it throttle. Swapped out the stator and it ran perfectly. It could be a damaged flywheel but...
  25. You need to run the engine under load for engine...

    You need to run the engine under load for engine break in. Its also not advisable to run on the hose for longer than a few minutes. The drive shaft and jet pump seals can heat up and cause...
Results 1 to 25 of 199
Page 1 of 8 1 2 3 4