Search

Type: Posts; User: cord359

Search: Search took 0.02 seconds.

  1. Replies
    2
    Views
    701

    Thanks for the reply. I have a new battery and it...

    Thanks for the reply. I have a new battery and it was charged to the max. I will say i didn't actually check the grounds but I did try to go over all the connections with a meter. I will go over the...
  2. Replies
    2
    Views
    701

    Intermitent spark to no spark

    I have a 96 GSX with new 787 short block. Over the past couple of years this thing would give me fits at start up. Sometimes it would start right up, sometimes it would spin, no spark. Then 20...
  3. Replies
    3
    Views
    442

    Sounds good to me considering what i was...

    Sounds good to me considering what i was thinking, i will check this out.
    Thanks
  4. Replies
    3
    Views
    442

    Intermittent no spark

    i have a brand new 787 short block in 96 gsx, just finished break in and it runs great. sometimes (usually when its been running and hot) u may shut it off
    for a few minutes and when you go to start...
  5. Replies
    11
    Views
    2,731

    A circlip that holds the wrist pin came out and...

    A circlip that holds the wrist pin came out and caused a lot of damage (rotor shaft gear, rotor valve plate and rotor valve surfaces on the cases).
    It looks like all thats usable is the crank, and...
  6. Replies
    11
    Views
    2,731

    Either way, this would mainly be to keep my kids...

    Either way, this would mainly be to keep my kids off the grandparents new sea-doo. Also I do
    kind of enjoy working on these things.
  7. Replies
    11
    Views
    2,731

    Thanks Guy's, i will admit i wasn't looking...

    Thanks Guy's, i will admit i wasn't looking forward to spending more money on this boat.
    Thanks for input
  8. Replies
    11
    Views
    2,731

    SBT Short Block

    I have a 96 GSX, motor is shot everything else in reasonable condition, thinking about a SBT short block.
    Reluctant to spend the cash, i need a nudge one way or another. Anyone have any advice....
  9. Thread: Rotary valve

    by cord359
    Replies
    2
    Views
    639

    Rotary valve

    I purchased a 96 787 engine for my old gsx, the rotary valve gear is striped out leaving
    the brass filings inside engine any suggestions on removing the brass without opening
    bottom end.
  10. Replies
    0
    Views
    595

    Engine cleaning

    I'm new to pwc's. I know these things are made for the water but is it safe to hose the engine compartment to clean it and maybe use some kind of detergent.
  11. Thread: Beep codes

    by cord359
    Replies
    2
    Views
    4,049

    thanks

    thanks
  12. Thread: Beep codes

    by cord359
    Replies
    2
    Views
    4,049

    Beep codes

    Can anyone tell me where to find beep code information. I have a 96 gsx that gives 3 beeps sometimes and want start, after unpluging lanyard and trying several times it will eventually start but it...
Results 1 to 12 of 12