Search

Type: Posts; User: Jaugi

Search: Search took 0.00 seconds.

  1. Wow. Well here is part of the problem and I hope...

    Wow. Well here is part of the problem and I hope it didn’t cause any bigger problems. I pulled the plugs again to put a tester on the cylinders, 2 plugs say br8es-11 and 1 plug says br8es. I ordered...
  2. I just got my leak down tester in the mail about...

    I just got my leak down tester in the mail about 5 minutes ago. I will do the test and keep you posted. It seems like itís only hard to start the first time of the day but I need to add premix to the...
  3. it is a 2000 gp1200r

    it is a 2000 gp1200r
  4. Hard start, choke, accel pump removed, drilled return

    Hi guys,

    I did the aftermarket f/aís, removed accel pump, rejetted, did drilled return. I did it based on osidebills write up. The engine is still hard to start but once itís running itís good....
  5. Replies
    7
    Views
    191

    Thanks! I got rid of the accelerator pump, added...

    Thanks! I got rid of the accelerator pump, added flame arresters and rejetted. I did the 95 gram springs and 1.5 n&s. The thing fired up immediately and didnít bog anymore. Need a warm day for a...
  6. Replies
    1
    Views
    111

    I found one but I don’t know how to delete the...

    I found one but I don’t know how to delete the post. I just wanted to let everyone know because I don’t need one anymore
  7. Replies
    1
    Views
    111

    2000 GP 1200r idle adjustment cable

    Hi,
    I'm looking for an idle adjustment cable/springs/orings etc for my 2000 gp1200r. I tried to adjust it the other day and it snapped off. I believe the part number is 66V-14124-00-00
  8. Replies
    7
    Views
    191

    I decided I’m going to do the accel pump delete,...

    I decided I’m going to do the accel pump delete, rejet, add f/a’s according to osidebill’s procedure. I am also going to do the drilled return mod. Before putting the carbs in I will check pop off,...
  9. Replies
    7
    Views
    191

    View Post

    Thanks Iím going to keep looking into this over the weekend. I used the mikuni rebuild kits for all 3 carbs and I used the original springs. I never measured pop off which was a novice mistake but...
  10. Replies
    7
    Views
    191

    Hey thanks for the reply. I did not do the...

    Hey thanks for the reply. I did not do the drilled return mod. It looks pretty straight forward but I’m new to PWCs in general and wanted the opinions of experienced people before doing anything. Do...
  11. Replies
    7
    Views
    191

    Bogging 2000 gp1200r

    Hey guys,
    New to the forum. Iíve been looking through the forum and it seems like there is a ton of information on the problem Iím having but it also seems like it could be a few things. I bought...
Results 1 to 11 of 11