Search

Type: Posts; User: connelja

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    483

    Virage single carb mount problems!

    I recently rebuilt my carb and after taking it off and putting it back on it seems that it is not sitting on the manifold neatly. Has anyone has similar issues and if so what did you do?
    I am...
  2. Sticky: Excellent info. My reverse lever is sticking and...

    Excellent info. My reverse lever is sticking and I plan to use this info and tackle this next weekend. Thanks everyone.
  3. I know this is an old post but sirdave were you...

    I know this is an old post but sirdave were you able to get your virage working correctly? I am having similar issues and I have rebuilt the carb and replaced a fuel lines; good compression in both...
  4. Steerring nozzle and reducer fit on the virage...

    Steerring nozzle and reducer fit on the virage nicely.
  5. Thread: 01 Virage

    by connelja
    Replies
    3
    Views
    430

    Thanks. I replaced the solenoid this weekend and...

    Thanks. I replaced the solenoid this weekend and the ski fired right up. I then took the ski out for its first test drive and thats when another problem showed up.
    The ski starts easily but it is a...
  6. 96 SLT 700 steering nozzle/reverse gate on 01 virage 700

    I recently found a great deal for a 01 virage 700 in good condition. It needs a few things but the most important seems to be the steering nozzle/reverse gate which appears to have been damaged by...
  7. Thread: 01 Virage

    by connelja
    Replies
    3
    Views
    430

    01 Virage

    I am looking at a 01 Virage 700 single carb to buy for a good price. Both cylinders have good compression and the hull is in good condition. However, the ski won't start unless you jump the solenoid....
  8. Replies
    12
    Views
    2,298

    Sorry for the delay but I was able to tear into...

    Sorry for the delay but I was able to tear into the polaris this weekend. Here is what I found. I opened up the rear cylinder and the piston was seized. It was literally bone dry in there, I even had...
  9. Replies
    12
    Views
    2,298

    I was doing a little more thinking tonight and I...

    I was doing a little more thinking tonight and I plan on checking the lubrication system this weekend but it still does not make sense to me that the engine would quite suddenly. Then I could start...
  10. Replies
    12
    Views
    2,298

    Thanks everyone for your ideas. I did check to...

    Thanks everyone for your ideas.
    I did check to see if the oil pump was sending oil to each feed line and it was but only small amounts. I assumed this was normal because each feedline was equal. I...
  11. Replies
    12
    Views
    2,298

    Thanks for your responses. I opened the ebox and...

    Thanks for your responses. I opened the ebox and everything looked good. I again check all my fuel lines and vents which all appeared to be ok. We then attempted to fire it up again on the water and...
  12. Replies
    12
    Views
    2,298

    No I did not check the electrical box. What...

    No I did not check the electrical box. What specifically should I look for?
  13. Replies
    12
    Views
    2,298

    96 Polaris SLT Top-End Rebuild problems

    Hello,
    If anyone out there can help me with this problem I would greatly appreciate it.
    I recently rebuilt the top end of a Polaris 96 SLT 700 with a complete piston kit. All gasket and rings were...
Results 1 to 13 of 13