Search

Type: Posts; User: HiPeRcO

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    5
    Views
    185

    So far there are no suitable substitutes for the...

    So far there are no suitable substitutes for the newer pigtail style TPS's. You can buy a 2001 and earlier throttle body and fit the older style TPS to it, still available as an Evinrude part.
  2. Replies
    38
    Views
    1,151

    A wise person I know suggests that tight cables...

    A wise person I know suggests that tight cables can be greatly improved by disconnecting on both ends and then spinning the cable innards with a drill. Worth a shot 8-)
  3. Replies
    4
    Views
    123

    Welcome to Greenhulk! Unless you know for sure...

    Welcome to Greenhulk! Unless you know for sure that the second EMM is good, it's possible that BOTH EMMs are bad.
  4. Replies
    5
    Views
    702

    Probably going to have to drive it out of the...

    Probably going to have to drive it out of the coupler from the threaded end. Not sure how though without pulling the engine :( (coupler loosened and removed first of course)
  5. Replies
    5
    Views
    305

    THIS (http://pwcmanuals.shorturl.com/)...

    THIS information will be helpful.
  6. Replies
    27
    Views
    2,207

    WTB - Parts Why the sad face, lol :)

    Why the sad face, lol :)
  7. Replies
    5
    Views
    305

    Welcome to Greenhulk! There's a good chance...

    Welcome to Greenhulk!

    There's a good chance the SIFB is bad, it can be bypassed with a paper clip. LINK But be aware that you lose reverse RPM limit and it will likely rev to the moon when out...
  8. FS Post will be deleted unless the rules are...

    Post will be deleted unless the rules are followed. Thanks in advance.
  9. Replies
    4
    Views
    348

    Welcome to Greenhulk! PODIAG cannot update...

    Welcome to Greenhulk!

    PODIAG cannot update injector coefficients without a factory floppy disk. The good news is there is a utility HERE that will accomplish what you seek :)

    (You just need to...
  10. Replies
    1
    Views
    113

    Sounds like a TPS issue. Install a service power...

    Sounds like a TPS issue. Install a service power jumper to power the EMM with the engine off, then measure TPS volts while you sweep the throttle. Should smoothly go from about 0.5V to around 4V or...
  11. Replies
    7
    Views
    559

    Fantastic work! =D>

    Fantastic work! =D>
  12. Replies
    1
    Views
    160

    There really isn't much you can do to that...

    There really isn't much you can do to that platform that is going to make a meaningful difference. (Great ski stock :) )
  13. Replies
    77
    Views
    2,474

    I hear the 785s are VERY temperamental. The 1200...

    I hear the 785s are VERY temperamental. The 1200 SLX is likely going to require much less fiddling and as a result much more ride time.
  14. FS Yes, common. The wear ring "swells" and...

    Yes, common. The wear ring "swells" and interferes with the impeller. More common in salt but can happen especially on skis left in the water for extended periods of time. (Or the bearings lock up,...
  15. FS It's probably the jet pump that is locked up.

    It's probably the jet pump that is locked up.
  16. Thread: Polaris stator

    by HiPeRcO
    Replies
    10
    Views
    429

    Some comments: - I have seen many bad "NEW"...

    Some comments:
    - I have seen many bad "NEW" aftermarket stators. They are miswired from a polarity standpoint. Even thought the windings produce AC, phasing is important since the EMM stacks the...
  17. Replies
    5
    Views
    357

    Well, no. The engine needs air to run ;) ...

    Well, no. The engine needs air to run ;)

    (The location of the air intake is somewhat unfortunate though, being low down in the hull)
  18. Thread: Cylinder Crack

    by HiPeRcO
    Replies
    15
    Views
    591

    I vote to REPLACE it.

    I vote to REPLACE it.
  19. Replies
    50
    Views
    2,459

    Thread un-stickied until/unless an actual...

    Thread un-stickied until/unless an actual compatible replacement is found.
  20. Replies
    4
    Views
    278

    WTB - Parts They made them for sure.

    They made them for sure.
  21. My first guess would be TPS

    My first guess would be TPS
  22. Replies
    38
    Views
    1,151

    Super easy to get to the fuel pump assembly, it's...

    Super easy to get to the fuel pump assembly, it's right out in the open on a Genesis.
  23. Replies
    50
    Views
    2,459

    Yes, please do tell us the part number, and where...

    Yes, please do tell us the part number, and where you purchased it?
  24. Replies
    5
    Views
    357

    Welcome to Greenhulk! Basically what you want...

    Welcome to Greenhulk!

    Basically what you want to do is disconnect the recirculation hose from the airbox, then route the hose to a catch can design of your choosing. It can be as simple as this. ...
  25. Replies
    50
    Views
    2,459

    So wait a minute, the sensor kingdill referenced...

    So wait a minute, the sensor kingdill referenced does NOT work, due to having opposite direction of rotation?? (I wonder which one he bought then...hmm)
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4