Search

Type: Posts; User: K447

Search: Search took 0.11 seconds.

  1. Just to be clear, the flashing red lamp on the...

    Just to be clear, the flashing red lamp on the dash does not indicate anything specific.
    Just to read the text warning message across the bottom of the MFI display.

    Whether the red lamp is...
  2. Unplug the oil sender. Low oil warning should go...

    Unplug the oil sender. Low oil warning should go away.

    Does engine run better?
  3. I will defer to Lakeside Tech - his knowledge of...

    I will defer to Lakeside Tech - his knowledge of all things Ficht has eclipsed my own.
  4. TPS bench testing can reveal a bad TPS. But...

    TPS bench testing can reveal a bad TPS.

    But bench testing cannot prove a TPS is actually good. There are no bench tests that prove a TPS is good.

    Only running it on the engine, and not having...
  5. What aftermarket Ficht stator connector wire...

    What aftermarket Ficht stator connector wire colors did you end up with at each pin now that the engine is starting and running?
  6. How to check Ficht stator coil phasing (incorrect aftermarket connector wiring)

    Do the test described in this linked post
    http://greenhulk.net/forums/showthread.php?t=294026&p=3140297&viewfull=1#post3140297

    Your results should be very similar to what HiPeRcO has posted...
  7. View Post

    Well, I donít know what a Ducati dry clutch sounds like, so :smt102

    I recommend the Deka ETX16 factory sealed AGM battery. Strong cranking power, no liquid acid to mess with. Cannot leak.

    Donít...
  8. Did you check all the coils for grounding?

    Did you check all the coils for grounding?
  9. Try swapping the 8-5 pins, that may correct the...

    Try swapping the 8-5 pins, that may correct the out-of-phase AC.
    That should reduce the delta into the mV range, similar to the 9 & 10 result you posted.

    Then redo the tests.
    Keep the battery...
  10. Checking Ficht stator for correct 12-pin connector coil wire phasing

    You could try this method.
    I have not tried it myself (I do not have a Ficht engine here) but it should work :-k

    http://greenhulk.net/forums/attachment.php?attachmentid=477257&stc=1

    Link...
  11. A Ficht engine will not start normally if the...

    A Ficht engine will not start normally if the voltage powering the fuel injectors is weak. Priming your engine with gasoline is allowing it to start, which basically confirms that the injectors are...
  12. Millivolts? Should be above 20 volts while...

    Millivolts?

    Should be above 20 volts while cranking. This is on the white/red wire, which is common to all three injectors.

    Sounds like the EMM needs repair.

    If you want to confirm before...
  13. What is the injector voltage while cranking, with...

    What is the injector voltage while cranking, with all injectors plugged in?
Results 1 to 13 of 14