Search

Type: Posts; User: turboman412

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    7
    Views
    97

    I paid 110 shipped a few years back for a very...

    I paid 110 shipped a few years back for a very nice pump. Any from a tripple engine 148mm will fit.
  2. Replies
    7
    Views
    97

    Pumps trashed time to find a used replacement

    Pumps trashed time to find a used replacement
  3. Replies
    20
    Views
    325

    Around 120

    Around 120
  4. Yes the pump could of been your issue.

    Yes the pump could of been your issue.
  5. Wait till you see the pump im going to send to...

    Wait till you see the pump im going to send to you then decide if you wanna spend the money on a new one.
  6. Replies
    20
    Views
    325

    2002 was when the changes started with...

    2002 was when the changes started with electronics, 2003 the hull structure was redesigned. 1999 to 2001 is no difference other then ignition
  7. Theres a box under steering support, check to see...

    Theres a box under steering support, check to see if clicking is coming from there. Very common to go bad and cause a no start. I have a few of those box for sale if any interested
  8. Yes you can start engine with jetpump removed....

    Yes you can start engine with jetpump removed. Just make sure you pull drive shaft back so its not hitting the coupler
  9. They should hold tight, they look worn. But i...

    They should hold tight, they look worn. But i dont think this is your issue.

    I have a TON of reeds and cages if you want me to look through them
  10. Yes same set of carbs

    Yes same set of carbs
  11. I have one, drop me a pm if interested

    I have one, drop me a pm if interested
  12. Replies
    23
    Views
    460

    ;)

    ;)
  13. Replies
    23
    Views
    460

    was this a good thing or a bad thing?

    was this a good thing or a bad thing?
  14. Thread: ULTRA 150

    by turboman412
    Replies
    3
    Views
    118

    I have plenty replacement coils, drop me a pm if...

    I have plenty replacement coils, drop me a pm if interested
  15. I soak the carbs in seafoam then blow out then...

    I soak the carbs in seafoam then blow out then use carb cleaner and blow out again. Put back together and paint. Reinstall on ski
  16. I might have another rack i can take apart and...

    I might have another rack i can take apart and have a look
  17. There are no jets under those seats

    There are no jets under those seats
  18. Its deff dirty could be the issue. Clean up till...

    Its deff dirty could be the issue. Clean up till its perfect.
  19. Soak with wd40 and pull up with needle nose...

    Soak with wd40 and pull up with needle nose pliers. Be careful to not damage seat since its brass. All depends on how nasty the oring determines how much effort to get them out.

    He will recommend...
  20. See the screw? Remove it and remove the seat for...

    See the screw? Remove it and remove the seat for the needle theres an o-ring and a screen in there. Could be your issue.

    If the bearings are noisy or rough they are shot. All should be smooth and...
  21. I have had a set of carbs where i had nothing but...

    I have had a set of carbs where i had nothing but starting issues running issue bogging. No matter how many times i took it apart and cleaned they were never right. Purchased a really nice set from...
  22. Then look into a used set.

    Then look into a used set.
  23. You will have to pull the glove box and the pick...

    You will have to pull the glove box and the pick ups are right there.

    I have never tested the pump, just a diaphragm in there. I have a few pumps off parts skis you can have just pay shipping
  24. Replies
    23
    Views
    460

    Its hydro locked from sitting, oil pump will weep...

    Its hydro locked from sitting, oil pump will weep into case over time. Turn it over with plugs out make sure wires are grounded on head.

    Trust me this isnt really a bad thing, atleast you know the...
  25. Replies
    23
    Views
    460

    Sounds like the start drive is getting hung up....

    Sounds like the start drive is getting hung up. Can you turn it by hand?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4