Search

Type: Posts; User: Dodgeramvt

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    267

    MSX 140 part out

    Parting out a complete msx 140. Shipping would be from 02893. Tree fell on the hood and windshield, everything else is good. 450308450309
  2. Replies
    5
    Views
    325

    I pressure tested the tank and the leak is at the...

    I pressure tested the tank and the leak is at the gas cap. The rubber o ring is not sealing properly. So im going to replace it and should be good.
  3. Replies
    5
    Views
    325

    I have also switched to 93 octane only with an...

    I have also switched to 93 octane only with an ethanol treatment with each tank. Would that effect anything?
  4. Replies
    5
    Views
    325

    I put a tank and a half of fuel thru it the past...

    I put a tank and a half of fuel thru it the past two days. Even after sitting in the sun there was no pressure build up. It runs fine, no issues with it what so ever. I just noticed the sudden lack...
  5. Replies
    5
    Views
    325

    03 msx 140 fuel tank pressure

    Random question, on my msx 140 when i unscrewed the gas cap there would always be some pressurized air that would blow out when i took the cap off. The past two days it hasnít done it, am i going...
  6. Replies
    1
    Views
    161

    Iso-03 msx 140 aqua step

    Anyone have an aqua step laying around they would like to sell for an 03 msx 140?
  7. Replies
    2
    Views
    448

    Im all set, thanks everyone!

    Im all set, thanks everyone!
  8. Replies
    2
    Views
    448

    Msx 140 steering arm

    Looking for part number 5631307 steering arm and 7556262 shims, 03 msx 140 438779
  9. Replies
    31
    Views
    1,643

    Zapped from cylinder #3 msx140 2003

    This was at about 80deg. I put it in the sun and the resistance did change so it seems ok. It didnt change when i tapped on it. I also put a dab of rtv on the top and trimmed the cover a little so it...
  10. Replies
    31
    Views
    1,643

    438730 This is what its testing at.

    438730

    This is what its testing at.
  11. Replies
    31
    Views
    1,643

    I have seen a few of them for sale, ill see how...

    I have seen a few of them for sale, ill see how it acts on the meter and go from there. I had it off when i cleaned everything up but didnít test it.
  12. Replies
    31
    Views
    1,643

    I have seen a few of them for sale, ill see how...

    I have seen a few of them for sale, ill see how it acts on the meter and go from there. I had it off when i cleaned everything up but didnít test it.
  13. Replies
    31
    Views
    1,643

    Very good, i will check it. No check engine light...

    Very good, i will check it. No check engine light has flashed. It will start and idle, run fine until it warms up then it just idles weird (usually down to 800-450 rpm and dies.) it will restart and...
  14. Replies
    31
    Views
    1,643

    438604 Would this damage to the air sensor...

    438604

    Would this damage to the air sensor cause a funky idle?
  15. Replies
    31
    Views
    1,643

    View Post

    When you guys say ďcable slackĒ where would it be noticeable? Im trying to adjust the throttle cable but not sure where the slack would be.
  16. Replies
    31
    Views
    1,643

    Ok thank you, i found it a little strange. Just...

    Ok thank you, i found it a little strange. Just wanted to make sure. Took it out yesterday and its still acting up on idle. Going to play with it this week and see if i can narrow it down.
  17. Replies
    31
    Views
    1,643

    I noticed today when i opened the fuel cap it was...

    I noticed today when i opened the fuel cap it was pressurized after sitting for a few days. isnít the check valve suppose to release the tank pressure?
  18. Replies
    31
    Views
    1,643

    As in take the spring out or did u try to post a...

    As in take the spring out or did u try to post a pic?
  19. Replies
    31
    Views
    1,643

    Good catch K447. I forgot about the TPS...

    Good catch K447. I forgot about the TPS spring.[/QUOTE]


    Iím confused as to the orientation of the spring, is there a picture of a properly installed tps that i could see?
  20. Replies
    31
    Views
    1,643

    Thanks guys, i will check that. Other than the...

    Thanks guys, i will check that. Other than the idle issue every now and then, It has been running fantastic, just working the fine tune kinks out. I was really surprised how strong it is on take off!
  21. Replies
    31
    Views
    1,643

    There is a small black finger tightening part of...

    There is a small black finger tightening part of the throttle cable near the bottom of the intake. I just tightened it a little and the idle increased. I will check the oil pump alignment. Not sure...
  22. Replies
    31
    Views
    1,643

    I bypassed the esm, went for a ride and it still...

    I bypassed the esm, went for a ride and it still acted up when i came back to the no wake zone. Hooked the esm back up, still no change. Was playing with it today and noticed that the throttle cable...
  23. Replies
    31
    Views
    1,643

    Compression good, fuel reg fixed

    Compression good, fuel reg fixed
  24. Replies
    31
    Views
    1,643

    Just got it and have been going thru it. 03 with...

    Just got it and have been going thru it. 03 with 43 hours. Tps was bad, changed that and has been fine since. Just a slight issue with idle after warm up. Tried to bypass the esm, still did it. Emm...
  25. Replies
    31
    Views
    1,643

    Zapped from cylinder #3 msx140 2003

    I have been having idle issues with my msx after it warms up. Once it warms up the idle will drop to 450rpm and stall. The no wake zone is a nightmare. Rest of the throttle is fine and strong. Plugs...
Results 1 to 25 of 33
Page 1 of 2 1 2