Search

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. A member off the forum was kind enough to PM me...

    A member off the forum was kind enough to PM me and walked me through a way they use, to check alignment without the tool. So I could check how well aligned it remains after moving the engine over...
  2. Yup. The second rings taper was visible with a...

    Yup. The second rings taper was visible with a magnifying glass, regardless of the markings pointed upwards as well..

    It ran 16.5 hours with the .0045 PTW clearances..
  3. Replies
    3
    Views
    119

    Broken Timing chain?

    Broken Timing chain?
  4. Replies
    12
    Views
    1,418

    Replace them with AWAB and then considered it...

    Replace them with AWAB and then considered it bullet proof.. http://www.awabllc.com/
  5. Its better than paying a fortune for a set of...

    Its better than paying a fortune for a set of new, old style Denso coils..
  6. Thread: Intake Setup

    by tiderider
    Replies
    13
    Views
    766

    Use an air filter housing with no cotton gauze or...

    Use an air filter housing with no cotton gauze or other material in it. Just the metal mesh works wonders, it runs on water and not a dirt road..
  7. $375, what a rip off..

    $375, what a rip off..
  8. Replies
    27
    Views
    2,341

    He hasn't said anything about experiencing any...

    He hasn't said anything about experiencing any cavitation. Those are small scuffs from the impeller edge, it won't make much difference if its replaced.
  9. Replies
    12
    Views
    1,801

    Because supertech gives you springs as well as...

    Because supertech gives you springs as well as the retainers for the same price as only the retainers from Riva.. Supertech all the way. I guess supertech is wiser in ensuring it all fits and works...
  10. Replies
    3
    Views
    215

    USA ROCKS!!

    USA ROCKS!!
  11. As usual. Thank you for your helpful advise!

    As usual. Thank you for your helpful advise!
  12. Replies
    4
    Views
    252

    Leave it stock and enjoy it for many years to...

    Leave it stock and enjoy it for many years to come instead of risking, reduced reliability and expensive repairs due to modifications. Get a stock 300 instead if you want more speed..
  13. Replies
    3
    Views
    241

    I would sell it and stick to bicycles... Like the...

    I would sell it and stick to bicycles... Like the non gas powered type.. Maybe an electric bike would be safe as well..
  14. Replies
    4
    Views
    429

    Or go with an ET137 and a tune for reliability....

    Or go with an ET137 and a tune for reliability. You may want to refresh the engine with a rebuild at this point..
  15. Replies
    1
    Views
    178

    Pressure test the intercooler.. Supercharger slip...

    Pressure test the intercooler.. Supercharger slip test? Spark plugs are new? Test the ignition coils.. Verify fuel pressure.
  16. Shell Rotella T6 5W40 synthetic is doing very...

    Shell Rotella T6 5W40 synthetic is doing very well on 4 PWC this year (SC and non SC engines). I put it in all 4 stroke rotax engines. I picked up a few large pails at a great price. Works out to $5...
  17. A little something I came across... The ...

    A little something I came across...

    The Toronto Sun reports that the obsession of Prime Minister Justin Trudeau to disarm Canada’s civilian population of certain legally-obtained weapons has...
  18. Add a catch can so your intercooler stays clean..

    Add a catch can so your intercooler stays clean..
  19. Replies
    1
    Views
    195

    Take it to a reputable mechanic..

    Take it to a reputable mechanic..
  20. Replies
    21
    Views
    677

    Probably damaged the thrust rings and block.

    Probably damaged the thrust rings and block.
  21. Replies
    4
    Views
    208

    I'd offer maximum $1500 It can cost up to 3K or...

    I'd offer maximum $1500 It can cost up to 3K or more, to rebuild each engine..
  22. Replies
    5
    Views
    339

    Socialism does suck.. Its okay until you run out...

    Socialism does suck.. Its okay until you run out of other people's money..

    I once installed a large K&N Filter on a boat but I removed the cotton gauze and left the stainless steel/metal mesh...
  23. Replies
    11
    Views
    701

    I would still suggest a simple "limiter removal"...

    I would still suggest a simple "limiter removal" for many years of reliability.. The limiter is only due to regulation and not reliability. It would remain as a faster, reliable stock ride. 8-)
  24. Once you dremel the bolt head off you can push...

    Once you dremel the bolt head off you can push out the supercharger and there will still be about 1/2" of bolt sticking out, which you can unscrew it with a vice grip or by putting 2 x nuts on it..
  25. I believe Westside Powersports rebuilds them or...

    I believe Westside Powersports rebuilds them or repairs them. https://www.westsidepowersports.com/
Results 1 to 25 of 43
Page 1 of 2 1 2