Search

What exactly are they talking about chop damaging Scers ? From the rpms going up suddenly ? Will a blow off valve help this problem ?

=D>

LMFAO !!

I ended up ordering another new PTO seal and this one was a tad shorter. When tightening the Oetiker clamp making sure seal is flush against the PTO cover and not over tightening the Oetiker clamp as...

@ what psi # of boost is considered high boost compared to low boost ? ?

I haven't had any problems with the Rhass mounts I put on my X2 about 5 years ago. :-k

Will this work with the red start button ?

Moved to 3/8 and still have the same problem.

I am guessing the motor will need to be moved forward even though the shaft play is @ 1/4" . Carbon ring/bellow are new parts. Rear seal/bellow are new & they are the correct part #'s according to...

http://greenhulk.net/forums/attachment.php?attachmentid=470021&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=470023&stc=1
I have a 1/4" play in my driveshaft with the Engine torqued...

I found these bad boys. They are pretty cool....

http://greenhulk.net/forums/attachment.php?attachmentid=470003&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=470004&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=470005&s...

Okay I found it.

http://greenhulk.net/forums/showthread.php?t=287404

Alright !!!! This is the info I have been looking for ! No where to be seen in my Factory Sea Doo Manual for 08 RXT. So 6mm is the magic # thanks guys.

I am wondering what the front to back play is on a 08 RXT. I do not see it anywhere in the Sea Doo shop manual or anything about front to back. I am hearing 3/8" play in the driveshaft is where you...

=D> Heck Ya !!!!!!!! :):)http://greenhulk.net/forums/attachment.php?attachmentid=468180&stc=1
http://greenhulk.net/forums/attachment.php?attachmentid=468181&stc=1

This is definitely wrong !!! Just because there were no problems yet does not make it right.

No response I see. I am looking also.

I'm guessing this didn't go down ? Sounds like a pretty good idea.

How hard are these pump shoes to get off ?? Trying to decide if I want to tackle it.

Nice !!! How did this jetting and cooling work out ?

Ya it sounds normal mine sounds different though because it is carbureted you can hear the injectors on yours opening and closing.

I had the same problem 0n my 2001 Polaris Virage TX. I replaced the wear ring with brand new OEM and new OEM impeller also all new WSM bearings and seals, Put it back together and it was worse than...

With a Canadoo GPS conversion on a 08 RXT can the the instrument cluster #'s be modified to go past 70 mph

Did you ever figure this out?