Search

Type: Posts; User: Gsmith88

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. How many hours? I think around 50? Hours a...

    How many hours? I think around 50? Hours a maintenance warning pops up
  2. Replies
    6
    Views
    428

    I haven’t ridden the previous hulls but my 2019...

    I haven’t ridden the previous hulls but my 2019 is a wet ride ..
  3. I added one washer to the rear bolts. Still has...

    I added one washer to the rear bolts. Still has bounce but a lot better. Need to still test with two washers
  4. Replies
    63
    Views
    5,390

    The best I ran was 75.x with my stage 1+. That...

    The best I ran was 75.x with my stage 1+. That was with oem plate though and the air temp was still around 60 degrees. 84-8500rpm. If I had the riva plate at the time I think it would be right...
  5. Replies
    63
    Views
    5,390

    82 mph. Tried one washer today , felt alright...

    82 mph. Tried one washer today , felt alright with trim in middle position but trimmed up one click it’s bouncing pretty bad still. Also think speed dropped a bit..
  6. Replies
    63
    Views
    5,390

    Update on the riva plate.. tested today in...

    Update on the riva plate..

    tested today in calm water, no chop. Definitely Has bounce to it.
  7. Replies
    63
    Views
    5,390

    thats how mine felt with the oem plate. Any...

    thats how mine felt with the oem plate. Any little current or side wind and the ski was all over the place. When I tested there was slight wind swept chop and it seemed to fix it on mine? Was wot...
  8. Replies
    63
    Views
    5,390

    I think you’re right ,with more speed it may go...

    I think you’re right ,with more speed it may go away. I was doing a little over 80 and didn’t notice any bounce at all
  9. Replies
    63
    Views
    5,390

    Picked up 4mph with the riva plate but it was 10...

    Picked up 4mph with the riva plate but it was 10 degrees cooler , didn’t test back to back with the oem plate. Definitely handles a lot better too
  10. Replies
    24
    Views
    2,153

    I still prefer my ultra in real choppy waters....

    I still prefer my ultra in real choppy waters. Depends where you’re riding
  11. Replies
    63
    Views
    5,390

    What was your speed before testing the plate ?

    What was your speed before testing the plate ?
  12. Replies
    63
    Views
    5,390

    Good info John. Guess the plate isn’t good for...

    Good info John. Guess the plate isn’t good for 5mph like riva claims
  13. Replies
    63
    Views
    5,390

    Any results yet ?

    Any results yet ?
  14. Replies
    14
    Views
    1,754

    Mine were also half an inch off the bottom of the...

    Mine were also half an inch off the bottom of the hull. For some reason I didn’t gain much rpm or speed when I cut them
  15. Replies
    12
    Views
    509

    no problem. It’s pretty much the tj mod without...

    no problem. It’s pretty much the tj mod without removing that sound suppression box that we no longer have on the 19
  16. Replies
    12
    Views
    509

    I cut the pipe that goes into the sound...

    I cut the pipe that goes into the sound suppression box shorter and cut the rubber fingers near the exit. Sounds deeper
  17. Replies
    24
    Views
    2,153

    Yeah somethings not right. I would check the...

    Yeah somethings not right. I would check the pitch on the impeller and check for boost leak. I know the hose that connects to the throttle body is a Common spot to leak
  18. Replies
    24
    Views
    2,153

    full riva stage 1+ excluding the ride plate so it...

    full riva stage 1+ excluding the ride plate so it has 13/18 and riva intake. RPMs were around 8600 with the out of box 13/18 so I added the lucky 13 cone
  19. Replies
    24
    Views
    2,153

    Riva stage 1+ , ribbon delete , stock plate ,...

    Riva stage 1+ , ribbon delete , stock plate , lucky 13 cone. 75mph 8400rpm
    waiting on riva plate and fizzle next
  20. Replies
    4
    Views
    395

    are you sure your rpms are accurate ? That’s a...

    are you sure your rpms are accurate ? That’s a pretty high top speed for those rpms. I was running 8450 @76mph on my 19 fx
  21. Replies
    13
    Views
    603

    Just tap the start button

    Just tap the start button
  22. My fuel alarm was going off last ride when I was...

    My fuel alarm was going off last ride when I was WOT, gauge showed about 15% when idling. Filled my tank yesterday and only took 10 gallons.
  23. Replies
    10
    Views
    452

    I used the same stuff on my truck. It lasted a...

    I used the same stuff on my truck. It lasted a few months. Was real happy with it considering how easy it is to apply
  24. There were reports of this same issue posted in...

    There were reports of this same issue posted in some Facebook groups. One guy even said it was fixed under warranty , so Yamaha has definitely heard about this issue before.
  25. Replies
    7
    Views
    445

    Was it a 2019 plate dean machined or an older...

    Was it a 2019 plate dean machined or an older style plate ?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4